Fisher & Paykel Active Smart Manual de usuario

ACTIVESMART™

INTEGRATED REFRIGERATOR

RS36W and RS91W Models

FRAMED AND FRAMELESS CABINETRY

DUAL INSTALLATION GUIDE

NZ AU GB IE HK SG IN US CA

FOLLOW THE INSTALLATION SEQUENCE

1 Safety and warnings 3

2 Dual Installation 3

3 Components list 4

4 Alcove dimensions 5

5 Attaching foam pads 5

6 Removing hinge bracket and fitting alcove bracket 6

7 Attaching top joiner bracket and alcove fixing bracket to alcove 7

8 Location of products into alcove — Right product 8

9 Location of products into alcove — Left product 9

!0 Preparing for centre trim 10

!1 Attaching the centre trim and toe kick 11

1SAFETY AND WARNINGS

Dual installation refers to the joining of 1 x RS91WR model with 1 x RS91WL model or

1 x RS36WR model with 1 x RS36WL model.

2DUAL INSTALLATION

RS91WR MODELS RS91WL MODELS

RS91WRJ FP RS91WLJ FP

RS91WRU FP

RS36WR MODELS RS36WL MODELS

RS36W80RJ FP RS36W80LJ FP

RS36W80RU FP

RS36WRJC DCS RS36WLJC DCS

RS36WRUC DCS

This booklet refers to left hinge and right hinge products.

IMPORTANT!

 Each refrigerator requires a water supply and shut off valve. Use a solid brass type splitter

if both refrigerators are supplied from the one water supply.

 Ensure the dual power outlet is suitable for two right angled plugs.

 Extension cords should not be used in the dual installation.

IMPORTANT!

For correct and complete installation of your refrigerator(s) follow the ‘Installation

guide’ booklet supplied with your refrigerator. This booklet is supplementary providing

instructions which are unique to dual installation.

!WARNING!

This appliance is top-heavy and must

be secured to prevent the possibility of

tippingforward.

To ensure that the appliance is stable under

all loading conditions, theanti-tip bracket and

fittings supplied must be installed according

tothe following installation instructions by a

professional installer.

IMPORTANT!

SAVE THESE INSTRUCTIONS

The models shown in this installation guide may not be available in all markets and are subject to change at any time. For current details about model and specification availability in your country, please go to

our website www.fisherpaykel.com or www.dcsappliances.com or contact your local Fisher & Paykel dealer.

3COMPONENTS LIST

Included with the Dual Install kit.

Alcove fixing bracket

(1)

Joiner bracket

(1)

Left hinge refrigerator

alcove bracket

(1)

Right hinge refrigerator

alcove bracket

(1)

Foam pads

(6)

Spring clips (provided with

the appliance)

(6)

Centre trim

(1)

Bottom joiner bracket

(1)

M8 nut

(1)

M8 Nut

M8 set screw

(1)

M8 Screw Set

M5 x 12 Socket head cap screw

(11)

M5 x 12 SHCS

(Socket Head Cap Screw)

M5 x 12 SHCS

(Socket Head Cap Screw)

#8 x 16 mush

washer screw

(5)

#8 x 16

Mush Washer

Twin Thread

Philips Screw

#8 x 16

Mush Washer

Twin Thread

Philips Screw

Toe kick

(1)

4ALCOVE DIMENSIONS

1Measure and attach foam pads to three locations down the right side of the left hinge

refrigerator. (Align the top of the foam pad to your measurement mark. Align the side of the

foam pad with the front edge of the cabinet).

 2” (50mm) from the cabinet top.

 35” (890mm) from the cabinet top.

 13” (50mm) from the floor.

Repeat on the left side of the right hinge product.

IMPORTANT!

Foam pads should be placed at identical heights on left and right hinge refrigerators to

ensure good fit of joiner trim.

2” (50mm)

35” (890mm) 13” (50mm)

ALCOVE DIMENSIONS inches (mm)

AOverall height of alcove 84” (2134)

BOverall width of alcove 72” (1829)

5ATTACHING FOAM PADS

6REMOVING HINGE BRACKET AND FITTING ALCOVE BRACKET

Fitting alcove bracket

4Screw the front two M5x8 countersunk Phillips screws (refer to C). Check that the top face

of the front trim is parallel to the refrigerator.

5Shift M5x10 pan head Phillips trim attachment screws into the slots in the alcove bracket,

(refer to D).

–If the front trim is not parallel to the refrigerator, screw the jacking screw supplied:

M5x12 Socket head cap screw (refer to E) to adjust the trim position.

6When the front trim is parallel to the refrigerator, secure the alcove bracket with the third

countersunk screw (refer to F).

Removing hinge bracket

Follow the steps below to remove the hinge bracket (non hinged side) and fit the alcove

bracket. This process is required for both left and right hinge refrigerators.

<1/4” (<6mm)

Top trim

1Ensure the distance between the end of the top trim and the side of the cabinet is not

greater than 1/4” (6mm). If distance is greater than 1/4” (6mm), loosen the pan head Phillips

screws at the back of the trim and shift the trim sideways to suit.

2On the right hand side (when facing the front side of the refrigerator), loosen the M5 x 10

pan head Phillips top trim attachment screws. Shift screws towards the centre of the trim,

(refer to A).

3Remove the right hinge bracket from the left hinge refrigerator by unscrewing the

countersunk Phillips head screws with a Phillips head screwdriver (refer to B).

Repeat process of removing hinge bracket and fitting alcove bracket on the right

hinge refrigerator.

Start with the left hinge refrigerator and repeat the process on the right hinge refrigerator.

Refrigerator front side

7ATTACHING TOP JOINER BRACKET AND ALCOVE FIXING BRACKET TO ALCOVE

1Use M5x12 Socket head cap screws to connect the top joiner bracket to the alcove

fixingbracket.

– For 80” (2032mm) installation, use the upper slots of the alcove fixing bracket (refer to A).

– For 84” (2134mm) installation, use the lower slots of the alcove fixing bracket (refer to B).

2Measure the width of your alcove. Mark a line in the centre of the cavity, on the ceiling.

3For flush installation measure 11/4” (108mm) back from the front face of the adjacent

cabinetry doors (refer to C).

– Face1 should be 41/4” (108mm) back.

– Face 2 should be lined up with the centre of the alcove.

For proud installation, the joiner bracket should sit forward. Measure 11/4” (108mm) - x

back from the front face of the adjacent cabinetry doors (refer to C).

– Face 1 should be 11/4” (108mm) - x (x = distance the product sits proud).

– Face 2 should be lined up with the centre of the alcove.

Using #8 x 16 mush washer screws (4), align and fix the joiner bracket to the centre of the

alcove (refer to D). (Loosely fix the screws the centre of each slot to enable adjustment in

the joiner bracket).

WARNING!

Ensure anti tip brackets are fitted at this stage (refer to separate ‘Installation guide’

booklet supplied with your refrigerator).

IMPORTANT!

Door panels must be fitted to doors at this stage (refer to separate ‘Installation guide’

booklet supplied with your refrigerator).

WARNING!

Do not open doors.

SCALE 1:10

84” (2134mm)

72” (1829mm)

At this stage, connect to water and electrical supply as per the ‘Installation guide’ booklet

supplied with your refrigerator.

WARNING!

Failure to follow the instructions can lead to serious injury or death.

41/4” (108mm) = flush installation

41/4” (108mm) - x = proud installation

Face 1

Face 2

41/4” (108mm) = flush installation

41/4” (108mm) - x = proud installation

8LOCATION OF PRODUCTS INTO ALCOVE — RIGHT PRODUCT

1Roll the right hinge refrigerator into the right hand side of the alcove until the refrigerator

makes contact with the joiner bracket.

IMPORTANT!

For flush installation: check for flushness of the refrigerator with the surrounding

cabinetry (refer to separate ‘Installation guide’ booklet supplied with your refrigerator)

on how to achieve flushness.

2Adjust the refrigerator height (refer to separate ‘Installation guide’ booklet supplied with

your refrigerator).

3Screw two M5 x 12 Socket head cap screws to connect the alcove bracket to the joiner

bracket (refer to A).

4If the refrigerator is not flush, further loosen the top screws of the alcove attachment

bracket if required and move the bracket in a forward to back motion to suit (refer to B).

5Recheck refrigerator flushness (refer to separate ‘Installation guide’ booklet supplied with

your refrigerator). Once satisfied with flushness, tighten top screws fix an additional

#8 x 16 mush washer screw (refer to C).

SCALE 1:10

SCALE 2:5

Otros manuales para Active Smart

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Refrigerador de Fisher & Paykel

Fisher & Paykel

Fisher & Paykel ACTIVESMART RS32A72 Manual de usuario

Fisher & Paykel

Fisher & Paykel RS6019S2 Manual de usuario

Fisher & Paykel

Fisher & Paykel ACTIVESMART RS80A Manual de usuario

Fisher & Paykel

Fisher & Paykel RS6121SLK1 Manual de usuario

Fisher & Paykel

Fisher & Paykel ActiveSmart RS80AU1 Manual de usuario

Fisher & Paykel

Fisher & Paykel RB2470BRV Manual de usuario

Fisher & Paykel

Fisher & Paykel E522BLE4 Manual de usuario

Fisher & Paykel

Fisher & Paykel CoolDrawer RB90S64MKIW1 Manual de usuario

Fisher & Paykel

Fisher & Paykel RS2484S Manual de usuario

Fisher & Paykel

Fisher & Paykel RS6121W Manual de usuario

Fisher & Paykel

Fisher & Paykel RF610ADW4 Manual de usuario

Fisher & Paykel

Fisher & Paykel ACTIVESMART RF605QDUVX1 Manual de usuario

Fisher & Paykel

Fisher & Paykel ActiveSmart RF135 Instrucciones de montaje

Fisher & Paykel

Fisher & Paykel ACTIVESMART RF500QNUB1 Manual de usuario

Fisher & Paykel

Fisher & Paykel ActiveSmart E372B Manual de usuario

Fisher & Paykel

Fisher & Paykel RS2484SLK1 Manual de usuario

Fisher & Paykel

Fisher & Paykel RS4621FRJK2 Manual de usuario

Fisher & Paykel

Fisher & Paykel DCS ActiveSmart RS36W80 Manual de usuario

Fisher & Paykel

Fisher & Paykel RS6121SRK1 Manual de usuario

Fisher & Paykel

Fisher & Paykel E402BRX4 Manual de usuario

Fisher & Paykel

Fisher & Paykel ActiveSmart E402B Instrucciones de montaje

Fisher & Paykel

Fisher & Paykel ActiveSmart RF135B Manual de servicio

Fisher & Paykel

Fisher & Paykel ActiveSmart E402B Manual de usuario

Fisher & Paykel

Fisher & Paykel ActiveSmart E402B Instrucciones de montaje

Manuales populares de Refrigerador de otras marcas

Bonnet Neve

Bonnet Neve SKYVIEW PLUS Manual de usuario

Zanussi Electrolux

Zanussi Electrolux ZERB 8441 Manual de usuario

Sharp

Sharp SJ-BA31IEXW2-EU Manual de usuario

CORBERO

CORBERO CC2300MCW Manual de usuario

KitchenAid

KitchenAid 2205264 Manual de usuario

Stengel

Stengel KU 1101 A++ Manual de usuario

NEFF

NEFF KI181 Series Manual de usuario

Hoshizaki

Hoshizaki Reach-In Manual de usuario

Amana

Amana ASD2524VES00 Manual de usuario

BOMANN

BOMANN KGC 213 Manual de usuario

Danby

Danby DAR044A1SLDD Instrucciones de montaje

Samsung

Samsung RF323TE Manual de usuario

Beko

Beko CSA31022 Manual de usuario

IKEA

IKEA FROSTIG C 185 E Manual de usuario

Electrolux

Electrolux ER 6821 D Manual de usuario

True

True TS-28 Manual de usuario

Frigidaire

Frigidaire FSC23R5DW9 Manual de usuario

Beko

Beko LSP4579W Manual de usuario