Training options
Extinguisher training
Extinguishers Tab
The FLAIM Extinguisher system has three
different training options - Extinguisher Training,
Experience, PVStop.
Option 1:
Extinguisher Training teaches users how to
use an extinguisher – giving three choices of
extinguisher type. For example: The Warehouse
Pallet scenario.
Option 2:
Experience is for observation learning. The user
will not have any extinguisher choices. For
example: The Aircraft Engine scenario.
Option 3:
PVStop teaches users how to use PVStop to
negate the electricity output of solar panels.
If you are in an Extinguisher Training scenario
(Option 1 scenarios) - extinguishers will be
located nearby (Figure 13).
To run this training option, follow the steps below:
1. Select an extinguisher, it will then appear in
the user’s hand.
2. The user should press the trigger or
top button on the controller to use the
extinguisher.
The scenario will end when the user runs out of
suppressant or the fire is extinguished.
You will then have the option to return to lobby
or restart.
Select the Extinguishers Tab (Figure 14) to learn
about the various types of extinguishers and their
role in fire suppression.
Virtual extinguishers will appear in front of the
user. Aim the controller laser at one, it will highlight
the information about its role in fire suppression.
Figure 11: Extinguishers in Extinguisher
Training scenarios
Figure 12: Extinguishers Tab (next to the
Scenarios Tab)
Technique Tab
Info Tab
The Technique Tab (Figure 15) walks users through the extinguisher PASS technique.
Ie: Pull the pin, Aim at the base of the fire, Squeeze the handle and Sweep from left to
right.
To see the next step - switch pages using the right arrow.
The Information (info) button is found at the top right of the screen (next to the video
connection button).
The Info button shows the current software version as well as FLAIM System’s website
address: flaimsystems.com
Figure 13: Technique Tab (next to the Extinguishers Tab)
1615
