Future Automation LSM-TU4 Suplemento

Page 1of 5 // email info@futureautomation.co.uk US tel +1(603) 742 9181 Europe tel +44 (0) 1438 833577

LSM-TU4 Family Application Notes

(from v7.5.0)

Contents Page

Features............................................................................................................... 1

Configuring programmable heights................................................................... 2

Controlling the Mechanism ................................................................................ 4

User operation.................................................................................................... 4

Programming Mode............................................................................................ 5

Page 2of 5 // email info@futureautomation.co.uk US tel +1(603) 742 9181 Europe tel +44 (0) 1438 833577

Features

Programmable maximum height

3 programmable intermediate heights

Home position (Lift out, telescope retracted)

Configuring programmable heights

1. Apply power.

2. Use the FA remote for the whole of the setup procedure

3. For all commands beginning with [STORE], press each button sequentially with

no more than 2 seconds between each press

4. In order to store programmable heights you must first enter programming mode.

In programming mode the lift then the telescope will move sequentially

a. Press [STORE] [STORE] [PRESET] to enter programming mode.

b. IMPORTANT- The mechanism will start to move out as soon as

[STORE] [STORE] [PRESET] has been keyed in.

c. Once in programming mode the lift will move fully out, followed by the

telescope. Once this has happened the [IN] and [OUT] commands will

only control the telescope.

5. Program the Maximum OUT position (max telescope extension)

a. Position the lift at the correct height using the IN and OUT commands

b. Press [STORE] [OUT] to store the current height as the maximum

extension.

Page 3of 5 // email info@futureautomation.co.uk US tel +1(603) 742 9181 Europe tel +44 (0) 1438 833577

c. Press [STORE] [STOP] [OUT] if you need to clear maximum extension.

IMPORTANT - The telescope shall revert to a maximum extension

located at the physical OUT switch.

d. The MAXIMUM HEIGHT can be verified in programming mode at any time

by pressing [OUT]

6. Program any required intermediate telescope extensions

a. There are 3 intermediate positions available, accessed by the [A], [B] and

[C] commands

b. Position the telescope at the required intermediate position.

c. Press [STORE] [A] to set the current position as position A.

d. Press [STORE] [B] to set the current position as position B.

e. Press [STORE] [C] to set the current position as position C.

f. The programmed position can be verified in programming mode at any

time by pressing [A], [B] or [C] respectively

7. IMPORTANT: To exit programming mode, press [STORE] [STOP] [PRESET].

The telescope and lift shall now return to running together when commanded.

Page 4of 5 // email info@futureautomation.co.uk US tel +1(603) 742 9181 Europe tel +44 (0) 1438 833577

Controlling the Mechanism

RS232 commands are all terminated with carriage return but no line feed. In Crestron this is

represented by \r

IR sequences involving multiple key-presses require each successive key to be pressed within 2

seconds

User operation

RS232

CC Pin (see note

below)

Action

Comments

fa_in

Pin 8

or Pin 5 short removed

Mechanism fully

OUT

fa_out

Pin 7

or Pin 5 shorted

Raise to full

extension

Raises to out switch if no

maximum extension is

configured

HOME

fa_home

Lift raised with the

telescope

retracted

fa_a

Lift raised with the

telescope at

intermediate

position A

fa_b

Lift raised with the

telescope at

intermediate

position B

fa_c

Lift raised with the

telescope at

intermediate

position C

STOP

fa_stop

Pin 6

Stop mechanism

Page 5of 5 // email info@futureautomation.co.uk US tel +1(603) 742 9181 Europe tel +44 (0) 1438 833577

Programming Mode

RS232

CC Pin (see note

below)

Action

Comments

STORE

PRESET

Enter programming

mode

STORE

STOP

PRESET

Exit programming

mode

STORE

OUT

Set maximum

extension

STORE

STOP

OUT

Clear maximum

extension

STORE

Set intermediate

extension A

STORE

Set intermediate

extension B

STORE

Set intermediate

extension C

Tabla de contenidos

Otros manuales de Rack y soporte de Future Automation

Future Automation

Future Automation EAD2 Manual de usuario

Future Automation

Future Automation TSLM-2 Manual de instrucciones

Future Automation

Future Automation CHT Series Manual de usuario

Future Automation

Future Automation EAD3 Manual de usuario

Future Automation

Future Automation Floor Mount Electric Manual de usuario

Future Automation

Future Automation PS Series Manual de usuario

Future Automation

Future Automation VWM Manual de usuario

Future Automation

Future Automation FM-BSQ Manual de usuario

Future Automation

Future Automation TSLM-3 Manual de instrucciones

Future Automation

Future Automation WB FSA3 Manual de instrucciones

Future Automation

Future Automation FSE90 Manual de usuario

Future Automation

Future Automation HQA2 Manual de usuario

Future Automation

Future Automation PIC SD Manual de usuario

Future Automation

Future Automation PSE90 Manual de usuario

Future Automation

Future Automation QA2-60 Manual de usuario

Future Automation

Future Automation CHS Series Manual de usuario

Future Automation

Future Automation SPS 800 Manual de usuario

Future Automation

Future Automation AL965 Manual de usuario

Manuales populares de Rack y soporte de otras marcas

Salamander

Salamander Acadia AC/W/L400/WH Manual de usuario

Fohhn

Fohhn VAT-09 Guía del usuario

ricoo

ricoo FS0522 Manual de usuario

AMSOIL

AMSOIL BMK-22 Guía rápida

Kargo Master

Kargo Master 48220 Manual de usuario

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Manual de usuario

ricoo

ricoo S1222 Manual de usuario

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Manual de usuario

VidaBox

VidaBox VB MNT FFS2 Manual de usuario

Welch Allyn

Welch Allyn 48960 Manual de usuario

Arkon

Arkon CM035-ST-2 Manual de usuario

PROEL

PROEL PLWIN60C Manual de usuario

Agilent Technologies

Agilent Technologies E2609B Manual de usuario

Mustang

Mustang MV-ARM4 Manual de usuario

Mounting Solutions

Mounting Solutions WRM-320 Manual de usuario

Pyle

Pyle PMKSPAD1 Manual de usuario

ShelterIt

ShelterIt 21208 Manual de usuario

SPL

SPL RackPack?4 1040 Manual de usuario