Always orient the solar panel with the connection cable box facing upwards!
·2 pcs M10 × 120 mm screw
·2 pcs M10 wing nut
2. 40W panel (Art.No. 8145) – console (Art.No. 8185)
for mounting post (Art.No. 8183)
Required material:
• 2 pcs horizontal console
• 1 pc vertical console left
• 1 pc vertical console right
• 12 pcs M5 × 14 mm screw
• 12 pcs M5 nut
• 24 pcs M5 washer
• 2 pcs M10 × 120 mm screw
• 2 pcs M10 wing nut
Console assembling – chapter 1.1
Solar panel mounting – chapter 1.2
2.1 Mounting to the mounting post
For mounting on the mounting post use a solar panel with a console. Panel with
console (for box portable Art.No. 8150) place on a mounting post screwed into the
ground so that the console is between the sides of the mounting post, secure the
panel in the marked holes, through both sides of the mounting post and both vertical
parts of the console with an M10 × 120 mm screw and an M10 wing nut. To secure
tilt of the panel, t a second M10 × 120 mm screw and an M10 wing nut, according
to drawing. The screws must pass through all parts of the console and the mounting
post.
6
