Fluke 574 Manual de usuario

574

Precision Infrared Thermometer

Users Manual

March 2005

All product names are trademarks of their respective companies.

574

LIMITED WARRANTY AND LIMITATION OF

LIABILITY

This Fluke product will be free from defects in

material and workmanship for one year from the

date of purchase. This warranty does not cover

fuses, disposable batteries, or damage from

accident, neglect, misuse, alteration, contami-

nation, or abnormal conditions of operation or

handling. Resellers are not authorized to extend

any other warranty on Fluke’s behalf. To obtain

service during the warranty period, contact your

nearest Fluke authorized service center to obtain

return authorization information, then send the

product to that Service Center with a description

of the problem.

THIS WARRANTY IS YOUR ONLY REMEDY. NO

OTHER WARRANTIES, SUCH AS FITNESS FOR

A PARTICULAR PURPOSE, ARE EXPRESSED

OR IMPLIED. FLUKE IS NOT LIABLE FOR ANY

SPECIAL, INDIRECT, INCIDENTAL OR CONSE-

QUENTIAL DAMAGES OR LOSSES, ARISING

FROM ANY CAUSE OR THEORY. Since some

states or countries do not allow the exclusion or

limitation of an implied warranty or of incidental

or consequential damages, this limitation of liabi-

lity may not apply to you.

574

Warning

A Warning identiﬁes conditions and actions that pose ha-

zards to the user. To avoid electrical shock or personal injury,

follow these guidelines:

• Do not point laser directly at eye or indirectly off

reﬂective surfaces.

• Before using the thermometer inspect the case. Do not

use the thermometer if it appears damaged. Look

for cracks or missing plastic.

• Replace the batteries as soon as the battery indicator

two or less segments.

• Do not use the thermometer if it operates abnormally.

Protection may be impaired. When in doubt, have the

thermometer serviced.

• Do not operate the thermometer around explosive gas,

vapor, or dust.

• Do not connect the optional external probe to live

electrical circuits.

• To avoid a burn hazard, remember that highly reﬂective

objects will result in lower than actual temperature

measurements.

• Do not use in a manner not speciﬁed by this manual or the

protection supplied by the equipment may be impaired.

Caution

To avoid damaging the thermometer or the equipment under

test protect them from the following:

• EMF (electro-magnetic ﬁelds) from arc welders,

induction heaters, etc.

• Static electricity

• Thermal shock (caused by large or abrupt

ambient temperature changes- allow 30 minutes

for thermometer to stabilize before use).

• Do not leave the thermometer on or near

objects of high temperature.

Safety Information

574

Table of Contents

Introduction ........................................................... 5

Warning for the Model 574 NI ............................... 6

Symbols and Safety Markings .............................. 7

Laser Warning and Serial Number Labels ............. 8

Delivery Content .................................................... 9

Functions and Display ........................................... 10

Batteries and Measurement .................................. 11

Field of View .......................................................... 12

Spot Size ............................................................... 13

Emissivity - Explanation and Adjust ...................... 14

Emissivity - Table and Unknown Value .................. 15

Mode - Maximum and Minimum ........................... 16

Mode - Difference and Avarage ............................ 17

Probe Connections ................................................ 18

Setup Alarm ........................................................... 19

Setup - Time and Date .......................................... 20

Setup - Offset and Min-Max Values ...................... 21

Data Logging and Recall ....................................... 22

Display ................................................................... 23

Display - Man. Range ............................................ 24

Display - Cycle ..................................................... 25

DIP Switches ......................................................... 26

Troubleshooting ..................................................... 27

Maintenance .......................................................... 28

Emissivity Table (Selected Values) ......................... 29

CE Conformity ....................................................... 30

Speciﬁcations ........................................................ 31

Factory Defaults .................................................... 32

574

The Fluke Model 574 Infrared Thermometer (the

thermometer) is for non-contact temperature

measurement. This thermometer determines

an object‘s surface temperature by measuring

the amount of infrared energy radiated by the

object‘s surface.

Contacting Fluke

To contact Fluke, call one of the following

telephone numbers:

USA: 1-888-44-FLUKE (1-888-443-5853)

Canada: 1-800-36-FLUKE (1-800-363-5853)

Europe: +31 402-675-200

Japan: +81-3-3434-0181

Singapore: +65-738-5655

Anywhere in the world: +1-425-446-5500

For USA Service: 1-888-99-FLUKE (1-888-993-5853)

Or, visit Fluke's Web site at www.ﬂuke.com.

To register your product, visit register.ﬂuke.com.

Introduction

574

Concerning Factory Mutual Approved

Nonincendive Devices:

Operation in Environments that Require

Nonincendive Devices

WARNING

IN HAZARDOUS LOCATIONS DO NOT use serial port con-

nections, change batteries or open serial port cover. To re-

duce risk of explosion in hazardous locations, use only Fluke

temp probe part 2432508 and do not use other accessories,

such as power supply and cables.

A nonincendive rating (NI) indicates that this infrared thermo-

meter has been tested to standards for preventing explosi-

ons in hazardous areas by limiting the ability of equipment

to ignite a speciﬁ ed ﬂ ammable gas or vapor-in-air mixture.

Nonincendive equipment is incapable of releasing sufﬁ cient

electrical or thermal energy to ignite ﬂ ammable gases or

vapors under NORMAL operation and environmental condi-

tions.

This noncontact thermometer has a Factory Mutual Nonin-

cendive rating. The rating from this USA organization reads:

“Nonincendive, Class I, Division 2, Groups A, B, C, D; Class

I, Zone 2 IIC; T4 Ta = 50ºC when used with 1.5V alkaline

batteries.“

A Class I, Division 2 location is a location:

• where volatile ﬂ ammable liquids or ﬂ ammable gases

or vapors exist, but are normally conﬁ ned within

closed containers;

• where ignitable concentrations of gases, vapors or liquids

are normally prevented by positive mechanical

ventilation; or

• adjacent to a Class I, Division 1 location, where ignitable

concentrations might be occasionally communicated

• groups A, B, C, D refers to: Acetylene, Hydrogen,

Ethylene, and Propane.

Warning for the Model 574 NI

574



Symbol Explanation



Risk of danger. Important information. See

Manual.

Risk of danger. Important information. See

Manual.

Risk of danger. Important information. See



Hazardous voltage. Precedes warning



Warning. Laser.



Conforms to requirements of European Union

and European Free Trade Association (EFTA)

Conforms to requirements of European Union

and European Free Trade Association (EFTA)

Conforms to requirements of European Union

Celsius

Fahrenheit

Battery

Symbols and Safety Markings



The laser sight simplifies

sighting of the measure-

ment object. It

shows the

spot size that includes the

measured target.

To turn the laser on or off

press the LASER button

(K) when the trigger is

pulled. A laser symbol (1)

appears when the laser is

on.

The laser automatically

turns of

f if you release the

trigger.

LASER

574

Laser Warning and Serial Number Labels

574

• The unit

• Getting Started

• Two AA batteries

• Manual on CD

• Thermocouple type K probe

• Windows-based software on CD

• RS232 cable

• Power supply

Delivery Content

574

Functions and Display

Function keys and display:

(A) Visual and audible

alarm

(B) Display

(D) Enter

(E) Handle and battery

compartment

(DIP

switches for

adjustments are

inside handle)

(F)

Trigger

(G) Tripod mount

(H) 6 main function keys

FUNCTIONS

SER INTERFACE

Displayed functions:

(1) Laser condition /

Lock symbol

(2)

ime (or date)

(3) Main temperature

display

(4) Graphic display

(5) Emissivity value

(6) Status bar

(7) Mode indicator

(8) Battery life indicator

(9) MAX, MIN, DIF, AVG

symbols

DISPLAY

Tabla de contenidos

Otros manuales de Termómetro de Fluke

Fluke

Fluke VT08-II Manual de usuario

Fluke

Fluke 561s Manual de usuario

Fluke

Fluke 67 MAX Manual de uso y cuidado

Fluke

Fluke Comark C12 HACCP Manual de usuario

Fluke

Fluke 1551A Ex Manual de uso y cuidado

Fluke

Fluke 56X Manual de usuario

Fluke

Fluke VT06 Instrucciones originales

Fluke

Fluke 61 Manual de instrucciones

Fluke

Fluke 65 Manual de usuario

Fluke

Fluke 900 Service Manual de usuario

Fluke

Fluke 572-2 Manual de lista de piezas

Fluke

Fluke 9133 Manual de usuario

Fluke

Fluke 5624 Manual de usuario

Fluke

Fluke CNX t3000 Manual de uso y cuidado

Fluke

Fluke FoodPro Manual de usuario

Fluke

Fluke Hart Scientific 1523 Guía de inicio rápido

Fluke

Fluke 62 MAX Manual de usuario

Fluke

Fluke 1551A Ex Manual de usuario

Fluke

Fluke 1529 Chub-E4 Manual de usuario

Fluke

Fluke 62 MAX Manual de usuario

Fluke

Fluke 54 Series II Manual de usuario

Fluke

Fluke 67 MAX Manual de usuario

Fluke

Fluke Comark C21 Manual de usuario

Fluke

Fluke Hart Scientific 1575 Super-Thermometer Manual de usuario

Manuales populares de Termómetro de otras marcas

Delton

Delton 981A Manual de usuario

Baker

Baker MM2P Manual de usuario

Tarmo

Tarmo 320281 Manual de usuario

Citizen

Citizen CTD 504 Manual de usuario

TFA

TFA 14.1500 Manual de usuario

Vive

Vive DMD1010 Manual de usuario

Gotemp

Gotemp THB4002 Manual de usuario

GREISINGER

GREISINGER G 1202 Manual de usuario

Amprobe

Amprobe TMD-53W Manual de usuario

Trotec

Trotec BP10 Manual de usuario

Radiance instruments

Radiance instruments RT616 Series Manual de usuario

Eurolec

Eurolec IR151 Manual de usuario

Scaneo

Scaneo TS42B Manual de usuario

Sper scientific

Sper scientific 800043 Manual de usuario

Microlife

Microlife NC 200 Manual de instrucciones

Motorola

Motorola MBP69SN Guía de configuración

The MeatStick

The MeatStick The MeatStick Manual de usuario

Hama

Hama TH35-A Manual de usuario