Last Check
PLACEMENT OF THE BBQ
•Ensure that the barbecue is placed at least 150 cm in all directions from house
walls, trees, plants and other flammable materials or liquids when in use.
•Do not place the barbecue under a roof or overhang.
•Make sure that the barbecue is placed in a well-ventilated place to avoid carbon
monoxide poisoning.
•The barbecue must not be used below normal ground level, as this can lead to an
explosion hazard and a risk of lack of oxygen.
FINAL CHECK
•Check that the control knobs work
normally.
•Check that the gas hose is free of
cracks and damage (it should always
be done before using the barbecue).
•Check that the gas cylinder and hose
do not come into contact with hot
objects.
GOOD ADVICE
•KEEP THE BARBECUE CLEAN.
A clean barbecue gives better effect,
less smoke, less irregular flames and
reduces the risk of fat burning.
•PREHEAT THE BARBECUE for
10-15 minutes at maximum temperature.
After preheating, adjust the controls
according to the type of grilling and the
desired grilling result. Using too much
heat can result in burnt and overcooked
food.
LIGHTING INSTRUCTIONS
1. Set all control knobs to off (red bar pointing upwards).
2. Open the lid. The lid must always be open when lighting the barbecue.
3. Open the gas valve of the gas cylinder.
4. Push the knob of the desired burner in and turn it to the left. The
burner will ignite automatically.
5. Wait until the burner is lit, then the next burned may be lit with the
same procedure.
Ignite the rest of the burners the same way as needed.
TIPS: Preheat the barbecue for about 10-15 minutes on maximum
temperature. After completion of preheating, turn all burners to the “LO“
position for best cooking results.
If the burners do not ignite after 5 seconds, set all control knobs to off
(red bar pointing upwards) and close the gas valve of the gas cylinder. Wait
for 5 minutes. Repeat the above procedure.
MANUAL LIGHTING
If the electric ignitor of the appliance does not work or you like to light the
appliance manually using a long match or a fireplace lighter:
Do not lean over the barbecue while lighting!
1. Set all control knobs to off (red bar pointing upwards).
2. Open the lid.
3. Open the gas valve of the gas cylinder.
4. Light a long match and enter it into the burner
ports on the left or right sidewall of the firebox.
5. Push the control knob of the adjacent burner in,
and turn it to the left.
6. Make sure the burner lights and stays lit.
7. Adjacent tube burners can be lighted by pushing
their knobs in and turning them to the left.
If the burners do not ignite after 5 seconds, set all
control knobs to off (red bar pointing upwards) and close the gas valve of
the gas cylinder. Wait for 5 minutes. Repeat the above procedure.
Lighting Instructions
●IF THE BURNER DOES NOT IGNITE, TURN THE SWITCHES TO THE OFF POSITION
(CLOSE THE GAS SUPPLY) AND WAIT 5 MINUTES BEFORE TRYING TO IGNITE AGAIN.
●IF THE BARBECUE STILL DOES NOT LIGHT WITH NORMAL OR MANUAL METHOD,
READ THE TROUBLESHOOTING TABLE OR CONTACT YOUR DEALER.
!
1918 fccbbq.com
