INSTALLATION
DIMENSIONS
Step1 Install the Wall Mount(A) at the applied position
Please check the area where LCD TV will be installed carefully. Make sure it is
strong enough to sustain the total weight of the display and wall mount kit. Do
not install on irregular surface. The wall mount kit must be installed by
professional personnel. At lease two persons are needed to install or remove
the product in order to prevent any accident.
Step3 Assemble the Bracket(D) with Wall Mount(A) Step4 Adjust the view angle for LCD TV
1. Hang the LCD TV assembled with the Bracket (D) on the Wall Mount (A)
mounted on the wall.
2. Please notice that the safety hook on the Bracket (D) must hook on the Wall
Mount (A) very firmly. Do not release the display until the hook have securely
hooked onto the crossbars.
3. Move the safety hook located on each bracket into position and insert M6*8L
Screw(H) into the hole on the safety hook to fix and to avoid having the display
accidentally lifted from the mount.
Please release the safety hook first before removing LCD TV from the Wall
Mount (A). Do not pull LCD TV directly to prevent persons and equipment from
damage. At least two persons are needed to remove the product.
1. Use screw driver to loose the bolts at both sides.
2. Adjust the view angle of LCD TV to the angle you prefer. The Maximum
adjustable angle is 10 degree.
3. Please tighten the bolts at both sides after adjustment in order to fix the
optimal view angle.
When adjusting the bolts, do not take out the bolts to prevent any damage.
Please remember to tighten the bolts after adjustment in case of shocks.
Check the bolts regularly. Tighten the bolts again if they become loose.
Please contact the distributor if the condition is not improved.
1. Wooden Wall or Drywall -drill a 5.0mm pilot hole at each location using an
electric drill. Fix Wall Mount(A) to the wall using the Hex Lag Bolts(B).
2. Concrete- drill a hole at each location using a 8mm masonry bit. Remove any
excess dust from the holes. Insert one Concrete Anchor(C) in to each hole.
Fix Wall Mount (A) to the wall using the Hex Lag Bolts (B).
3. Do not release the Wall Mount(A) until all screws are secure.
704
450
425
214
184
TKLA-8420 LCD TV Bracket
66
Unit: MM
Step2 Assemble the Bracket(D) with LCD TV
1. Screw could go through the holes on the washer respectively.
2. The VESA holes at the back of different brands of LCD TV/Plasma TV might
be different. If the screws do not match the VESA holes at the back of LCD
TV, please contact your distributor.
sFandG
1.TakeoutscrewsF&Gandchoose the suitable screw which mostly match the
VESA holes at the back of LCD TV. Then go through the matched hole on the
Washer(E). (For example, if M6 screw is the matched screw, then it should go
through the biggest hole on the washer(E).)
2. Place the LCD TV at flat place. Screw the Bracket (D)at the back of LCD TV
with the matched screws. Make sure the screws are snug, but do not over-
tighten.
H
554
450
425
214
184
TKLA-8370 LCD TV Bracket
66
Unit: MM
F G
M6 M5
TOOLS REQUIRED Crosshead Screw Driver
Portable or Electric Drill
7mm Socket Wrench or Ratchet with 7 mm
5.0mm Drill Bit for Wooden Wall or Drywall Installation
8.0mm Masonry Bit for Concrete Installation
Socket
