FlowCon AHU Wafer Manual del propietario

INSTALLATION AND OPERATION INSTRUCTION











AUTOMATIC BALANCING VALVE

WITH PRE-SET INSERT

FlowCon AHU Wafer 50-80mm

1W95000 - 04/2016

FlowCon International assumes no responsibility

for mistakes, if any, in any printed material.

Denmark Dubai USA Singapore www.owcon.com

- 1 -

FlowCon AHU Wafer 50-80mm, 2”-3”

Figure 1

Install the FlowCon AHU Wafer as called

for in the design drawings. INSTALL THE AHU

WAFER HOUSING WITH THE FLOW DIREC-

TIONAL ARROW POINTING IN THE CORRECT

DIRECTION.

The FlowCon AHU Wafer (Model Nos.

F386.X.X.B) is available for end connections of

DIN steel flanges from PN10 and up. For valve

sizes 2½” and 3” ANSI steel flanges from class

150 and up are available and for size 2” ANSI

steel flanges class 300 are to be used. Flanges

are not supplied by FlowCon.

Extended pressure/temperature fittings (p/t

plugs) are included as standard. Before finger

mounting the p/t plugs in the body tappings, pls.

seal the threads of the p/t plugs (DO NOT OVER

TIGHTEN).

Inserting the insert:

For FlowCon AHU Wafer bodies size DN50-

DN80 (figure 1), a 3” stainless steel insert (either

standard flow or high capacity) is available. It is

recommended that the o-ring located around the

insert is lubricated with silicone grease, before

the insert is installed into the valve body.

IMPORTANT:

Never use mineral oil or petrol based grease or

oil on the o-ring.

When inserting the insert, be assured to check

the placement of the o-ring. There is no need to

use tools - the insert can be inserted/removed

by the fingers. Once the insert is installed in the

valve body, the retainer clip is fitted to hold the

insert in proper place.

Assembly drawing

FlowCon AHU Wafer

AHU Wafer housing

O-ring

3” Stainless steel insert (optional)

Retainer clip

Extended p/t plug (2 pcs.).







AUTOMATIC BALANCING VALVE

WITH PRE-SET INSERT

FlowCon AHU Wafer 50-80mm

1W95000 - 04/2016

FlowCon International assumes no responsibility

for mistakes, if any, in any printed material.

Denmark Dubai USA Singapore www.owcon.com

- 2 -

Figure 2

Installation drawing

FlowCon AHU Wafer

Assembly of wafer housing

Flange (not supplied by FlowCon)

Studs (available upon request)

Nuts (available upon request)

General

Water must always be suitable treated, clean and

free of debris. It is recommended that a strainer

be installed prior to the valve body to prevent

damage or blockage due to debris, strainers are

not supplied by FlowCon.

Warranty obligation

Failure to abide by all recommendations as per

this installation and operation instruction will void

warranty.

For latest updates please see www.flowcon.com

AUTOMATIC BALANCING VALVE

WITH PRE-SET INSERT

FlowCon AHU Wafer 50-80mm

1W95000 - 04/2016

FlowCon International assumes no responsibility

for mistakes, if any, in any printed material.

Denmark Dubai USA Singapore www.owcon.com

- 3 -

l/sec l/hr GPM

Type 1 Type 2 Type 4 Type 8

10-135

kPaD

22-210

kPaD

40-390

kPaD

90-880

kPaD

0.883 3180 14.0 F324135

1.01 3630 16.0 F324140

1.10 3970 17.5 F324235

1.14 4090 18.0 F324145

1.26 4540 20.0 F324150 F324240

1.39 5000 22.0 F324155

1.42 5110 22.5 F324245

1.47 5300 23.3 F324435

1.51 5450 24.0 F324160

1.58 5680 25.0 F324250

1.64 5910 26.0 F324165

1.68 6060 26.7 F324440

1.73 6250 27.5 F324255

1.77 6360 28.0 F324170

1.89 6810 30.0 F324175 F324260 F324445

2.02 7270 32.0 F324180

2.05 7380 32.5 F324265

2.10 7570 33.3 F324450

2.15 7720 34.0 F324185

2.21 7950 35.0 F324270 F324835

2.27 8180 36.0 F324190

2.31 8330 36.7 F324455

2.37 8520 37.5 F324275

2.40 8630 38.0 F324195

2.52 9080 40.0 F3241100 F324280 F324460 F324840

2.65 9540 42.0 F3241105

2.68 9650 42.5 F324285

2.73 9840 43.3 F324465

2.78 9990 44.0 F3241110

2.84 10200 45.0 F324290 F324845

2.90 10400 46.0 F3241115

2.94 10600 46.7 F324470

3.00 10800 47.5 F324295

3.03 10900 48.0 F3241120

3.15 11400 50.0 F3241125 F3242100 F324475 F324850

3.28 11800 52.0 F3241130

3.31 11900 52.5 F3242105

3.36 12100 53.3 F324480

3.41 12300 54.0 F3241135

3.47 12500 55.0 F3242110 F324855

3.53 12700 56.0 F3241140

3.58 12900 56.7 F324485

3.63 13100 57.5 F3242115

3.66 13200 58.0 F3241145

3.79 13600 60.0 F3241150 F3242120 F324490 F324860

3.94 14200 62.5 F3242125

4.00 14400 63.3 F324495

4.10 14800 65.0 F3242130 F324865

4.21 15100 66.7 F3244100

4.26 15300 67.5 F3242135

4.42 15900 70.0 F3242140 F3244105 F324870

Accuracy ±5%

l/sec l/hr GPM

Type 1 Type 2 Type 4 Type 8

10-135

kPaD

22-210

kPaD

40-390

kPaD

90-880

kPaD

4.57 16500 72.5 F3242145

4.63 16700 73.3 F3244110

4.73 17000 75.0 F3242150 F324875

4.84 17400 76.7 F3244115

5.05 18200 80.0 F3244120 F324880

5.26 18900 83.3 F3244125

5.36 19300 85.0 F324885

5.47 19700 86.7 F3244130

5.68 20400 90.0 F3244135 F324890

5.89 21200 93.3 F3244140

5.99 21600 95.0 F324895

6.10 22000 96.7 F3244145

6.31 22700 100 F3244150 F3248100

6.62 23800 105 F3248105

6.94 25000 110 F3248110

7.26 26100 115 F3248115

7.57 27300 120 F3248120

7.89 28400 125 F3248125

8.20 29500 130 F3248130

8.52 30700 135 F3248135

8.83 31800 140 F3248140

9.15 32900 145 F3248145

9.46 34100 150 F3248150

Accuracy ±5%

l/sec l/hr GPM

Type 1 Type 2

28-135 kPaD 55-210 kPaD

5.68 20400 90.0 F3241220

6.94 25000 110 F3241270 F3242220

8.20 29500 130 F3241320

8.52 30700 135 F3242270

10.1 36300 160 F3242320

Accuracy ±5%

Stainless Steel Insert

for DN50/65/80, 2”-3”

(3” insert, standard flow)

Stainless Steel Insert

for DN50/65/80, 2”-3”

(3” insert, standard flow)

Stainless Steel Insert

for DN50/65/80, 2”-3”

(3” insert, st. flow, hi. capacity)

AUTOMATIC BALANCING VALVE

WITH PRE-SET INSERT

FlowCon AHU Wafer 50-80mm

1W95000 - 04/2016

FlowCon International assumes no responsibility

for mistakes, if any, in any printed material.

Denmark Dubai USA Singapore www.owcon.com

- 4 -

Otros manuales de Unidad de control de FlowCon

FlowCon

FlowCon DPCV Manual del propietario

FlowCon

FlowCon S-JUST Manual del propietario

FlowCon

FlowCon SM.1.1 Manual del propietario

FlowCon

FlowCon Green Manual del propietario

FlowCon

FlowCon SM 50-250mm Manual del propietario

FlowCon

FlowCon UniQ Manual del propietario

FlowCon

FlowCon FlowCon Green Series Manual del propietario

FlowCon

FlowCon Green.3 Series Manual del propietario

FlowCon

FlowCon ABM Manual del propietario

FlowCon

FlowCon Green.3 DN40 Manual del propietario

FlowCon

FlowCon PIM-DP Manual de usuario

FlowCon

FlowCon Green Manual del propietario

FlowCon

FlowCon SM.3.0 Manual de usuario

FlowCon

FlowCon SH series Manual del propietario

FlowCon

FlowCon EVS Manual de usuario

Manuales populares de Unidad de control de otras marcas

Festo

Festo Compact Performance CP-FB6-E Manual de lista de piezas

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manual de usuario

JS Automation

JS Automation MPC3034A Manual de usuario

JAUDT

JAUDT SW GII 6406 Series Guía rápida

Spektrum

Spektrum Air Module System Manual de usuario

BOC Edwards

BOC Edwards Q Series Manual de usuario

KHADAS

KHADAS BT Magic Manual de usuario

Etherma

Etherma eNEXHO-IL Manual de usuario

PMFoundations

PMFoundations Attenuverter Manual de usuario

GEA

GEA VARIVENT Manual de usuario

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manual de usuario

Altronix

Altronix LINQ8PD Instrucciones de montaje

Eaton

Eaton Powerware Series Manual de usuario

WAGO

WAGO 750-407/040-000 Manual de usuario

Sony

Sony CCU-590 Manual de usuario

Graco

Graco 25D614 Manual de usuario

Task Force Tips

Task Force Tips YE-RF-900 Manual de programación

Shini

Shini SPV-U Series Manual de usuario