7
Safety instructions for all operations
Safety Warnings common for grinding, sanding, wire brushing, polishing,
carving or abrasive cutting-o operations:
a) This power tool is intended to function as a grinder, sander, wire brush,
polisher, carving or cut-o tool. Read all safety warnings, instructions,
illustrations and specications provided with this power tool.
Failure to
follow all instructions listed below may result in electric shock, re and/or
serious injury.
b) Operations such as polishing is not recommended to be performed
with this power tool.
Operations for which the power tool was not
designed may create a hazard and cause personal injury.
c) Do not use accessories which are not specically designed and
recommended by the tool manufacturer.
Just because the accessory can
be attached to your power tool, it does not assure safe operation.
d) The rated speed of the grinding accessories must be at least equal to
the maximum speed marked on the power tool.
Grinding accessories
running faster than their rated speed can break and y apart.
e) The outside diameter and the thickness of your accessory must
be within the capacity rating of your power tool.
Incorrectly sized
accessories cannot be adequately controlled.
f) The arbour size of wheels, sanding drums or any other accessory must
properly t the spindle or collet of the power tool.
Accessories that do
not match the mounting hardware of the power tool will run out of balance,
vibrate excessively and may cause loss of control.
g) Mandrel mounted wheels, sanding drums, cutters or other accessories
must be fully inserted into the collet or chuck.
If the mandrel is
insuciently held and/or the overhang of the wheel is too long, the
mounted wheel may become loose and be ejected at high velocity.
h) Do not use a damaged accessory. Before each use inspect the accessory
such as abrasive wheels for chips and cracks, sanding drum for cracks,
tear or excess wear, wire brush for loose or cracked wires. If power tool
or accessory is dropped, inspect for damage or install an undamaged
accessory. After inspecting and installing an accessory, position
yourself and bystanders away from the plane of the rotating accessory
and run the power tool at maximum no-load speed for one minute.
Damaged accessories will normally break apart during this test time.
