Häfele MiniLock Manual de usuario

Electronic cam lock

INSTALLATION MANUAL

www.hafele.com

•lockers •cabinets •boxes

Installation

Overview

1. miniLock

2. M16x1,5mm Cylinder nut

3. Stop Cam

4.Cam 22mm Axle

5. Cam 38mm Axle

6. M4x10mm Cam Screw

7-9. Mounting Screws

Assembly will

be made in

locked position

0 - 5 mm covers 8mm

10 -12 mm

covers

16mm

16 -18 mm

covers

24mm

Cover thickness Screw size

Note: 5 mm measurement is for 18 mm..!

Half gap should be 1.50 mm

1,50

0.16”(4mm)

2.44”(62mm)

0.63”(16mm)

miniLock Outline

Cylinder Hole

Mounting

Template Upper Mounting

Screw Hole

Mounting on Left & Right Door

RIGHT LEFT

Hinges on

outside of

door are on

the Right

Hinges on

outside of

door are on

the Left

Peg on stop cam

is on the right side

Peg on stop cam

is on the left side

Back View

Knob, rotates to the

right to open lock

Back View

Knob, rotates to the

left to open lock

View of the lock

in closed position

22 mm Axle cam 38 mm Axle cam

RECESSED COVER ASSEMBLY MEASUREMENTS

JOINT ERECT LOCK ASSEMBLY MEASUREMENTS

OVERLAPPING / EXTERNAL COVER

ASSEMBLY MEASUREMENTS

Right cover on the body

Locker body

22 mm cam

27 mm

42 mm

62 mm

3 mm

4 mm

Hole

16 mm

Hole

Replacing existing lock:

1. Place mounting template centered on existing hole and mark

upper mounting screw hole.

2. Drill mounting screw hole.

3. Install lock using adaptor if necessary.

4. Thread nut on cylinder.

5. Install mounting screw

6. Tighten both nut and mounting screw.

7. Test operation of lock

New Install:

1. Place mounting template on door and mark upper mounting

screw hole and lower cylinder hole

2. Drill mounting screw hole and cylinder holes.

3. Continue steps 4-7 above

Note: Before drilling holes, make sure miniLock is positioned

with proper clearance for cam to work.

NOTE: Read instructions, set combination

and test lock BEFORE installing!

Max

(Nm)

1. Pull the transparent “Remove to Start” tag coming out of bat-

tery cap at thebackof thelock and activate thelock.

2. Read theuser manual and apply password change and

opening/closing operations severaltimes before themounting

of the lock.

3. Before mounting of the lock, switch lockhandle to closing

position.

4. Make sure that there is no friction in the cabinet lids.If there is

a frictionin the cabinet lids,make the hinge adjustments and

make the cabinet lid operable.

5. Do not forget to place Stop Camdepending on the condition

of the right or left lid of your cabinet.

6. Do not over-tighten nuts or screws. The maximum torqueon

the cylinder screw is 2Nm.

7. Ensure that there is no friction between strike plate and the

cam.

8. Finally check the mounting screws, tighten theloose screws.

9. When placing the existing locks into place, if the cylinder hole

is big, use theadapter and do not over tighten the cylinder

nut. (max. 2Nm).

10.Check the cabinet lid hingeadjustment at least once a year.

Tighten loose screws.

WARNINGS FOR MOUNTING:

86,5

24 28

75,45 gr (*)

* Assembly set is not.

Otros manuales para miniLock

Tabla de contenidos

Otros manuales de Cerrar de Häfele

Häfele

Häfele EFL 30 Manual de usuario

Häfele

Häfele miniLock II Manual de usuario

Häfele

Häfele 836.28.380 Manual técnico

Häfele

Häfele DT 210 R2 Manual de usuario

Häfele

Häfele LockerLock LL 200 Manual de usuario

Häfele

Häfele LockerLock LL 200 Manual de usuario

Häfele

Häfele DT 600 Manual de usuario

Häfele

Häfele miniLock Manual de usuario

Häfele

Häfele Keya-Tronic 231.49.031 Instrucciones de funcionamiento

Häfele

Häfele HLS100 Manual de usuario

Häfele

Häfele DL7900 Manual de usuario

Manuales populares de Cerrar de otras marcas

Magic

Magic 105 Manual de usuario

Gantner

Gantner GAT NET.Lock 7020 System Guía rápida

Wittkopp

Wittkopp Insys 7202 Manual de usuario

Dorma

Dorma Studio Classic Manual de usuario

Securam

Securam ECSL-601 Manual de usuario

Sudhaus

Sudhaus 3003 Manual de usuario

Safety 1st

Safety 1st 48517 Manual de usuario

Pado

Pado FDS-10 Manual de usuario

Esco

Esco systeQ Series Manual de usuario

COMPX

COMPX National D8951 Manual de usuario

secureo

secureo Key Box Manual de usuario

Stock Loks

Stock Loks C8713 Manual de usuario

COMPX

COMPX 1T-058 Manual del propietario

Auslock

Auslock T11 Manual de usuario

ELCOM

ELCOM 7205 Manual de usuario

Stealth SAFES

Stealth SAFES ShadowVault Manual de usuario

Knox

Knox KeySecure 5 Manual de usuario

Kwikset

Kwikset 48334/01 Manual de usuario