VC300 Pneumatic Valve Controller Operating Manual
© 2021 Fisnar - 9 - VC300 Rev 01
2A. Digital Display
Screen
In MANUAL mode, when the foot pedal switch or shot button is pressed
or an external machine actuation input signal is received, the dispense
valve will be actuated to start dispensing fluid. The machine will also
begin counting up from 0.000 seconds.
When the foot pedal switch or shot button is released or an external
machine actuation input signal is removed, the dispense valve will stop
being actuated and dispensing of fluid will stop. The machine will display
and hold the dispense cycle time until the next actuation cycle.
When the foot pedal switch or shot button is pressed again or an external
machine actuation input signal is received again, the timer will
automatically reset and start counting up from 0.000 seconds, and the
dispense valve will be actuated to start dispensing fluid again.
When in TIMED mode, the saved dispense time (seconds) will be
displayed. When the foot pedal switch or shot button is pressed or an
external machine actuation input signal is received, the dispense valve
will be actuated to start dispensing fluid. The machine will also begin
counting up from 0.000 seconds until it reaches the saved dispense time.
Once the saved dispense time has been reached, the dispense valve
will stop being actuated and dispensing of fluid will stop. The machine
will display and hold the dispense cycle time until the next actuation
cycle.
One (1) individual program is saved to the machine and automatically
recalled when the machine is powered back on.
When in CYCLE mode, the saved dispense time (seconds) will be
displayed. When the foot pedal switch or shot button is pressed or an
external machine actuation input signal is received, the dispense valve
will be actuated to start dispensing fluid. The machine will also begin
counting up from 0.000 seconds until it reaches the saved dispense time.
Once the saved dispense time has been reached, the dispense valve
will stop being actuated and dispensing of fluid will stop. The machine
will then automatically start counting down from the time set in the “P00.
Auto Cycle Stop” function setting to 0.000 seconds.
Once the machine has counted down to 0.000 seconds, the dispense
valve will automatically be actuated to start dispensing fluid again. The
machine will also automatically begin counting up from 0.000 seconds
until it reaches the saved dispense time.
This looping cycle will continue to be repeated until the foot pedal switch
or shot button is pressed again or an external machine actuation input
signal is received again.
