Fluke 3000 FC Manual de usuario

May 2014, Rev. 1, 9/16

All product names are trademarks of their respective companies.

3000 FC

Wireless Multimeter

Users Manual

Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176 - TestEquipmentDepot.com

LIMITED WARRANTY AND LIMITATION OF LIABILITY

This Fluke product will be free from defects in material and workmanship for three years from the date of purchase. This

warranty does not cover fuses, disposable batteries, or damage from accident, neglect, misuse, alteration, contamination, or

abnormal conditions of operation or handling. Resellers are not authorized to extend any other warranty on Fluke’s behalf.

To obtain service during the warranty period, contact your nearest Fluke authorized service center to obtain return

authorization information, then send the product to that Service Center with a description of the problem.

THIS WARRANTY IS YOUR ONLY REMEDY. NO OTHER WARRANTIES, SUCH AS FITNESS FOR A PARTICULAR

PURPOSE, ARE EXPRESSED OR IMPLIED. FLUKE IS NOT LIABLE FOR ANY SPECIAL, INDIRECT, INCIDENTAL OR

CONSEQUENTIAL DAMAGES OR LOSSES, ARISING FROM ANY CAUSE OR THEORY. Since some states or countries

do not allow the exclusion or limitation of an implied warranty or of incidental or consequential damages, this limitation of

liability may not apply to you.

11/99

Table of Contents

Title Page

Introduction .................................................................................................................... 1

How to Contact Fluke..................................................................................................... 1

Safety Information .......................................................................................................... 1

Hazardous Voltage......................................................................................................... 5

Test Lead Alert............................................................................................................... 5

Battery Saver (Sleep Mode)........................................................................................... 5

Wireless Radio............................................................................................................... 5

MIN MAX AVG Record Mode......................................................................................... 6

Display Hold................................................................................................................... 7

Yellow Button ................................................................................................................. 7

Display Backlight............................................................................................................ 7

Manual and Auto Range................................................................................................. 8

Power-Up Options.......................................................................................................... 8

Features......................................................................................................................... 9

AC Zero Input Behavior of True-rms Meters .................................................................. 13

3000 FC

Users Manual

Wireless Radio Setup .................................................................................................... 13

Pair with Fluke Connect App..................................................................................... 14

Pair with Wireless Test Tools.................................................................................... 14

Disconnect the Wireless Radio ................................................................................. 17

Basic Measurements ..................................................................................................... 17

AC and DC Voltage Measurements.......................................................................... 17

Volts/Hertz Ratio....................................................................................................... 19

Resistance Measurements ....................................................................................... 20

Capacitance Measurements ..................................................................................... 21

Continuity Test.......................................................................................................... 22

AC or DC Current Measurements............................................................................. 23

Diode Test ................................................................................................................ 25

Frequency Measurement.......................................................................................... 27

Maintenance.................................................................................................................. 29

General Maintenance................................................................................................ 29

Fuse Test.................................................................................................................. 29

Battery and Fuse Replacement................................................................................. 30

Service and Parts .......................................................................................................... 33

Specifications ................................................................................................................ 36

AC Voltage................................................................................................................ 38

DC Voltage, Continuity, Resistance, Diode Test, and Capacitance.......................... 39

AC and DC Current................................................................................................... 40

Frequency................................................................................................................. 40

Frequency Counter Sensitivity .................................................................................. 41

Input Characteristics ................................................................................................. 42

MIN MAX Recording ................................................................................................. 42

Introduction

 Warning

To prevent possible electrical shock, fire, or

personal injury, read all safety information

before you use the Product.

The 3000 FC Wireless Multimeter (the Product) is a

True-rms Digital Multimeter. Safety Information

The Product complies with:

•ANSI/ISA-82.02.01

•CAN/CSA-C22.2 No. 61010-1-12: 3rd Edition

•UL 61010-1: 3rd Edition

•IEC/EN 61010-1:2010

•Measurement Category III, 1000V, Pollution

Degree 2

•Measurement Category IV, 600V, Pollution Degree 2

3000 FC

Users Manual

A Warning identifies conditions and procedures that are

dangerous to the user. A Caution identifies conditions

and procedures that can cause damage to the Product or

the equipment under test.

A list of symbols used on the Product and in this manual

is in Table 1.

 Warning

To prevent possible electrical shock, fire, or

personal injury:

•Carefully read all instructions.

•Do not alter the Product and use only as

specified, or the protection supplied by

the Product can be compromised.

•Limit operation to the specified

measurement category, voltage, or

amperage ratings.

•Do not use the Product around explosive

gas, vapor, or in damp or wet

environments.

•Do not touch voltages >30 V ac rms, 42 V

ac peak, or 60 V dc.

•Do not exceed the Measurement

Category (CAT) rating of the lowest rated

individual component of a Product,

probe, or accessory.

•Measure a known voltage first to make

sure that the Product operates correctly.

•Do not use the Product if it is altered or

damaged.

•Disable the Product if it is damaged.

•Do not work alone.

•Comply with local and national safety

codes. Use personal protective

equipment (approved rubber gloves, face

protection, and flame-resistant clothes)

to prevent shock and arc blast injury

where hazardous live conductors are

exposed.

Wireless Multimeter

Safety Information

•Replace the batteries when the low

battery indicator shows to prevent

incorrect measurements.

•The battery door must be closed and

locked before you operate the Product.

•Do not use the Product if it operates

incorrectly.

•Examine the case before you use the

Product. Look for cracks or missing

plastic. Carefully look at the insulation

around the terminals.

•Use only correct measurement category

(CAT), voltage, and amperage rated

probes, test leads, and adapters for the

measurement.

•Do not use test leads if they are

damaged. Examine the test leads for

damaged insulation, exposed metal, or if

the wear indicator shows. Check test

lead continuity.

•Keep fingers behind the finger guards on

the probes.

•Do not touch the probes to a voltage

source when the test leads are

connected to the current terminals.

•Connect the common test lead before

the live test lead and remove the live test

lead before the common test lead.

•Remove all probes, test leads, and

accessories that are not necessary for

the measurement.

3000 FC

Users Manual

Table 1. Symbols

Symbol Description Symbol Description

WARNING. RISK OF DANGER. WARNING. HAZARDOUS VOLTAGE. Risk of electric

shock.

Consult user documentation.  Minimum fuse interrupt rating.

Conforms to European Union directives. Conforms to relevant Australian Safety and EMC

standards.

Certified by CSA Group to North

American safety standards. Fuse

Battery Double Insulated

Conforms to relevant South Korean EMC standards.

Measurement Category II is applicable to test and measuring circuits connected directly to utilization points

(socket outlets and similar points) of the low-voltage MAINS installation.

Measurement Category III is applicable to test and measuring circuits connected to the distribution part of the

building’s low-voltage MAINS installation.

Measurement Category IV is applicable to test and measuring circuits connected at the source of the building’s

low-voltage MAINS installation.

This product complies with the WEEE Directive marking requirements. The affixed label indicates that you must

not discard this electrical/electronic product in domestic household waste. Product Category: With reference to

the equipment types in the WEEE Directive Annex I, this product is classed as category 9 "Monitoring and

Control Instrumentation" product. Do not dispose of this product as unsorted municipal waste.

Wireless Multimeter

Hazardous Voltage

The hazardous voltage warning shows on the display

when the Product detects a voltage ≥30 V.

Test Lead Alert

The display shows LEAD for 1 second when you turn the

function switch to or from the mA position to remind you

to make sure the test leads are in the correct terminals.

Battery Saver (Sleep Mode)

To save battery power, the Product includes a sleep

mode. Sleep mode turns off the display if there is no

function change or button pushed for 20 minutes. To turn

off the sleep mode, push while you turn on the

Product. The sleep mode is always turned off for a MIN

MAX AVG record session and when remote test tools are

shown on the display.

Wireless Radio

The Product uses low-power 802.15.4 wireless radio

technology to send or receive measurements to other

wireless test tools or the Fluke Connect®app on a mobile

device such as a smartphone or tablet.

You can set up to pair with:

•A mobile device. Use the Fluke Connect app to view

measurements remotely, save to Fluke Cloud™

storage, and share the information with your team.

•Up to three 3000 FC Series Wireless Test Tools.

Show their measurements on a single display.

•A 3000 FC Wireless Multimeter when it operates in

the send mode.

The wireless radio does not cause interference with meter

measurements.

Note

Changes or modifications to the wireless

2.4 GHz radio not expressly approved by Fluke

Corporation could void the user’s authority to

operate the equipment.

See Wireless Radio Setup on page 13 for instructions on

how to set up and use the wireless radio in the Product.

3000 FC

Users Manual

MIN MAX AVG Record Mode

The MIN MAX AVG record mode records the minimum

and maximum input values, and calculates a running

average of all measurements. The Product beeps when a

new high or low is sensed.

Note

For dc functions, accuracy is the specified

accuracy of the measurement function,

12 counts for changes longer than 250 ms in

duration.

For ac functions, accuracy is the specified

accuracy of the measurement function

40 counts for changes longer than 900 ms in

duration.

To start a MIN MAX AVG record session:

1. Make sure the Product is set to the correct

measurement function and on the correct range.

Autorange is disabled while in a MIN MAX AVG

record session.

2. Push . and Max show at the top of the

display. The measurement in the display is the

maximum value measured. It changes only when a

new maximum value is sensed.

3. To pause MIN MAX AVG record, push .

shows on the display while record is paused.

Recorded values are not deleted. To continue the

record session, push .

4. To exit and erase the MIN, MAX, and AVG values,

push for 1 second or turn the rotary switch.

5. To see the other recorded values (minimum and

average), push . Each push of the button

shows a different recorded value. The value shown in

the display is identified with Max, Min, or Avg to the

right of the MIN MAX icon.

Note

Sleep mode is turned off in MIN MAX AVG

record mode.

Otros manuales para 3000 FC

Tabla de contenidos

Otros manuales de Multímetro de Fluke

Fluke

Fluke 8506A Manual de usuario

Fluke

Fluke 707 Instrucciones de instalación y funcionamiento

Fluke

Fluke 83 Manual de usuario

Fluke

Fluke LinkRunner Pro LRPRO-1000 Manual de usuario

Fluke

Fluke 8010A Manual de usuario

Fluke

Fluke 80 Series III Instrucciones de funcionamiento e instalación

Fluke

Fluke 8020A Manual de usuario

Fluke

Fluke 8845A Manual de usuario

Fluke

Fluke 80 Series V Manual de usuario

Fluke

Fluke 114 Manual de uso y cuidado

Fluke

Fluke 10 Manual de usuario

Fluke

Fluke 110 Manual de uso y cuidado

Fluke

Fluke 77 Manual de uso y cuidado

Fluke

Fluke 106 Manual de usuario

Fluke

Fluke i410 Manual de usuario

Fluke

Fluke 8060A Manual de usuario

Fluke

Fluke 1587 Manual de usuario

Fluke

Fluke CNX i3000 Manual de uso y cuidado

Fluke

Fluke 79 III Manual de uso y cuidado

Fluke

Fluke 87V MAX Manual de uso y cuidado

Fluke

Fluke 77 Manual de usuario

Fluke

Fluke 8508A Manual de usuario

Fluke

Fluke LinkRunner Pro Manual de usuario

Fluke

Fluke 1587 Manual de uso y cuidado

Manuales populares de Multímetro de otras marcas

Agilent Technologies

Agilent Technologies 34420A Manual de usuario

Hameg

Hameg HM 8012 Manual de usuario

Mastech

Mastech MY70 Manual de usuario

Steren

Steren MUL-300 Manual de usuario

Somogyi Elektronic

Somogyi Elektronic home SMA 92 Manual de usuario

Gossen MetraWatt

Gossen MetraWatt METRAmax 6 Manual de usuario

PeakTech

PeakTech 4000 Manual de uso y cuidado

YOKOGAWA

YOKOGAWA 90050B Manual de usuario

Gossen MetraWatt

Gossen MetraWatt METRALINE DMM16 Manual de usuario

Tempo Communications

Tempo Communications MM200 Manual de usuario

Elenco Electronics

Elenco Electronics CM-1555 Manual de usuario

Mastech

Mastech MS8238C Manual de usuario

SDAR

SDAR 830A, 830B, 830D, 830C Manual de usuario

RS PRO

RS PRO RS-9519BT Manual de usuario

BGS technic

BGS technic 8890 Manual de usuario

Amprobe

Amprobe Hexagon 60 Manual de usuario

Morris

Morris 57074 Manual de usuario

Agilent Technologies

Agilent Technologies 34450A 5 Digit Multimeter Manual de usuario