Fly Sky FS-i6X Manual de usuario
X220 v2 User Manual
catalogue
1 product introduction.................................................................................................3
2 Remote Control Radio Transmitter........................................................................ 4
2.1 Buttons and switches................................................................................... 4
2.2 Basic operation............................................................................................. 5
2.3 Joystick functions..........................................................................................5
2.4 Display............................................................................................................7
3 Flight Guide............................................................................................................... 9
3.1 Safety instructions........................................................................................ 9
3.2 Arm/disarm and flight modes...................................................................... 9
3.3 Basic operation of drone........................................................................... 10
3.3.1 Power the drone................................................................................. 10
3.3.2 Replacement of propeller................................................................... 10
3.4 Binding......................................................................................................... 11
3.5 Pre flight inspection....................................................................................11
3.6 Frist fly.......................................................................................................... 12
3.7 Warning&security....................................................................................... 12
4 Battery......................................................................................................................14
4.1 Battery voltage............................................................................................ 14
4.2 Charging method........................................................................................ 14
4.3 Preservation method.................................................................................. 14
4.4 Warning&security....................................................................................... 15
5 Advanced operations.............................................................................................. 16
5.1 Flight controller wiring diagram................................................................ 16
5.2 Equipment wiring diagram.........................................................................16
5.3 Fpv fly........................................................................................................... 18
1 product introduction
Components
x220 v2 RTF
FLYSKY I6X Remote Control Radio Transmitter
Package Included:
1 x X220 V2 Frame Kit
1 x Flysky FS-i6X Remote Control
1 x Flysky FS-A8S Receiver
1 x 1500mAH 4S 14.8V Battery
2 x 2207 2550KV Motor CW
2 x 2207 2550KV Motor CCW
1 x PDB-XT60
1 x F405 DJI DUAL BEC V1 Flight Controller
4 x 30A Independent ESC
1 x FOXEER Arrow MICRO PRO Camera
1 x TC5804 PRO VTX
4 x 5046 3-blade Propeller CW
4 x 5046 3-blade Propeller CCW
1 x 30° Camera Mount (For Gopro5/6/7)
1 x Charger
1 x Antenna
2 x Battery Strap
2 x Carbon Wrench
2 Remote Control Radio Transmitter
2.1 Buttons and switches
The functions of switches, buttons and buttons are shown in the figure
below：
2.2 Basic operation
Turn on / off the remote control: push the power switch
Install the battery: open the battery compartment cover on the back of
the remote control and install the battery
2.3 Joystick functions
joystick operation is divided into left throttle and right throttle, please
check according to the type of your purchase.。
2.3.1 left throttle
As shown in the figure above:
Left joystick：
Up and down for Throttle, control the drone ascent or descent
Left and right for Yaw，Control the drone to turn left or right
Right joystick：
Up and down for Pitch，Control the drone to lean forward or backward
Left and right for Roll，Control the aircraft to tilt left or right
2.3.2 right throttle
As shown in the figure above:
Left joystick：
Up and down for Pitch，Control the drone to lean forward or backward
Left and right for Yaw，Control the drone to turn left or right
Right joystick：
Up and down for Throttle, control the drone ascent or descent
Left and right for Roll，Control the aircraft to tilt left or right
2.4 Display
Tx：The voltage of the Transmitter
Rx ： Voltage of receiver （ If the drone and Transmitter not connected
successfully，it does not display）
Sig：signal intensity
3 Flight Guide
So far, you have the necessary understanding of transmitter and drone, you
can start from the flight guide
3.1 Safety instructions
The flight of the drone must comply with local laws and regulations!
Keep a safe distance in all directions around the drone to avoid collision.
Operate a drone in an open space away from people and traffic.
3.2 Arm/disarm and flight modes
Arm：The motor rotates at idle speed, and
the drone can be controlled at this time
Disram：The motor of the aircraft stops
immediately, and the drone cannot be
controlled at this time
Switch SA:Arm/Disram of drone
Drone will be disarmed if SA is down
Drone attempts to arm if the user moves switch SA up（Arming may fail If the
throttle is not at the lowest position)
To ensure your flight experience, the dronet has two flight modes:
Leve mode：
The joysticks controls the current tilt angle of thedrone. The drone will
return to horizontal flight when the joysticks are centered,Recommended for
beginners.
ACRO mode:
The joysticks controls the rotation speed of the drone. When the joystick
is centered, the drone will maintain its current angle.
Switch SB:Level/Arco mode
The flight mode is "level mode".If the switch SB is down
Theflight mode is "acro mode"If switch SB is up
3.3 Basic operation of drone
3.3.1 Power the drone
Strap the battery to the upper cover plate of the drone, connect its XT60
plug to the same plug of the aircraft, the flight control indicator lights up, and
the power supply of the drone is successful
Warning⚠：
In the case of non immediate flight such as drone maintenance, please
remove the blades when connecting the battery.
3.3.2 Replacement of propeller
Grasp the motor by hand, use the matching wrench to remove the blade
nut, pull out the blade, and replace it according to the figure below.
The blade is sharp. Pay attention to safety when disassembling the blade.
Other tools can be used if necessary.
3.4 Binding
This kit has completed the frequency matching between the transmitter
and the receiver. If you want to use another receiver or repeat bind, please
follow the following steps:
1. Turn on the transmitter power and press the bind key to enter the
code matching state.
2. Press and hold the bind key on the receiver, and connect the power to
the receiver. The flash of the indicator light on the receiver indicates that the
receiver enters the code matching state; After successful bind, the status
indicator of the receiver changes from fast flashing to slow flashing.
3. Exit the transmitter from the binding interface manually, and the status
indicator of the receiver will be on.
4. Check whether the transmitter, receiver and model work normally. If
there is any abnormality, repeat the above steps to re code.
3.5 Pre flight inspection
Make sure that all components are included and not damaged, and the
battery is installed firmly。
Otros manuales para FS-i6X
1
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Transmisor de Fly Sky
Manuales populares de Transmisor de otras marcas
Dejero
Dejero EnGo 3x Manual de usuario
Rosemount
Rosemount 4600 Manual de usuario
Speaka Professional
Speaka Professional 2342740 Manual de usuario
trubomat
trubomat GAB 1000 Manual de usuario
Teledyne Analytical Instruments
Teledyne Analytical Instruments LXT-380 Manual de usuario
Rondish
Rondish UT-11 Manual de usuario
