Haier HDW101SST Manual de usuario

Dishwasher

HDW101SST

HDW101WHT

Instructions for Use

0120505589

Index

Safety information

Installation

Getting to know your dishwasher

How to fill the rinse aid and the detergent dispenser

Not suitable for the dishwasher

Arranging crockery, glasses, etc. in the dishwasher

Programme overview

Washing dishes

How to keep your dishwasher in shape

Care and maintenance

Fault finding

Technical data

Important information

Safety information

Site the dishwasher and connect it up in accordance with the installation instructions.

The dishwasher must not be connected to the electricity supply while installation is being carried out.

Ensure that the domestic wiring is properly earthed.

The mains electricity supply must conform to the details shown on the dishwasher nameplate.

Do not connect the dishwasher to the electricity supply via an extension cable.

After the appliance has been installed,the mains plug should still be easily accessible.

During installation, the power supply cord must not be excessively or dangerously bent or flattened.

During installation

If your family includes children

Keep detergents out of the reach of children, who must also be kept away from the dishwasher when

it is open.

Attention

The appliance is not instruct for use of young children of infirm persons without supervision.

Young children should be supervised to ensure that they do not play with the appliance.

The dishwasher must only be used by adults for the washing of household dishes and cooking utensils.

This appliance cannot be installed outdoor, not even if the area in which it is installed is covered by a

roof; it is also very dangerous to leave it exposed to the rain and elements.

Do not place any heavy objects or stand on the door when it is open. The appliance could tip forward.

The water inside the dishwasher is not suitable for drinking.

Do not use solvents of any kind inside your dishwasher. They could cause an explosion danger.

Open the door very carefully if the dishwasher is operating. There is a risk of water squirting out.

During normal use

Do not touch the heating element during or after a wash cycle.

Fundamental rules to follow when using the appliance:

- Never touch the dishwasher when barefoot or with wet hands or feet;

- We discourage the use of extension cords and multiple sockets;

- If the appliance is not operating properly or maintenance must be performed, disconnect the

appliance from the power supply.

At time of delivery

Check packaging and dishwasher immediately for signs of transport damage. If the appliance is

damaged, do not put it into use but contact your supplier or customer service without delay.

Please dispose of packaging materials properly.

When disposing of old appliances

Appliances which are no longer being used must be made inoperable by cutting the power supply

cord and removing the door lock.

Take the appliance to a designated waste disposal center.

Dangerous voltage

Warning

Children could get locked in the appliance (risk of suffocation)

or get stuck in other positions. Therefore: Remove the mains

plug, cut the mains wire and set aside. Damage the door lock so

that the door can no longer be closed.

If a fault occurs

If the appliance malfunctions, turn off water supply to the appliance and disconnect the plug from

the wall socket. Then, consult the section entitled, "Finding fault" .If you cannot solve the problem,

contact a service center.

To maintain the EFFICIENCY and SAFETY of this appliance,we recommend:

- call only the Service Centers authorized by the manufacturer.

- always use original Spare Parts.

Warning

If the supply cord is damaged, it must be replaced by the manufacturer or its service agent

or a similarly qualified person in order to avoid a hazard.

Installation

Levelling the appliance

Once the appliance is positioned, adjust the feet (screwing them in or out) to adjust the dishwasher,

making it level. In any case, the appliance should not be inclined more than 2˚. If the appliance is level, it

will help ensure proper performance.

Positioning the appliance

Positioning the appliance in the desired location. The back should rest against the wall behind it, and the

sides, along the adjacent cabinets or wall. The dishwasher is equipped with water supply and drain

hoses that can be positioned to the right or the left to facilitate proper installation.

Warning

The appliance is to be connected to the water mains using new hose-

sets and that old hose-sets should not be reused.

Cold water connection

Connect the water supply hose to a threaded 3/4” bsp connector,

making sure that it is fastened tightly in place (see fig.A).

If the water pipes are new or have not been used for an ex-

tended period of time, let the water run to make sure that the

water is clear and free of impurities. If this precaution is not taken,

there is a risk that the water inlet can get blocked and damage

the appliance.

fig.A

Drain hose connection

Insert the drain hose into a drain pipe with a minimum diameter of 4cm, or let it run into the sink, making

sure to avoid bending or crimping it. If necessary, fit a syphon trap (U-bend) with a connecting piece for

the drain hose (fig.B). The free end of the hose must be at a height between 40 and 100 cm and must not

be immersed in water.

fig.B1

Attention:

The connecting piece for syphon trap (U-bend) must be solidly

fastened to the wall to prevent the drain hose from moving and

allowing water to spill outside the drain.

Electrical Connection

After making sure that the voltage and frequency values for the current in the home correspond to those

on the rating plate (located on the stainless steel inner door of the appliance) and that the electrical

system is correct for the maximum voltage on the rating plate, insert the plug into an electrical socket

which is earthed properly (the earthing of the appliance is a safety requirement mandated by law).

If the electrical socket to which the appliance must be connected is not appropriate for the plug, replace

the whole cable, rather than using adaptors or the like as they could cause overheating and burns.

Caution:

The dishwasher plug must be accessible even when the appliance

is installed as a built-in unit so that maintenance can be done safely.

fig.B2

Getting to know your dishwasher

Close-up view (control panel)

Heat Indicator Light

Low Rinse Aid Indicator Light

Handle For Opening Door

Knob For Selecting Cycle

“DRY” Button

"3 IN 1" Button

"Eco" Button

"END" Light

ON-OFF Button

BDAC FG H IE

Models explanation

Model Colour

HDW101WHT

HDW101SST

White

Stainless Steel

Dishwasher interior

Upper Rack

Detergent and Rinse Aid Dispenser

Top Spray Arm

Silverware Basket

Third Sprayer

Bottom Spray Arm

Washing Filter

Lower Rack

When the low rinse aid indicator lights, you must load rinse aid.

Rinse aid

This product makes dishes sparkle and helps them to dry without spotting. The dispenser is located on

the inside panel of the door .

Loading the rinse aid

Regardless of the type of detergent dispenser installed on your

appliance, you must proceed as indicated below when loading the

rinse aid.

To open the dispenser, turn the " 1 " cap in an anti-clockwise direc-

tion and then pour in the rinse aid, making sure not to overfill. The

amount of rinse aid used for each cycle can be regulated by turning

the "2" dose adjustor, located beneath the "1" cap, with a screwdriver.

There are 6 different settings; the normal dosage setting is 2.

Important

Proper dosage of the rinse aid improves drying.

If drops of water remain on the dishes or spotting occurs, the dosage adjus-

tor should be turned to a higher setting.

If the dishes have white streaks, turn the dosage adjustor to a lower setting.

How to fill the rinse aid and the detergent dispenser

Detergent

Detergent specifically intended for use with dishwashers must be used.

The dispenser must be refilled before the start of each wash cycle

following the instructions provided in the "Programme overview". The

detergent dispenser is located on the inside panel of the door.

To open the " 3" cover on the dispenser, press the "4" button.

The detergent for the wash cycle should be poured into the " 5"

compartment.

The detergent for the pre-wash cycle should be poured into the

“6” compartment.

After the detergent has been placed in the dispenser, close the

cover and press down until it clicks in place.

Loading the detergent

Notice:

To facilitate closing the cover, remove any excess detergent on

the edges of the dispenser.

Not suitable for the dishwasher

What you should not put into the dishwasher

Cutlery and tableware manufactured in whole or part from wood.They become faded and unsightly in

appearance.Furthermore,the adhesives that are used are not suitable for the temperature that occur

inside the dishwasher.Delicate decorative glassware and vases,special antique or irreplaceable china.

The decorative patterns on such items will not be dishwasher-proof.

Plastic objects that are not resistant to hot water, copper and pewter utensils are also not suitable.

Decorative patterns printed or painted onto the surface of crockery, glasses, etc.,aluminium and silver

items tend to become discoloured or faded if washed in the diswasher. Some types of glass can become

opaque in appearance after they have been washed many times in a dishwasher. Highly absorbent

materials, such as sponges and towels,should never be placed in the dishwasher.

Our recommendation

In future, only purchase table or kitchenware that has been confirmed as being dishwasher-proof.

Important

Dishes or cutlery that have been soiled by tobacco ash, wax,

Iubricating grease or paint, should not be put in the dishwasher.

Possible causes

type of glass or manufacturing process

chemical composition of detergent

water temperature and duration of dishwasher programme.

Use glassware or porcelain dishes that have been marked ‘dishwasher-proof’ by the manufacture.

Use a mild detergent that is described as ‘kind to dishes’. If necessary, seek further information from

detergent manufacturers.

Select a programme with a low temperature and a short duration as possible.

To prevent damage, take glass and cutlery out of the dishwasher as soon as possible after the

programme has ended.

Suggested remedy

Damage to glassware and other dishes

Arranging crockery, glasses, etc. in the dishwasher

Before placing the dishes in the dishwasher, remove larger food

particles to prevent the filter from becoming clogged, which re-

sults in reduced performance.

If the pots and pans have baked-on food that is extremely hard

to remove, we recommend that they are soaked before washed.

This will eliminate the need for extra wash cycles.

Pull out the rack to load the dishwasher.

Load for 12 Standard Settings

(for AS/NZS 2007 tests)

How to use the lower rack

We recommend that you place the most difficult to clean items

on the bottom rack: pots, pans, lids, serving dishes and bowls,

as shown in the figure to the right.

It is preferable to place serving dishes and lids on the sides of the

racks in order to avoid blocking the rotation of the top spray arm.

Pots, serving bowls, etc. must always be placed face down.

(see fig.C)

Deep pots should be slanted to allow the water to flow out.

Silverware should be placed in the silverware basket with

the handles at the bottom; if the rack has side baskets, the

spoons should be located individually into the appropriate

slots. Especially long utensils should be placed in the hori-

zontal position at the front of the upper rack.(see fig.D)

The silverware basket can be doubled (see fig.D) so that

only one section may be used when the silverware load is

light. This also makes space for additional pots and pans

and it can also be placed in the upper rack.

Warning

Knives and other utensils with sharp points must be loaded in the

basket with their points down or placed in a horizontal position.

fig.C

fig.D

Otros manuales para HDW101SST

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Lavavajillas de Haier

Haier

Haier ESD100 Manual de usuario

Haier

Haier ESD210 Manual de usuario

Haier

Haier DW12-AFE4T Manual de usuario

Haier

Haier DW12-CBE6 IS Manual de usuario

Haier

Haier HDW6WH Manual de usuario

Haier

Haier DW9-AFM ME Manual de usuario

Haier

Haier DW12-CBE7 Manual de usuario

Haier

Haier DW9-TFE1 Series Manual de usuario

Haier

Haier DW12-BFE ME Manual de usuario

Haier

Haier DW12-BFES Manual de usuario

Haier

Haier DW12-TFE3 series Manual de usuario

Haier

Haier DW15-PFE2ME Manual de usuario

Haier

Haier HDBL865ATS Manual de usuario

Haier

Haier DW12-PFE2-U Manual de usuario

Haier

Haier DW12-TFE2WH Manual de usuario

Haier

Haier DW12-EBM 1S Manual de usuario

Haier

Haier DWL4035 Manual de usuario

Haier

Haier DW12-PFE1S Manual de usuario

Haier

Haier DW12-LFE SS Manual de usuario

Haier

Haier DW12-PFE2-U Manual de usuario

Haier

Haier DW9-CBE7 Manual de usuario

Haier

Haier DW-8888-24 Manual de usuario

Haier

Haier WQP4-3N Manual de usuario

Haier

Haier DW12-KFE ME Manual de usuario

Manuales populares de Lavavajillas de otras marcas

Electrolux

Electrolux ESI5211LOX Manual de usuario

KitchenAid

KitchenAid KUDB230B Manual de usuario

Brandt

Brandt BDJ424DB Manual de usuario

Asko

Asko DSD767UXXL.AU Manual de usuario

Beko

Beko DFN26210W Manual de usuario

NEFF

NEFF S153ITX00E Hoja de especificaciones

Midea

Midea SV 4.45 wi Manual de usuario

LG LDF7932 Manual de usuario

Gorenje

Gorenje GV63214 Manual de usuario

Hotpoint

Hotpoint HDA1100ZWH Manual de servicio

Blomberg

Blomberg LDFN2240W Manual de usuario

AEG

AEG FFB83836PM Manual de usuario

Cylinda

Cylinda DM3220RFD Manual de usuario

Atag

Atag DW8214MB Manual de usuario

GE GLD8000 Series Manual de usuario

Siemens

Siemens SN23HI02KE Hoja de especificaciones

Omega

Omega ODW717X Manual de usuario

BORETTI

BORETTI BVW-683 Manual de usuario