foc.us TView Micro Manual de usuario
TView Micro
User’s Guide
Rev. 04/02
FCC NOTICE
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy, and if not
installed and used in accordance with the installation
manual, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by turning
the equipment on and off, the user is encouraged to try to
correct the interference by one or more of the following
measures:
•This unit was tested with shielded cable. Therefore,
for continued compliance, use the shielded cables
provided with the unit.
•Re-orient or relocate the unit or receiving antenna.
•Increase the separation between the
computer/converter and television.
•Connect the equipment to an outlet on a circuit
different from that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV
technician for help.
You may find the following booklet helpful:
How to Identify and Resolve Radio-TV Interference
Problems (stock number 004-000-000345-4)
To order the booklet, write to:
The U.S. Government Printing Office
Washington D.C. 20402
COPYRIGHT
This document and the software described in it are
copyrighted under United States Copyright Laws. No part
of this document or software may be copied without prior
written consent from FOCUS Enhancements, Inc. except
in the normal use of the software as described in this
documentation. All printed circuits, their physical
implementation on printed circuit boards and associated
software are copyrighted with all rights reserved. Under
the copyright laws, the printed circuit board, or the
software programs provided may not be copied in whole
or part, without written consent of FOCUS
Enhancements, Inc., except in the normal use of the
software programs to make a backup copy. This
exception does not allow copies to be made for others,
whether sold or not, but all of the material may be sold,
given, or loaned to another person. Under the law,
copying includes translating into another language or
format.
Microsoft Windows, Windows 95, 98, 2000, ME, NT, XP
and Microsoft are trademarks of Microsoft Corporation.
All other products named are trademarks of their
respective manufacturers.
©2002 FOCUS Enhancements, Inc. All Rights Reserved
This is a blank page
Table of Contents
CHAPTER 1 4
CHAPTER 2 10
Checking the Packing List 11
Packing List 11
Inspecting the Equipment 12
CHAPTER 3 22
Windows 95, 98, NT, 2000, ME & XP 25
Macintosh 25
Configuring the Macintosh Monitor Mode 26
CHAPTER 4 28
Brightness 29
Color 29
Sharpness 29
Tint or Hue 29
CHAPTER 5 30
Preface 1
About the User’s Guide
The TView Micro User’s Guide is designed to help you to
quickly and easily connect the hardware and install the
software for this product. The guide is divided into the
following chapters:
Chapter 1: Introduction: which describes the key
features and functionality of the product and some of its
many uses. The chapter also discusses the notation
conventions used in the guide.
Chapter 2: Installing the Hardware: which
describes the information you should know before
installing and connecting the TView Micro hardware, and
the steps required to perform the installation.
Chapter 3: Image Control: describes the location
and functions of the control buttons on the TView Micro
unit and the auto-save memory function. It also describes
the steps involved in configuring your PC or laptop video
output.
Chapter 4: Tuning Your Television: this chapter
describes the methods you can use to tune the image on
your television.
Chapter 5: Troubleshooting: describes possible
problems that you might encounter and ways to solve
them.
TView Micro User’s Guide
About This Guide 2
Notation Conventions
This user’s guide uses the following conventions to
specify certain types of information.
Warns you about potential problems
and hazards during the installation or
use of the product. Read these
warnings carefully, and be sure you
understand how they relate to the
installation procedures before
proceeding.
Note: Points out important or useful information.
Contact Information
To get information on the reseller nearest to you, to order
replacement parts, or for technical support contact one of
the following:
Focus Enhancements
Worldwide Headquarters
1370 Dell Avenue
Campbell, CA
Customer Service 800-338-3348 (U.S. Only)
Technical Support 408-370-9963
TView Micro User’s Guide
Introduction 4
Chapter 1
Introduction
The TView Micro converts the VGA output from your
computer into video that can be displayed on a television
or recorded to a VCR. TView Micro automatically detects
VGA, SVGA, and XGA resolutions and synchronizes
them with your television. The result is a high quality,
flicker-free television display from your computer.
Features
The TView Micro includes the following features:
•Contains the industry leading FS 400 Chip which
provides the best possible resolution for PC-to-TV
scan conversion
•Plug and play pure hardware design
•Support for 640 x 480 800 x 600 and 1024 x 768
resolution at frequencies up to 152Hz
•Supports NTSC or PAL systems ( Two versions sold
seperately)
•Supports Composite and S-Video
•Manufacture default reset
•Power consumption from PC’s keyboard or USB port
•Compatibility with any size television monitor
(NTSC/PAL) with an RCA (composite), S-Video input
connection (Pending purchase of NTSC or PAL unit)
Chapter 1 5
•Works with multiple platforms including Mac OS 7.1
or higher, Microsoft Windows 95, 98 , NT, 2000 and
ME
•8 Levels of Brightness Control along with 8 Levels of
Sharpness and Flicker Filter
•8 Levels of Over/UnderScan and Horizontal/Vertical
Scan
•EE-ROM auto save TV-Position and Size
•Zoom/Pan and freeze/unfreeze
•2D Flicker Filter with 8 Levels
•Auto power on/off
•VGA to SCART adapter for PAL version
TView Micro User’s Guide
Introduction 6
Modes of Operation
The TView Micro has ability to operate in three separate
modes:
1. Presentation Mode: Display the same image on your
computer
2. Television Only Mode: Use the television as your only
display.
3. Video Record Mode: Record your video image
directly to videotape.
Otros manuales para TView Micro
1
Tabla de contenidos
Otros manuales de Convertidor de medios de foc.us
foc.us
foc.us FIREWRITER REMOTE Manual de usuario
foc.us
foc.us MCSDI-1 Manual de usuario
foc.us
foc.us Harmony 2ES Manual de usuario
foc.us
foc.us TView Micro XGA Manual de usuario
foc.us
foc.us iTView Mac Manual de usuario
foc.us
foc.us iTView DV Manual de usuario
foc.us
foc.us TView Gold PCI Manual de usuario
foc.us
foc.us Quadscan Elite Manual de usuario
foc.us
foc.us MCSDI-1 Manual de usuario
foc.us
foc.us MEDIACONVERTER MC-2E Manual de usuario
foc.us
foc.us Harmony 2ES Manual de usuario
foc.us
foc.us TView Gold PCI Manual de usuario
foc.us
foc.us TView Micro XGA Manual de usuario
foc.us
foc.us MediaConverter Manual de usuario
foc.us
foc.us TView Micro SXGA Manual de usuario
foc.us
foc.us Quadscan Elite Manual de usuario
foc.us
foc.us TView PresoCard Manual de usuario
foc.us
foc.us TView Gold PCI Manual de usuario
foc.us
foc.us Quadscan Elite Manual de usuario
foc.us
foc.us LTV Portable Pro Manual de usuario
