foc.us iTView DV Manual de usuario
iTView DV
User’s Guide
Rev. 9/01
FCC NOTICE
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy, and if not
installed and used in accordance with the installation manual, may
cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment on and off, the user is encouraged to try to correct the
interference by one or more of the following measures:
•This unit was tested with shielded cable. Therefore, for
continued compliance, use the shielded cables provided with the
unit.
•Re-orient or relocate the unit or receiving antenna.
•Increase the separation between the computer/converter and
television.
•Connect the equipment to an outlet on a circuit different from
that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for
help.
You may find the following booklet helpful:
How to Identify and Resolve Radio-TV Interference Problems (stock
number 004-000-000345-4)
To order the booklet, write to:
The U.S. Government Printing Office
Washington D.C. 20402
COPYRIGHT
This document and the software described in it are copyrighted under
United States Copyright Laws. No part of this document or software
may be copied without prior written consent from FOCUS
Enhancements, Inc. except in the normal use of the software as
described in this documentation. All printed circuits, their physical
implementation on printed circuit boards and associated software are
copyrighted with all rights reserved. Under the copyright laws, the
printed circuit board, or the software programs provided may not be
copied in whole or part, without written consent of FOCUS
Enhancements, Inc., except in the normal use of the software
programs to make a backup copy. This exception does not allow
copies to be made for others, whether sold or not, but all of the
material may be sold, given, or loaned to another person. Under the
law, copying includes translating into another language or format.
Mac OS 7.1, 8.5, 9.0 and 10 are trademarks of the
Apple Corporation. All other products named are trademarks of
their respective manufacturers.
©2001 FOCUS Enhancements, Inc. All Rights Reserved
This is a blank page
Table of Contents
CHAPTER 1 INTRODUCTION 4
CHAPTER 2 HARDWARE INSTALLATION 9
Packing List 9
Inspecting the Equipment 10
Installing the RGB Cover on your iMac DV 10
Connecting the iTView DV to a Television 13
Connecting the iTView DV to a VCR 18
Functions of the iTView DV LED 20
CHAPTER 3 iTVIEW DV SOFTWARE 21
Installing the iTView DV Control Panel Software 21
Screen Controls 22
TV Output Controls 24
Picture Setup 26
Additional Features 28
CHAPTER 4 TUNING YOUR TELEVISION 31
Brightness 32
Color 32
Sharpness 32
Tint or Hue 32
CHAPTER 5 TROUBLESHOOTING 33
Returning a Damaged or Failed iTView DV Unit 35
iTView DV User’s Guide
Preface 1
About the User’s Guide
The iTView DV User’s Guide is designed to help you to quickly and
easily connect the hardware and install the software for this product.
The guide is divided into the following chapters:
Chapter 1: Introduction: which describes the key features and
functionality of the product and some of its many uses. The chapter
also discusses the notation conventions used in the guide.
Chapter 2: Hardware Installation: which describes the information
you should know before installing and connecting the iTView DV
hardware, and the steps required to perform the installation.
Chapter 3: iTView DV Software: Describes the steps required to
install the iTView DV software control panel and how to operate the
program.
Chapter 4: Tuning Your Television : this chapter describes the
methods you can use to tune the image on your television
Chapter 5: Troubleshooting : describes possible problems that you
might encounter and ways to solve them..
iTView DV User’s Guide
About This Guide 2
Notation Conventions
This user’s guide uses the following conventions to specify certain
types of information.
Warns you about potential problems and hazards during
the installation or use of the product. Read these
warnings carefully, and be sure you understand how
they relate to the installation procedures before
proceeding.
Note: Points out important or useful information.
Contact Information
To get information on the reseller nearest to you, to order
replacement parts, or for technical support contact one of the
following:
Worldwide Headquarters
1370 Dell Avenue
Campbell, CA 95008
Customer Service 800-338-3348 (U.S. Only)
Technical Support 408-370-9963
iTView DV User’s Guide
Chapter 1 4
Chapter 1 Introduction
The iTView DV converts the VGA output from your computer into
video that can be displayed on a television or recorded to a VCR.
iTView DV automatically detects VGA ,SVGA, and XGA output
frequencies up to 152Hz and synchronizes it with your television. The
result is a high quality, flicker-free television display from your
computer.
Features
The iTView DV includes the following features:
•Screen position controls
•Variable horizontal and vertical scaling controls
•Variable zoom controls
•Image freeze control
•Brightness,Contrast, Sharpness, Flicker Filter, Color Saturation
•2D flicker filter controls
•Easy plug-and-play installation for iMac DV personal computers
•Compatibility with any size television monitor (NTSC/PAL) with
an RCA (composite), S-Video, or SCART (Europe only) input
connector.
•Support for 640 x 480 (VGA), 800 x 600 (SVGA) and 1024 x 768
(XGA) resolution at frequencies up to 152Hz
•Support for 24-bit color
•TrueScale™ image compression that precisely fits the image on
your television without dropping lines or altering video resolution
•Electronic Marker™ Software
iTView DV User’s Guide
Introduction 5
Modes of Operation
The iTView DV has ability to operate in two separate modes:
Figure 1-1: Presentation Mode
1. Presentation Mode: Display the same image on your computer
and your television.
iTView DV User’s Guide
Chapter 1 6
Figure 1-2: Video Record Mode
2. Video Record Mode: Record your video image or digital movie
directly to your videotape.
Tabla de contenidos
Otros manuales de Convertidor de medios de foc.us
foc.us
foc.us TView Pro AV Manual de usuario
foc.us
foc.us MCSDI-1 Manual de usuario
foc.us
foc.us Quadscan Elite Manual de usuario
foc.us
foc.us TView Micro Manual de usuario
foc.us
foc.us MCSDI-1 Manual de usuario
foc.us
foc.us TView PresoCard Manual de usuario
foc.us
foc.us TView Micro SXGA Manual de usuario
foc.us
foc.us HyperConverter 1024 Manual de usuario
foc.us
foc.us MEDIACONVERTER MC-2E Manual de usuario
foc.us
foc.us TView Micro XGA Manual de usuario
foc.us
foc.us iTView Mac Manual de usuario
foc.us
foc.us TView Micro Manual de usuario
foc.us
foc.us TView Silver Manual de usuario
foc.us
foc.us TView Gold PCI Manual de usuario
foc.us
foc.us FIREWRITER REMOTE Manual de usuario
foc.us
foc.us TView Gold PCI Manual de usuario
foc.us
foc.us MediaConverter Manual de usuario
foc.us
foc.us TView Pro AV 1600 Manual de usuario
foc.us
foc.us TView Micro XGA Manual de usuario
foc.us
foc.us MMC-2 Manual de usuario
