9
General safety instructions
13
OPERATING INSTRUCTIONSELECTRICAL CIRCULAR SAW
ENGeneral safety instructions
Always lower the jack slowly.
DO NOT USE THE JACK TO SUPPORT OR STABILIZE A LOAD.
Using the jack to support or stabilize a load may result in unexpected
movement and result in serious injury, being crushed and death. Always
securely chock and block (stabilize) the load to be lifted. Never place any
part of the body under a raised load without properly chocking and
supporting the load.
Never use the jack on curved or tubular vehicle
Bumpers, this will result in the vehicle slipping off the jack and falling, causing
serious injury or death. Use a bumper lift to lift most vehicles with curved
bumpers or plastic bumpers.
Wear ANSI-approved safety glasses and heavy-duty work gloves during use.
Do not adjust the safety valve.
Do not move or dolly vehicle while jack is in use.
Stay alert. Use caution and common sense when operating jack. Do not use a
jack when tired, incoherent, dizzy, under the use or drugs or alcohol.
Training
Read this manual before use. Do not allow anyone who has not read this
manual, and/or does not understand the requirements, to use the jack.
Spectators
Do not allow bystanders around the jack or under the load supported only by
the jack. -Do not allow anyone in the vehicle while the jack is in use. Keep all
bystanders away from vehicle when in use.
Inspection
Inspect the jack carefully before each use. Ensure the jack is not damaged,
excessively worn, or missing parts. -Do not use the jack unless it is properly
lubricated. -Using a jack that is not in good clean working condition or
properly lubricated may cause serious injury.
Additional Notes:
Save the receipt, warranty and these instructions.
Do not modify the jack in any way. Unauthorized modification may impair the
function and/or safety and could affect the life of the equipment. There are
specific applications for which the jack was designed.
Always check for damaged or worn out parts before using the jack. Broken
parts will affect the equipment operation. Replace or repair damaged or
worn parts immediately.
When jack is not in use, store it in a secure place out of the reach of children.
Inspect it for good working condition prior to storage and before re-use.
Center Load on Jack Saddle
Center load on jack saddle before lifting vehicle.
Off-center loads and loads lifted when the jack is not level can cause loss of load
or damage to the jack.
Do not raise or lower the vehicle unless tools, materials and people are clear.
When the lift is being lowered, make sure everyone is standing at least six feet
away. Be sure there are no tools or equipment left under or around the jack
before lowering.
HYDRAULIC FLOOR JACK
