GOREK GT-VB800 Manual de instrucciones
INSTRUCTION MANUAL
Vacuum Blender GT-VB800
Vaccum Blender GT-VB800
GOREK TECHNOLOGIES
101, J.B. Shopping Center-1, Matawadi, L H Road, Surat, Gujarat
Contact: +91-9016891389 | +91-9327460898
IMPORTANT SAFEGUARDS (INTRODUCTION)
When using electrical appliances, basic safety precautions should always be followed
including the followings:
Read all instructions.
● Read these instructions carefully and retain for future reference.
● Remove all packaging and any labels.
●Take care the blades are very sharp.
●Do not use the vacuum blender more than 3 minutes.
Safety
● The blades are very sharp, handle with care. Always hold the plastic parts rather than the cutting
edge when handling and cleaning.
●Keep hands and utensils away from the blade while blending to reduce the risk of severe injury
to persons or damage to the vacuum blender.
● This appliance will be damaged and may cause injury if the interlock mechanism is
subjected to excessive force.
● Before removing the blending jar: switch off first, wait until the blades have completely stopped.
●Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions,
or is dropped or damaged in any manner. Return appliance to the nearest authorized service
facility for examination, repair or electrical or mechanical adjustment.
● Never let the power unit, cord or plug get wet.
● Don’t let excess cord hang over the edge of a table or worktop or touch hot surfaces.
● Never leave the appliance on unattended.
● Misuse of your vacuum blender can result in injury.
● Never use an unauthorized attachment.
● This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience andknowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.
Vaccum Blender GT-VB800
GOREK TECHNOLOGIES
101, J.B. Shopping Center-1, Matawadi, L H Road, Surat, Gujarat
Contact: +91-9016891389 | +91-9327460898
● Children should be supervised to ensure that they do not play with the appliance.
●Do not use outdoor, household use only. Supplier will not accept any liability if the appliance is
subject to improper use, or failure to comply with these instructions.
●To protect against risk of electrical shock do not put power unit in water or other liquid. Close
supervision is necessary when any appliance is used by or near children.
●Unplug from outlet when not in use, before putting on or taking off parts, and before cleaning.
●Avoid contacting moving parts.
●The use of attachments not recommended or sold by the manufacturer may cause fire, electric
shock or injury, or discs on base without first putting bowl properly in place.
●Do not attempt to defeat the interlock mechanism.
●Blade is sharp. Handle carefully.
●Be certain machine is installed properly before operating appliance.
●Do not modify the plug in any way.
●Please do not move the unit during operation.
●Please do not use the unit at a place that is unstable.
●Please do not put ingredients of a temperature higher than 40°C into the jars. Doing so may
cause injury.
●Never perform no-load running. Please do not use the unit with ingredients less than 250ml or
exceed Max line.
Before plugging in
● Make sure your electricity supply is the same as the rating label one that shown on the underside
of the appliances.
Vaccum Blender GT-VB800
GOREK TECHNOLOGIES
101, J.B. Shopping Center-1, Matawadi, L H Road, Surat, Gujarat
Contact: +91-9016891389 | +91-9327460898
SAVE THESE INSTRUCTIONS:
PARTS DESCRIPTION
Blending jar lid
Blending jar
Power button
AUTO button
Speed knob
Vacuum valve
Upper cover
Main body
VACUUM button
Speed indicator
Foot pad
Vaccum Blender GT-VB800
GOREK TECHNOLOGIES
101, J.B. Shopping Center-1, Matawadi, L H Road, Surat, Gujarat
Contact: +91-9016891389 | +91-9327460898
BLENDING JAR SET VACUUM STORAGE JAR SET
Vacuum valve
Blending jar lid
Blending jar lid pad
Lid filter
.
Blending jar seal
Blending jar
Blade base seal
Blade set
Vacuum valve
Storage jar lid
Lid filter
Storage jar seal
Vacuum
storage jar
Vaccum Blender GT-VB800
GOREK TECHNOLOGIES
101, J.B. Shopping Center-1, Matawadi, L H Road, Surat, Gujarat
Contact: +91-9016891389 | +91-9327460898
TO ASSEMBLE YOUR VACUUM BLENDER
Assemble Blending Jar:
(1) Assemble lid Install Vacuum valve & Blending jar lid pad to Blending jar lid first.
Then install Blending jar seal to Blending jar lid.
Then install Lid filter by rotate clockwise
.
Press Blending jar lid down to Blending jar by aligning lid tip with jar spout
.
Vaccum Blender GT-VB800
GOREK TECHNOLOGIES
101, J.B. Shopping Center-1, Matawadi, L H Road, Surat, Gujarat
Contact: +91-9016891389 | +91-9327460898
(2)Assemble blade set
Rotate Blade set anti-clockwise and install it to Blending jar
Assemble Vacuum Storage Jar:
Install Vacuum valve & Storage jar seal to Vacuum storage jar
Then install Lid filter by rotate clockwise
Press Storage jar lid down to Vacuum storage jar
Vaccum Blender GT-VB800
GOREK TECHNOLOGIES
101, J.B. Shopping Center-1, Matawadi, L H Road, Surat, Gujarat
Contact: +91-9016891389 | +91-9327460898
TO USE YOUR VACUUM BLENDER
Connect plug to power supply and all indicator lights flash for once, then press Power button, the
indicator light around Power button goes on, you can start to use now.
For vacuum & blending:
Install vacuum storage jar in place:
The vacuum blender has a separate vacuum function, programmed to vacuum the Blending jar
or Vacuum storage jar. Press VACUUM button and wait 45 seconds until the indicator light goes
out.
Vaccum Blender GT-VB800
GOREK TECHNOLOGIES
101, J.B. Shopping Center-1, Matawadi, L H Road, Surat, Gujarat
Contact: +91-9016891389 | +91-9327460898
1. AUTO function
One click function is an auto feature the Vacuum Blender has.
First press Power button, then just one click the AUTO button, vacuum and blending will be
automatically operated with a program of 45 seconds’vacuum & 1 minute’s blending, there you
are ready to enjoy your smoothie.
NOTE: When AUTO program is running, adjust Speed knob manually will be useless;
Auto function can be stopped by clicking AUTO button again.
2. Manual function
When you want to blendor grind at your preferred timescale,you can operate the Vacuum Blender
in a manual way.
1) Press VACUUM button and wait 45 seconds until the indicator light goes out.
2) Rotate the Speed knob anticlockwise and release soon to proceed with PULSE motion.
3) Dial the Speed knob clockwise to adjust speed.
NOTE: When machine is running at a selected speed, press AUTO button will be useless.
The machine will stop working automatically after 2 minutes 30 seconds to ensure user’s safety,
please re-select speed to use continuously. But in any condition, do not run it over 3 minutes
continuously, and please cool it for 30 minutes.
DISASSEMBLE YOUR VACUUM BLENDER
Always release vacuum completely first before opening Upper cover, blending jar lid and
Storage jar lid, otherwise you can’t open them.
Vaccum Blender GT-VB800
GOREK TECHNOLOGIES
101, J.B. Shopping Center-1, Matawadi, L H Road, Surat, Gujarat
Contact: +91-9016891389 | +91-9327460898
Disassemble vacuum storage jar:
(1) If vacuum function has been used, release vacuum to open Upper cover.
(2) Take Vacuum storage jar out to store in refrigerator or take away. When you want to open
lid, if vacuum function has been used, release vacuum first.
Disassemble Blending jar:
(1) If vacuum function has been used, release vacuum to open Upper cover.
(2) Rotate Blending jar anti-clockwise to take it out
Tabla de contenidos
