GFA 10005230 10012 Manual de usuario

Installation Instructions

ELEKTROMAT

SI 260.12 FU-80,00

Model: 10005230 10012

-en-

Status: 02.07.2023

GfA ELEKTROMATEN GmbH & Co. KG

Wiesenstraße 81

D-40549 Düsseldorf

www.gfa-elektromaten.de

[email protected]

Table of contents

1General safety information .............................................................................................. 4

2Technical data ................................................................................................................ 6

3Integrated safety brake ................................................................................................... 7

4Mechanical installation .................................................................................................... 8

5Electrical installation ..................................................................................................... 12

6Limit switch adjustment ................................................................................................. 13

7Motor connection .......................................................................................................... 14

8Limit switch connection ................................................................................................. 14

9Emergency manual operation (hand chain operator) ..................................................... 15

10Completion of commissioning / testing .......................................................................... 17

11Disposal ........................................................................................................................ 20

12Declaration of incorporation / Declaration of conformity ................................................. 21

13UKCA: Declaration of incorporation / Declaration of conformity ..................................... 22



Symbols

Warning - Potential injury or danger to life!

Warning - Danger to life from electric current!

Note - Important information!

▶ Requirement - Required action!

Schematic representations are based on product examples. Deviations from delivered

products are possible.

1General safety information

Specified use

The drive unit is intended for vertically moving doors that need to be secured against

dropping. A safety brake is integrated into the gearbox. The drive unit must be mounted

directly on the shaft of the door.

The drive unit must be protected against moisture and aggressive environmental

conditions (such as corrosive substances). The drive units are only suitable for indoor use.

Appropriate protective measures must be taken for outdoor installation. The drive unit is

not intended for hazardous areas. The values specified in the technical data of the drive

unit must not be exceeded. The safe operation can only be ensured if used as specified.

Target audience of these installation instructions

These installation instructions are geared towards qualified persons trained in the handling

of door systems. Expert knowledge, relevant skills and practical experience are what set

apart qualified persons. They are capable of safely carrying out the tasks involving

installation, maintenance and modernisation according to the instructions.

Safe operation

The safe operation of the product can only be ensured if it is used as specified. Follow the

installation instructions. Observe all specifications, especially warnings, when installing the

product in the overall system. GfA is not liable for damage resulting from non-observance

of the installation instructions. The resulting overall system must be reassessed for its

safety in accordance with applicable standards and directives (e.g. CE marking). These

installation instructions refer only to a part of the overall system and are not sufficient as

the sole instructions for the overall system. The installer of the system must prepare the

instructions for the overall system. We recommend entering the danger area of the system

only when the drive unit is at a standstill.

Warning - Failure to follow these installation instructions may result in severe injury or death.

Please read these instructions before using the product.

Keep these instructions handy.

Include these instructions when passing on the product to third parties.

Warning - Danger from improper use of the product!

Do not let children operate the product unsupervised or use as a toy.

Warning - Danger to life from incorrect installation!

Work carried out improperly may result in death or severe injury from electrical

current or falling parts.

Allow only competent people to carry out the work.

Disconnect all cables from the power supply.

Observe valid regulations and standards.

Use suitable tools.

Warning! Danger to life from falling objects if the drive unit is subjected to

impermissible forces.

Inadmissible forces (examples: collision with a forklift, dropping the drive unit, tearing

or pulling on the motor) lead to damage to the drive unit. There is a risk of severe

injury or death from falling objects.

Prevent impermissible forces from acting on the drive unit,

Check the drive unit for damage if impermissible forces have acted on it. Look

even for minor damage. Lock the door during the inspection.

Contact the service department if you have difficulty assessing the damage.

2Technical data

Designation Unit

Output speed 12 rpm

Output torque 2600 (2600) 1) Nm

Output / hollow shaft 80,00 mm

Series SG 186F -

Limit switch range

(maximum revolutions of the output / hollow shaft)

10 -

Supply voltage 3~ 380-460 V

Operating current 12,40 A

Operating frequency 50/60 Hz

Power factor cos φ 0,76 -

Safety circuit 24 V

Degree of protection IP 65 -

Temperature range -10 / +40 (+60) 2) °C

Operating sound pressure level < 70 dB(A)

Output speed OPEN 2-12 min-1

Output speed CLOSE > 2,5 m 2-5 min-1

Output speed CLOSE ≤ 2,5 m 2-5 min-1

Cycles per hour 11 (6,0)1) h-1

Max. holding torque 2600 Nm

Locking torque 8255 Nm

Safety brake (testing centre / approval number) 11-003301-PR -

Braking torque 100 Nm

Braking voltage 178 V DC

Rectifier type FU -

Manual force emergency manual operation 182 N

1) Specification in ( ) according to EN 60335-2-103.

2) When using a temperature range of +40°...+60°C use half of maximum cycles per hour.

3Integrated safety brake

A safety brake is integrated into the gearbox of this ELEKTROMATEN. The safety brake

protects against the door dropping due to breakage or wear of the gear teeth. The safety

brake works regardless of the mounting position, speed and rotating direction. It is

maintenance-free. The specification of the locking torque and the approval number of the

safety brake are available in the technical data of these instructions.

Warning - Danger of the door dropping!

If you need to apply more than the permissible force of 390N (according to DIN EN

12604/DIN EN 12453) to move the door by emergency manual operation, this

indicates a stalling on the drive unit or door. Releasing the stalling may cause the

door to drop.

Adopt a secure position.

For drive units with brake, the emergency manual operation must be carried out

against the closed brake.

4Mechanical installation

Requirements

The permissible loads on walls, mountings, connection and transmission elements must not

be exceeded even for maximum holding or locking torque (▶ observe technical data).

Connection elements

Use self-locking connection

elements with a minimum

strength of 800 N/mm2 (8.8).

Use a screw that precisely

fits the hole.

Use adequately

dimensioned washers for

elongated holes.

BAGAB00002_Z002 BAGAB 00003_Z002

3 : 1

Permissible mounting positions

BAGAC07001_Z003

Mounting

2 elongated holes are provided for mounting.

▶ Installation is only permitted with an additional torque mount (Ⓑ).

Warning – Injury or danger to life possible!

Check installation aid (Ⓐ) before each use and replace it in case of damage.

BAGAD07001_Z003

Installation

The following descriptions refer to a door which is not further defined. The door

manufacturer's specifications must also be observed.

Warning – Injury or danger to life possible!

Use a lifting device with sufficient load-carrying capacity for installation tasks.

Completely grease the door shaft.

BAGAE03003_Z002

Mount the key.

BAGAE03004_Z001

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Accionamiento de CC de GFA

GFA

GFA ELEKTROMAT SI 75.24-55,00 Manual de usuario

GFA

GFA 10004146 10011 Manual de usuario

GFA

GFA ELEKTROMAT SIK 17.10 WS-30,00 Manual de usuario

GFA

GFA ELEKTROMAT FS 50.20-40,00 Manual de usuario

GFA

GFA ELEKTROMAT SI 260.9-80,00 Manual de usuario

GFA

GFA ELEKTROMAT SI 360.12 FU-80,00 Manual de usuario

GFA

GFA ELEKTROMAT SI 60.55 FU-55,00 Manual de usuario

GFA

GFA ELEKTROMAT SI 25.15-30,00 Manual de usuario

GFA

GFA ELEKTROMAT SI 17.30 FU-30,00 Manual de usuario

GFA

GFA 10003166 10011 Manual de usuario

GFA

GFA ELEKTROMAT SI 35.15-40,00 GA35/15GD Manual de usuario

GFA

GFA ELEKTROMAT SI 45.7 WS-40,00 Manual de usuario

GFA

GFA ELEKTROMAT SI 17.15-30,00 Manual de usuario

GFA

GFA ELEKTROMAT SG 186F Manual de usuario

GFA

GFA ELEKTROMAT SI 40.15-40,00 Ex Manual de usuario

GFA

GFA ELEKTROMAT SI 40.15-40,00 Manual de usuario

GFA

GFA ELEKTROMAT SI 75.20 FU-55,00 Manual de usuario

GFA

GFA ELEKTROMAT SI 5.250 FU-25,40 Manual de usuario

GFA

GFA ELEKTROMAT SI 75.15-55,00 Manual de usuario

GFA

GFA 10003917 10011 Manual de usuario

GFA

GFA ELEKTROMAT SI 35.30-40,00 Manual de usuario

GFA

GFA ELEKTROMAT SE 9.24 WS-25,40 Manual de usuario

GFA

GFA ELEKTROMAT SI Manual de usuario

GFA

GFA 10005484 00001 Manual de usuario

Manuales populares de Accionamiento de CC de otras marcas

Vincent Associates

Vincent Associates UNIBLITZ ED12DSS Manual de usuario

EKSMA OPTICS

EKSMA OPTICS DQ-100-4 Manual de lista de piezas

Chamberlain Garog

Chamberlain Garog D Series Manual de usuario

Parker

Parker PDS Series Manual de usuario

Festo

Festo DGC G Series Guía de configuración

Binks

Binks QS-5012-1-CE Manual de usuario

Danfoss

Danfoss VLT 2800 Series Hoja de especificaciones

ABB

ABB ACQ580-01 Series Manual de instalación

YASKAWA

YASKAWA CANopen SI-S3 Manual de usuario

GE D20A6 Manual de usuario

Unex

Unex MC-D-250-1000-050W-TW Manual de usuario

Geckodrive

Geckodrive G213V Manual de usuario

ABB

ABB RSYC-01 Manual de usuario

Rockwell Automation

Rockwell Automation PowerFlex 700S Manual del propietario

WEG

WEG DeviceNet CFW500 Manual de usuario

Siemens

Siemens SINAMICS G Hoja de datos

Siemens

Siemens SINAMICS SM150 6SL3815-7NP41-0AA1 Instrucciones de funcionamiento

SOMFY

SOMFY JR RU 30 Manual de usuario