2.5.5.1 Routine operation ………………………………………………………………………20
2.5.5.2 Warning for fire accident…………………………………………………………………20
2.5.6 other risk………………………………………………………………………………… 20
2.5.7 emergency accident solvement……………………………………………………………20
2.5.7.1 treament measures of personal injury …………………………………………………20
3.5.7.2 Fire treament measures …………………………………………………………………20
Chapter 3 Machine Installation And Debugging…………………………………………………21
3.1 Machine Installation………………………………………………………………………21
3.1.1 Steps of unpacking…………………………………………………………………………23
3.1.2 Unpacking check …………………………………………………………………………24
3.1.3 Preparations for equipment installation……………………………………………………25
3.1.4 Steps of installation ………………………………………………………………………25
3.1.4.1 Laser tube installation …………………………………………………………………25
3.1.4. 2 Laser power supply installation…………………………………………………………27
3.1.4.3 Water cooling system installation………………………………………………………28
3.1.4.4 Air pump installation……………………………………………………………………29
3.1.4.5 Blower installation ……………………………………………………………………30
3.1.4.6 Equipment earthing ……………………………………………………………………30
3.1.4.7 Removal of fixation block ………………………………………………………………31
3 1.4.8 Cutting head installation…………………………………………………………………32
3.1.4.9 Software and machine drive installation.………………………………………………33
3.1.4.10 0ther auxiliary part installation…………………………………………………………33
3.2 Equipment debugging………………………………………………………………………34
3.2.1 Sequence of power-on and power-off.……………………………………………………34
3.2.2 Movement debugging……………………………………………………………………34
3.2.2.1 Motor shaft movement…………………………………………………………………34
3.2.2.2 Resolution setup…………………………………………………………………………35
3.2.2.3 Stroke,limit and reset……………………………………………………………………36
3.2.2.4 Straightness and perpendicularity ………………………………………………………37
3.2.3 Laser debugging …………………………………………………………………………37
3.2.3.1 Light emitting test ………………………………………………………………………37
3.2.3.2 Light route adjustment…………………………………………………………………39
3.2.4 Trial operation of processing ……………………………………………………………40
Chapter 4 System Maintenance…………………………………………………………………41
4.1 Mechanical maintenance……………………………………………………………………41
4.1.1Guide rail,linear shaft,slide block assembly (metal guide pulley),nylon guide pulley ……41
4.1.2 Synchronous belt. synchronous belt wheel ………………………………………………42
4.1.3Fasten screws and coupling ………………………………………………………………42
4.2 Electric maintenance ……………………………………………………………………42
4.2.1 Limit switch ………………………………………………………………………………42
4.2.2 Maintenance of each button and indicators ………………………………………………43
4.3 Light route maintenance ……………………………………………………………………43
4.4 Auxiliary parts maintenance ………………………………………………………………44
4.4.1 Water replacement and water tank cleaning ………………………………………………44
