Frigidaire FFRE0833S1 Manual de usuario

READ BEFORE INSTALLING UNIT

MSII MSIII Window Mounting (5,000~8,000 BTU)

Installation Instructions

Before installing, the top rail must be assembled on the unit.

DO NOT USE ANY SCREWS OTHER THAN

THOSE SPECIFIED HERE.

NOTE:

SAVE CARTON and these INSTALLATION

INSTRUCTIONS for future reference. The carton is

the best way to store unit during winter, or when not

in use.

FOR SAFETY REASONS, THE TOP RAIL MUST BE

SECURELY FASTENED WITH ALL FOUR (4)

SCREWS.

A. Remove the air conditioner from the carton and place on a flat surface.

B. Remove top rail from the rear of the packaging material as shown in Fig. A

C. Align the hole in the top rail with those on the top of the unit as shown in Fig. B

D. Secure the top rail to the unit with the 3/8ƎScrews as shown in Fig. C

Top Rail Hardware Qty.

3/8ƎScrew

Top Rail

Some assembly is required. Please read these instructions

carefully.

Packaging

Fig. A

The unit is for window mounting only.

INSTALLATION WARNINGS AND CAUTION

Pay attention to danger and safety notices.

To avoid risk of personal injury, property damage, or product damage due to the weight of this device and sharp edges that may

be exposed:

Air conditioners covered in this manual pose an excessive weight hazard. Two or more people are needed to move and install

the unit. Wear protective gloves whenever lifting or carrying the unit.AVOID the sharp metal fins of front and rear coils. To

prevent injury or strain, use proper lifting and carrying techniques when moving unit.

Carefully inspect location where air conditioner will be installed. Be sure it will support the weight of the unit overan extended

period of time.

Handle air conditioner with care.

Make sure air conditioner does not fall during installation.

Carefully read the installation manual before beginning.

Follow each step as shown.

Observe all local, state, and national electrical codes and by qualified, licensed, authorized personnel only.

Drill (If pilot holes are needed)

Mounting Hardware Qty.

(or Wooden windows)

weather stripping

insulation panel

ruler

(10”X3/4”X1/12”) 5

window sash seal foam 1

12345678910 11 12

12345

16120300A04442

Top Rail

How to Install

NOTE: Top Rail and Side Panels at each side are offset to provide the proper pitch to the rear of (5/16”).

This is necessary for proper condensed water utilization and drainage. If you are not using the Side Panels

for any reason, this pitch to the rear must be maintained!

Place unit on floor, a bench or a table. There is a Left and Right side Filler Panels - be sure to use the proper

panel for each side. When installed, the flange for securing the panel in place to the window sill will be facing

into the room.

A. Hold the side Panel in one hand and gently pull back the center to free the open end. See FIG. 1.

B. Slide the free end “T” section of the panel directly into the cabinet as shown in FIG. 2. Slide the panel down. Be

sure to leave enough space to slip the top and bottom of the frame into the rails on the cabinet.

LEFT + RIGHT FILLER PANEL ASSEMBLY

FIG. 2FIG. 1

C. Once the panel has been installed on the side of the cabinet, make sure it sits securely inside the frame channel by

making slight adjustments. Slide the top and bottom ends of the frame into the top and bottom rails of the cabinet. See

FIG. 3.

D. Slide the panel all the way in and repeat on the other side. FIG. 3

Installation

Top Rail

Bottom Rail

“T” section

Your air conditioner is designed to install in standard double hung windows with opening widths of 23 to 36 inches

(584 mm to 914 mm) (FIG. 4A ，FIG. 4B)．

Lower sash must open sufficiently to allow a clear vertical opening of 14 inches (356 mm ). Side louvers and the rear of

the air conditioner must have clear air space to allow enough airflow through the condenser, for heat removal. The rear

of the unit must be outdoors, not inside a building or garage.

Fig. 4A

14Ǝmin

356 mm

Wooden Windows

Fig. 4B

14Ǝmin

356 mm

Vinyl-Clad Windows

INNER

WINDOW SILL INNER

WINDOW SILL

INTERIOR

WALL

If the air conditoner is blocked by Storm Window, add wood as

shown in FIG. 5, or remove storm window before air conditioner

is installed.

If Storm Window Frame must remain, be sure the drain holes or

slots are not caulked or painted shut. Accumulated Rain Water

or Condensation must be allowed to drain out.

Storm Window: FIG. 5

Board

thickness as

required, for

proper pitch to

rear, along

entire sill.

Fasten with

nails or screws.

Storm window

frame or other

obstruction.

SASH

1-1/2” min

(38 mm)

How to Install Installation

Extend the side panels out against the window frame (FIG. 7A for wooden windows), (FIG. 7B for Vinyl-Clad

windows).

FIG. 7A

window

frame

Place the frame lock between the frame extensions and the window sill as shown (FIG. 8A for wooden

windows), (FIG. 8B for Vinyl-Clad windows).

FIG. 8A

A: For wooden windows:

Drive 1/2Ǝ(12.7 mm) locking screws through the frame lock and into the window sash (FIG. 9B). NOTE:

Before driving the screws, use a drill to drill 5 holes through the holes in the frame lock and frame extensions

into the windows sash as shown ( FIG. 9B).

B: For Vinyl-Clad windows:

FIG. 8B

FIG. 7B

Drive 1/2Ǝ(12.7 mm) locking screws through the frame lock and into the sill (FIG. 9A). NOTE:To prevent

window sill from splitting, drill 1/8Ǝ(3mm) pilot holes before driving screws. Drive 1/2Ǝ(12.7 mm) locking

screws through frame holes into window sash (FIG. 9B).

FIG. 9A

FIG. 9B

Drive locking screws:

wooden windows: Vinyl-Clad windows:

Keep a firm grip on the air conditioner, carefully place the unit into the window opening so the bottom of the air

conditioner frame is against the window sill (FIG. 6A & FIG. 6B). Carefully close the window behind the top rail

of the unit.

INSIDE OUTSIDE

FIG. 6B

Wooden Windows Vinyl-Clad Windows

INSIDE OUTSIDE

FIG. 6A

Installation

FIG. 13 FIG. 14

FOAM SEAL

Cut foam window seal and insert it into the space between the upper and lower sashes (FIG. 14).

NOTE: It is difficult to lock the windows with the sash lock for Vinyl-Clad windows, so you can use lock by

(FIG. 13).

window itself.

FIG. 10

FIG. 11 FIG. 12

Measure the inner width

of the side curtain

12345678910 111213 14 15

123456

Measure the width of the inner side curtain with the provided ruler, as shown (FIG. 10). Mark a line on the

patterned side of the provided insulation panel according to the measured width, then cut out the insulation

panel along the line, as shown (FIG.11). Place the patterned side of the insulation panel to face inside your

room, then slide the insulation panel into the frame until the panel goes into the side curtain frame completely.

If the insulation panel does not slide in the frame smoothly, trim the insulation panel then try again, until the

insulation panel fits the frame, as shown (FIG.12). Repeat these instructions for the other side.

Installation

Removing the air conditioner From Window

Turn the air conditioner off, and disconnect power cord.

Remove sash seal from between windows, and unscrew sash lock.

Remove screws installed through frame and framelock.

Remove the insulation panel and close (slide) side panels into frame.

Keeping a firm grip on air conditioner, raise sash and

carefully remove.

Be careful not to spill any condensate water while lifting

unit from window. Store parts WITH air conditione

Weather stripping

normal use, correct the slope otherwise.

FIG. 15A & FIG. 15B).

FIG. 15A

Wooden Window

EDISTUOEDISNI INSIDE

about

Bottom Rail

Vinyl-Clad Window

Bottom Rail

OUTSIDE

In order to minimize air leaks between the room air conditioner

and the window opening, suitable weather stripping(trim the

provided weather stripping into suitable size) should be applied

in case of any gaps found at the location as indicated by the

arrows in Fig. 16.

FIG. 15B

FIG. 16

Tabla de contenidos

Otros manuales de Acondicionador de aire de Frigidaire

Frigidaire

Frigidaire FAH12EN2T3 Guía de inicio rápido

Frigidaire

Frigidaire Designer Series Manual de usuario

Frigidaire

Frigidaire GAC102P1A - GIBSON 10000BTU 115V 9.2A 9.8E3 SPD 8 WAY AIR... Guía de inicio rápido

Frigidaire

Frigidaire FAC105L1A1 Manual de usuario

Frigidaire

Frigidaire FAH086M1T1 Manual de usuario

Frigidaire

Frigidaire Home Comfort FRA106HT2 Instrucciones de instalación

Frigidaire

Frigidaire 66121613 Manual de usuario

Frigidaire

Frigidaire FRA106CV1 Manual de usuario

Frigidaire

Frigidaire FAA051N7A2 Manual de usuario

Frigidaire

Frigidaire 220211A177 Manual de usuario

Frigidaire

Frigidaire FFRE12L3Q16 Manual del propietario

Frigidaire

Frigidaire FAC053J7A1 Manual de usuario

Frigidaire

Frigidaire FAM157S1A13 Manual de usuario

Frigidaire

Frigidaire FAS225J2A3 Manual de usuario

Frigidaire

Frigidaire CRA052XT70 Manual de usuario

Frigidaire

Frigidaire FRA126CT1 Manual de usuario

Frigidaire

Frigidaire FRA08EZT1 Manual de usuario

Frigidaire

Frigidaire FAC125P1 Manual de usuario

Frigidaire

Frigidaire FRA156MT1 Instrucciones de instalación

Frigidaire

Frigidaire FRA25ESU2 Instrucciones de instalación

Frigidaire

Frigidaire FAA087P7 Manual de usuario

Frigidaire

Frigidaire FAK103J1V4 Manual de usuario

Frigidaire

Frigidaire FAS155J1A1 Manual de usuario

Frigidaire

Frigidaire FAA063P7 Manual de usuario

Manuales populares de Acondicionador de aire de otras marcas

Spheros

Spheros CC 355 Manual de usuario

Bosch

Bosch Climate 5000 SCI 24 CAS/ OU- OUE Manual de usuario

Panasonic

Panasonic CS-E12HKEW Manual de usuario

nedis

nedis ACMB1WT7 Manual de usuario

Samsung

Samsung AR KV Series Guía

Daikin

Daikin FCFV50A Manual de usuario

Fujitsu

Fujitsu Inverter ASBA30JFC Manual de usuario

Toshiba

Toshiba RAS-M10SMUV-E Manual de usuario

Daikin

Daikin FXLQ20MAVE Manual de usuario

Hitachi

Hitachi RAS-E24CAK Manual de usuario

CIAT

CIAT Magister 2 Series Guía

Bestron

Bestron AAC6000 Manual de usuario

Hisense

Hisense 7K Manual técnico

Samsung

Samsung AS09HM3N Manual de usuario

Soleus Air

Soleus Air GB-PAC-08E4 Manual de usuario

McQuay

McQuay MCK020A Manual de usuario

Webasto

Webasto Frigo Top 25 DS Manual de usuario

Mitsubishi Electric

Mitsubishi Electric MSC-GE20VB Manual de usuario