change the hour setting.
1. Press <PRG>, the minutes will flash, press < >, < >
to change the minutes setting.
2. Press <PRG>, temperature will flash, press < >, < >
to change the set point.
4. Press <PRG> to set the next program.
5. The program setting sequence is as below:
Mon~Fri (P1P2P3 P4P5P6)Sat (P1
P2P3 P4P5P6)Sun (P1P2P3
P4P5P6)…
6. Press < > to exit the program setting mode and
return to the normal mode.
Or transmitter will auto-return to normal mode after 10
seconds.
Temporary / Permanent Override Mode:
1. There are two modes in the override mode (Temporary
override and Permanent override mode).
The sequence is as below:
NormalTemporary Override Permanent
OverrideNormal…
9
3. Slide the battery drawer back to its position.
4. Check if the thermostat works properly or not. Press
“Reset” if necessary.
Start/Reset:
1. After wiring and mounting, switch off all the connected
devices. Place 2 new AAA 1.5V alkaline batteries
according to the polarities marked.
LCD display will be switched on.
2. Press ‘RST’ to reset. The thermostat will be ready to
control the heater / cooler.
Normal Time Mode:
1. Temperature detection starts and LCD displays the
room temperature.
2.If Battery is LOW, will be flashing. The old
batteries must be replaced with new ones immediately.
3.Defrost function is activated with displayed when
temperature is 5°C or below. Output will be forced to
ON @ Heat & OFF @ Cool.
4.Below 0°C, transmitter will display LO.
5.Above 40°C, transmitter will display HI.
6
