Furuno FA-30 Manual de usuario
www.furuno.co.jp
The paper used in this manual
is elemental chlorine free.
・FURUNO Authorized Distributor/Dealer
9-52 Ashihara-cho,
Nishinomiya, 662-8580, JAPAN
Telephone : +81-(0)798-65-2111
Fax
:
+81-(0)798-65-4200
A : MAY 2007
Printed in Japan
All rights reserved.
Pub. No. OME-44430-A
*00016497010**00016497010*
(DAMI ) FA-30
*
00016497010
*
*
00016497010
*
* 0 0 0 1 6 4 9 7 0 1 0 *
i
IMPORTANT NOTICES
• The descriptions in this manual are intended for readers with a solid knowledge of English.
• No part of this manual may be copied or reproduced without written permission.
• If this manual is lost or worn, contact your dealer about replacement.
• The contents of this manual and equipment specifications are subject to change without notice.
• The example screens (or illustrations) shown in this manual may not match the screens you
see on your display. The screen you see depends on your system configuration and equipment
settings.
• Store this manual in a convenient place for future reference.
• FURUNO will assume no responsibility for the damage caused by improper use or modification
of the equipment (including software) by an unauthorized agent or a third party.
• When it is time to discard this product it must be done according to local regulations for dis-
posal of industrial waste. For disposal in the USA, refer to the Electronics Industries Alliance
(http://www.eiae.org/).
ii
WARNING
Indicates a potentially hazardous situation which, if not avoided,
could result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation which, if not avoided,
can result in minor or moderate injury.
Warning, Caution
Mandatory Action
Prohibitive Action
SAFETY INSTRUCTIONS
The operator and installer must read the applicable safety instructions before attempting to
install or operate the equipment.
WARNING
WARNING
Do not open the equipment.
Only qualified personnel should work
inside the equipment.
Do not disassemble or modify the
equipment.
Fire, electrical shock or serious injury can
result.
Immediately turn off the power at the
power source if
water leaks into the equipment
something is dropped into the
equipment
the equipment is emitting smoke or
is on fire
the equipment is emitting strange
noises
Continued use of the equipment can
cause fire or electrical shock. Contact a
FURUNO dealer or agent for service.
Do not operate the equipment with wet
hands.
Electrical shock can result.
Use the proper fuse.
Use of the wrong fuse can cause fire
or electrical shock.
WARNING
Do not place liquid-filled containers on
the top of the equipment.
Fire or electrical shock can result if a
liquid spills into the equipment.
Make sure no rain or water splash
leaks into the equipment.
Fire or electrical shock can result if water
leaks into the equipment.
.
WARNING
To avoid electrical shock,
do not remove cover. No
user-serviceable parts
Name: Warning Label (1)
Type: 86-003-1011-1
Code No.: 100-236-231
WARNING
To avoid electrical shock,
do not remove cover.
No user-serviceable parts
inside.
Name: Warning Label (2)
Type: 86-129-1001-1
Code No.: 100-236-741
Warning labels are attached to the equipment.
Do not remove these labels. If a label is missing
or illegible, contact a FURUNO agent or dealer
about replacement.
Safety instructions for the operator
iii
CAUTION
Observe the following compass safe
distances to prevent interference to a
magnetic compass:
Turn off the power at the switchboard
before beginning the installation.
Fire or electrical shock can result if the
power is left on.
Do not install the equipment where it
may get wet from rain or water splash.
Water in the equipment can result in fire,
electrical shock or damage to the equipment.
Be sure that the power supply is
compatible with the voltage rating of the
equipment.
Connecting an incompatible power supply
can cause fire or damage the equipment.
The voltage rating appears on the inlet
of power.
Standard
compass Steering
compass
0.30 m 0.30 m
FA-30
WARNING
Safety instructions for the installer
iv
TABLE OF CONTENTS
FOREWORD .........................................................................................................v
SYSTEM CONFIGURATION................................................................................vi
1. INSTALLATION ................................................................................................1
1.1 Equipment Lists ..................................................................................................................1
1.2 AIS Receiver FA-30............................................................................................................2
1.3 Whip Antenna ..................................................................................................................... 3
1.4 Wiring .................................................................................................................................4
2. WEB SOFTWARE SETUP, DATA DISPLAYS .................................................6
2.1 AIS Receiver FA-30............................................................................................................ 6
2.2 COM Port Setup, Network Setup........................................................................................7
2.3 Own Vessel Data Display, Channel Selection..................................................................10
2.4 Sensor Status ...................................................................................................................12
3. MAINTENANCE, TROUBLESHOOTING........................................................13
3.1 Maintenance .....................................................................................................................13
3.2 Replacing the Fuse...........................................................................................................14
3.3 Troubleshooting................................................................................................................14
3.4 Diagnostics .......................................................................................................................15
VHF CHANNEL LIST ......................................................................................AP-1
SPECIFICATIONS...........................................................................................SP-1
OUTLINE DRAWINGS ...................................................................................... D-1
INTERCONNECTION DIAGRAM...................................................................... S-1
v
FOREWORD
A Word to the Owner of the FA-30
Congratulations on your choice of the FURUNO FA-30 AIS Receiver. We are confi-
dent you will see why the FURUNO name has become synonymous with quality and
reliability.
For over 50 years FURUNO Electric Company has enjoyed an enviable reputation for
quality marine electronics equipment. This dedication to excellence is furthered by our
extensive global network of agents and dealers.
This equipment is designed and constructed to meet the rigorous demands of the ma-
rine environment. However, no machine can perform its intended function unless op-
erated and maintained properly. Please carefully read and follow the recommended
procedures for operation and maintenance.
Thank you for considering and purchasing FURUNO equipment.
Features
The FA-30 is a compact and cost effective AIS Receiver that is designed specifically
for small commercial, leisure and fishing boats.
Connected to a VHF antenna it receives AIS data from AIS-equipped vessels, shore
stations and navigational aids (AIS-equipped buoys, etc.). Vessel movement is plotted
on a display connected to the LAN port. Data includes identity (name, call sign and
MMSI), position, speed, heading, etc. of AIS-equipped vessels within VHF range.
Program Version
Item Program No. Version No. Date
FA-30 AIS Receiver Main Program 0550227 01.02 May 2007
vi
SYSTEM CONFIGURATION
AIS RECEIVER
FA-30
HUB
WHIP ANTENNA
SENSOR
OR
12-24 VDC IF-1500AIS
OR
FR-8xx2 SERIES
GPS
SPEED LOG
GYROCOMPASS
SATELLITE COMPASS
NAVNET
RADAR
CHART PLOTTER
ECDIS
PILOT PLUG
PC
w/FAISPC MX
EXTERNAL
DISPLAY
: Standard supply
: Optional supply
: Local supply
NAVNET
EXTERNAL
DISPLAY
1
1. INSTALLATION
1.1 Equipment Lists
Standard supply
Optional supply
Name Type Code No. Qty Remarks
AIS Receiver FA-30 - 1
Installation Materials CP05-11101 001-014-160 1 set Tapping screw
(4x20, 4 pcs.)
AIS Viewer FP05-05910 000-010-938 1 set FAISPC-MX for PC
Spare Parts SP05-05701 001-014-150 1 set 2A fuse, 2 pcs.
Name Type Code No. Qty Remarks
VHF Antenna 150M-W2VN 000-113-498 1
LAN Cable P5E-4PTX-BL 000-164-634-10 1 L=2 m
P5E-4PTX-BL 000-164-637-10 L=10 m
2
1.2 AIS Receiver FA-30
Mounting considerations, mounting
The FA-30 can be mounted on a desktop, deck or on a bulkhead. When selecting a
mounting location, keep the following points in mind:
• The temperature and humidity should be moderate and stable.
• Locate the unit away from exhaust pipes and vents.
• The mounting location should be well ventilated.
• Mount the unit where shock and vibration are minimal.
• Keep the unit away from electromagnetic field-generating equipment such as
motors and generators.
• A magnetic compass will be affected if the FA-30 is placed too close to it. Observe
the compass safe distances noted in the safety instructions to prevent disturbance
to the magnetic compass.
• Fix the unit to the mounting location with 4x20 self-tapping screws (supplied).
MORE THAN
70
"A" DETAIL
MORE THAN
70
All dimensions
in millimeters.
MORE THAN 150
Otros manuales para FA-30
4
Tabla de contenidos
Otros manuales de Equipos marinos de Furuno
Furuno
Furuno GP-1650DF Manual de usuario
Furuno
Furuno MFD8 Manual
Furuno
Furuno FELCOM 82A Series Manual de usuario
Furuno
Furuno LH-3000 Manual de usuario
Furuno
Furuno FCV-581 Manual de usuario
Furuno
Furuno FCV-10 Manual de usuario
Furuno
Furuno DSC-6A Manual de usuario
Furuno
Furuno Navigational Echo Sounder FE851S Manual de usuario
Furuno
Furuno LS-6100 Manual de usuario
Furuno
Furuno FICE-100 Manual de usuario
Furuno
Furuno FMD-3200 Manual de usuario
Furuno
Furuno FICE-100 Manual de usuario
Furuno
Furuno BBDS1 Manual de usuario
Furuno
Furuno FI-501 Manual de usuario
Furuno
Furuno FCV-667 Manual de usuario
Furuno
Furuno FI70DSW Manual de usuario
Furuno
Furuno MD-550 Manual de usuario
Furuno
Furuno NAVNET 3D MFDBB Instrucciones de montaje
Furuno
Furuno FI-301 Manual de usuario
Furuno
Furuno FE-700 Manual de usuario
Manuales populares de Equipos marinos de otras marcas
Raymarine
Raymarine Maxiview ST80 Guía del usuario
GUIDANCE MARINE
GUIDANCE MARINE 20- Series Instrucciones de montaje
Raymarine
Raymarine ST60 Tridata Guía del usuario
olympia electronics
olympia electronics ΒS-531/1/MAR Manual de usuario
Sonic
Sonic 2024 Manual de usuario
Quicksilver
Quicksilver 88688A25 Manual