TYPHOON 3 OPERATION GUIDE
DO NOT RETURN Mist blower TO STORE, if you experience problems or have
questions contact our Customer Support, M-F 9am-5pm EST at
+1 (803) 339-2500, or email: support@wessol.com, or nd more information
at fzspray.com/pages/troubleshoot.
OPERATING
• Do not allow familiarity with
products to make you careless.
Remember that a single moment
of carelessness is sucient to
cause serious injury.
• Always wear eye protection
with side shields when handling
or operating this mist blower.
Failure to do so could result in
serious injury from chemical
contact or ying dirt or debris.
• The Lithium-ion battery pack can
be used in temperatures down
to 32ºF. When operating in cold
temperatures, put the battery
pack in the battery compartment
and use the mist blower in a light
duty application. After about
a minute the battery pack will
warm up and begin operating
normally.
• Always use the correct power
setting for your application.
Using the correct PSI and ow
rate will result in a safer and
more thorough treatment. For
calibration resources please
contact FlowZone® technical
support. (Note: Always refer to
local, state, and federal laws
and regulations regarding your
application.)
• Do not use the mist blower if the
power switch is not functioning
correctly. Any power tool that
cannot be controlled with the
switch is dangerous and must be
repaired.
• Remove battery before making
any adjustments, changing
accessories, or storing the mist
blower. Disconnect the mist
blower from the power source by
removing the battery pack. These
preventative safety measures
reduce the risk of starting the
mist blower accidentally.
STORING
• Store mist blower out of reach of
children and do not allow persons
unfamiliar with the power tool
or these instructions to operate
the mist blower. Power tools
are dangerous in the hands of
untrained users.
• Maintain mist blowers and
accessories. Check for
misalignment or binding of
moving parts, breakage of parts
and any other condition that
may affect the mist blowers
operation.
SAFETY
• Use the mist blower and
accessories in accordance
with these instructions, taking
into consideration the working
conditions and the work to be
performed. Use of this mist
blower for applications that it was
not intended for could result in a
hazardous situation.
• Keep handles and lift points
dry, clean and free from oil and
grease. Slippery handles and
lift points do not allow for safe
handling and control of the mist
blower.
• Risk of re or explosion: Never
use this mist blower with liquids
such as gasoline, ethanol,
methanol, or any other ammable
or gas producing chemicals.
Do not use mist blower around
sparks, ame, or smoke. Failure
to adhere to these instructions
may cause ignition, resulting in
potential injury and damage to
property.
• To reduce the risk of re, personal
injury, and product damage from
a short circuit, never immerse
the mist blower, battery, or
charger in uids. Do not place
or store mist blower where it
could fall or be pulled into a tub
or sink. Corrosive or conductive
uids, such as seawater, certain
industrial chemicals, and bleach
or bleach containing products,
etc., can cause a short circuit.
• Electric shock hazard: Never
spray toward electrical outlets.
• Spray area must be well ventilated
to avoid hazardous fume build-
up. Always refer to the product
label of the chemical being used
for safety instructions and proper
use practices.
• Avoid spraying on windy days.
Spraying in windy conditions
could cause chemicals to be
blown onto persons, plants, or
objects that are not intended to
be sprayed.
