Global Payments FLEX POS Semi-Integrated Move/5000 Manual de usuario
Global Payments FLEX POS –
Semi-Integrated Move/5000
Quick start guide
Welcome to your Global Payments FLEX POS – Semi-Integrated solution. This quick start guide is designed to
help you quickly get started with your semi-integrated payment solution. If this is your first setup, please contact
your Point-of-Sale (POS) or Electronic-Cash-Register (ECR) system provider to start.
Terminal ON/OFF
When the terminal is connected to the power supply, it will automatically
power up, initiate an application check and then enter the home screen.
To power off the device, remove the terminal from its base and any power
source, and hold the yellow [Correction] key and the [.,#*] key
simultaneously for one second.
Power connection
Ensure your power supply comes from a surge protector connected to
your electrical outlet.
Plug the power supply into the power port onto the communication base.
Place your Move/5000 device on the communication base. Follow the
directory below to connect to the base: Configuration →Term config →
Mobility →Association →Base →New Base
Network connection
Plug the end of the ethernet connection cable into the device’s base
ethernet port.
For 4G devices, the connectivity comes from the SIM card and it will
automatically connect to the network when booted.
NOTE: Both ethernet and 4G connection types required your computer’s
IP for settlement/closing.
Administrator password
Contact the Global Payments Customer Care Centre at 1-800-263-2970
to set up your personalized admin password.
You will need to change your password once the terminal has been
installed.
© 2022 Global Payments Inc. All Rights Reserved.
1
Global Payments FLEX POS – Semi-Integrated Move/5000
Quick start guide
Change password
1. To get to the Menu, click the yellow key then [0]
2. Select the Configuration menu. When prompted, enter the
password.
3. Select Modify pwd in the Security Menu
4. Enter your new password containing 5-7 numeric digits. Do not
reuse the previous password
5. Re-enter your new password to complete the password change
Connection type setup
1. To get to the Menu, click the yellow key then [0]
2. Select the Configuration menu and enter your assigned password
3. Select Term Config →POS Comm → Configuration
4. Depending on your setup, select IP or RS232 as your POS Comm
Type
5. When IP is selected, enter your computer IP address and the port
Firmware download/update
1. Confirm your Terminal ID (TID) before performing the download
2. To get to the Menu, click the yellow key then [0]
3. Select the Configuration menu. When prompted for the password
please enter your current password
4. Select Initialize followed by Download to update your device’s
firmware
Performing a transaction
Once the connection between your POS system and your device has
been set up, you will be able to perform any transactions initiated by the
POS system on your FLEX device.
Closing a batch
Please remember to close the batch on your terminal daily. To close a
batch, head to Administration →Close batch on your device.
Additional support
Should you require any assistance with your FLEX POS solution, please
contact the Global Payments Customer Care Centre at 1-800-263-2970
2
Otros manuales de Terminal táctil de Global Payments
Global Payments
Global Payments Wireless - Move/5000 Manual de usuario
Global Payments
Global Payments Desk/5000 Manual de usuario
Global Payments
Global Payments Desk/5000 Manual de usuario
Global Payments
Global Payments P2PE Manual de usuario
Global Payments
Global Payments Genius Smart P2PE Manual de usuario
Global Payments
Global Payments Desjardins T650C Manual de usuario
Global Payments
Global Payments Countertop M400 Manual de usuario
Global Payments
Global Payments Wireless e285 Manual de usuario
Global Payments
Global Payments Countertop P400 Manual de usuario
Global Payments
Global Payments Lane/3000 Manual de usuario
