First Data FD 150 Manual de usuario
paystri.com | Paystri Support: 978-744-9090
First Data FD 150 Terminal Setup Guide
In the Box
The First Data FD 150 terminal comes with all the parts listed below.
Connect the Terminal
Before anything else, connect the FD 150 via ethernet and / or telephone line.
The terminal requires a connection to be able to run transactions and communicate
with the processor.
1. Remove the cover from the bottom of the device.
LAN Ethernet Cable
paystri.com | Paystri Support: 978-744-9090
2. Plug an ethernet cable into the yellow port and / or a phone cable into the blue port.
3. Plug the other end of the ethernet cable into an open port on the router or modem.
If using a telephone line, connect the other end of the phone cable into a wall jack
preferably not being shared with another device.
4. Connect the two parts of the power cable.
5. Plug the power cable into the power adapter port on the side and
replace the back cover.
paystri.com | Paystri Support: 978-744-9090
6. Lift the hatch to open the paper tray.
7. Drop the paper into the printer tray with the leading edge feeding down from the
bottom of the roll.
8. With the end of the paper sticking out, close the lid on the paper.
9. Plug the power cord into a power outlet and the terminal will automatically
turn itself on. The terminal is ready to process transactions when the screen
displays SWIPE OR INSERT CARD.
Otros manuales para FD 150
2
Tabla de contenidos
Otros manuales de Terminal táctil de First Data
First Data
First Data EFTPOS Manual de usuario
First Data
First Data VeriFoneVX820 Duet Manual de usuario
First Data
First Data RP10 Manual de usuario
First Data
First Data VeriFone VX810 Duet Manual de usuario
First Data
First Data FD130 Manual de usuario
First Data
First Data FD100 Manual de usuario
First Data
First Data FD130 Manual de usuario
First Data
First Data FD100 Instrucciones de montaje
First Data
First Data FD130 Manual de usuario
First Data
First Data verifone vx 670 Manual de usuario
