Fantom FC285H Manual de usuario

REPLACEMENT PARTS

IMPORTANT SAFETY INSTRUCTIONS

NAMES OF EACH PART

PREPARATION BEFORE USE

USING THE VACUUM CLEANER

USING THE ATTACHMENTS

EMPTYING THE DUST COMPARTMENT

CLEANING THE FILTERS

CLEARING BLOCKAGES IN THE

SUCTION HOSE AND CLEANING THE

AGITATOR ASSEMBLY

REPLACEMENT INSTRUCTIONS

TROUBLESHOOTING

LIMITED WARRANTY

Contents

FC285H

INSTRUCTION MANUAL

VACUUM CLEANER

HOUSEHOLD AND COMMERCIAL USE

FILTER SENSOR 16

IMPORTANT SAFETY INSTRUCTIONS

When using an electrical appliance, basic precautions should always be

followed, including the following.

READ ALL INSTRUCTIONS

BEFORE USING THIS VACUUM CLEANER

WARNING -To reduce the risk of fire, electric shock or injury:

1. Do not leave the vacuum cleaner when plugged in. Unplug it from the outlet

when not in use and before servicing.

2. Do not use outdoors or on wet surfaces.

3. Do not allow vacuum cleaner to be used as a toy. Close attention is necessary

when used by or near children or infirmed persons.

4. Use only as described in this manual. Use only the manufacturer's

recommended attachments.

6. Do not pull or carry by the cord, use the cord as a handle, close a door on the

cord, or pull the cord around sharp edges or corners. Do not run the vacuum

cleaner over the cord. Keep the cord away from heated surfaces.

7. Do not unplug by pulling on the cord. To unplug, grasp the plug, not the cord.

8. Do not handle the plug or the vacuum cleaner with wet hands.

9. Do not put any objects into the openings. Do not use with any opening

blocked, keep free of dust, lint, hair and anything that may reduce air flow.

10. Keep hair, loose clothing, fingers and all the parts of your body away from

openings and moving parts.

11. Do not pick up anything that is burning or smoking, such as cigarettes,

matches or hot ashes.

12. Do not use without dust compartment and filters in place.

13. Turn off all controls before unplugging.

14. Use extra care when cleaning on stairs.

15. Do not use to pick up flammable or combustible liquids such as gasoline, or

use in areas where they may be present.

5. Do not use with a damaged cord or plug. If the vacuum cleaner is not working

as it should, or if it has been dropped, damaged, left outdoors or dropped into

water, return to FANTOM at 94 Main Mill Street, Door 16, Plattsburgh, NY 12901.

Rev. 02/06

16. Do not touch the agitator while it is spinning.

17. Do not place any heavy items on top of the vacuum cleaner.

18. Do not step on the hose or pull it too strongly.

19. Do not pick up items such as pieces of waste paper or cloth which looks as

though they may cause the hose to become blocked.

20. Do not clean or store the vacuum cleaner in places where there are high

temperatures.

21. Store the vacuum cleaner away from excessive humidity.

22. When carrying the vacuum cleaner, hold it by the carrying handle.

23. Before servicing the vacuum cleaner, allow all internal metal parts to cool first.

25. If the supply cord of this appliance is damaged, it must only be replaced by

FANTOM,because special purpose tools are required.

24. Always place foot on handle release when adjusting the handle position

of the vacuum cleaner.

26. Connect to a properly grounded outlet only. See Grounding Instructions.

SAVE THESE INSTRUCTIONS

This vacuum is intended for household or commercial use.

Note to user concerning attachment plug:

Grounding Instructions

This appliance must be grounded. If it should malfunction or breakdown, grounding

provides a path of least resistance for electric current to reduce the risk of electric shock.

This appliance is equipped with a cord having an equipment-grounding conductor and

grounding plug. The plug must be inserted into an appropriate outlet that is properly

installed and grounded in accordance with all local codes and ordinances.

WARNING- Improper connection of the equipment-grounding conductor can result in a risk

of electric shock. Check with a qualified electrician or service person if you are in doubt as

to whether the outlet is properly grounded. Do not modify the plug provided with the

appliance - if it will not fit the outlet, have a proper outlet installed by a qualified electrician.

This appliance is for use on a nominal 120-volt circuit and has a grounding attachment plug

that looks like the plug illustrated below. Make sure that the appliance is connected to an

outlet having the same configuration as the plug.

Grounding

Grounded

Outlet

WARNING:The power cord on this product contains lead, a chemical known to the State of

California to cause birth defects or other reproductive harm. Wash hands after handling.

Plug shown in figure

may differ from actual

plug attached to unit

for your area.

NAMES OF EACH PART

WARNING:

Operate vacuum cleaner only at the voltage specified on name plate.

FRONT REAR

Set the ON/OFF switch

to " ON " to light the

headlight.

Headlight

Handle

Suction

Hose A

Dust

Compartment

Carrying Handle

Dust Cup Knob ON/OFF Switch

Release

Button B

Suction

Hose B

Filter Cover

Handle Release Lever

Power Cord

Upholstery Tool &

Dusting Brush

Power Cord

Plug

Wand

Hose Holder

Rug/Floor (Tools)

SELECTOR

Cord Storage

Hooks

Duster

Variable Suction

Control

Tool Cover Release

Button A

Crevice Tool

Cleaning Utensil

Extra Hose

Height Adjustment

Lever

Filter Sensor

Handle

Upholstery Tool

& Dusting Brush

Hose Cuff

Suction Inlet

Caution: Do not connect the power cord plug to the wall outlet until assembly

is completed.

Attaching the handle

PREPARATIONS BEFORE USE

Attaching the suction hose A,B & attachments

Set the vacuum cleaner

to the upright position.

lnsert the handle

as shown in the illustration.

Wand

Crevice Tool

Duster

Suction

Hose A

The wand and crevice

tool are contained

together. Insert the

crevice tool as shown.

Suction

Hose B

PREPARATIONS BEFORE USE

THERMAL SAFETY DEVICE IN MAIN BODY

To protect your vacuum cleaner motor from overheating, a thermal safety device has been

built in. If your vacuum cleaner hose or air intake clogs up with dust or dirt, or if your dust

bag becomes full and you continue to run the machine, the vacuum will shut off

automatically to prevent the motor from overheating. If this happens, turn off switch and

disconnect your vacuum from power outlet, remove the material clogging the machine

and let your vacuum cool down for approximately 45 minutes. You can then restart your

vacuum cleaner and use it again.

WINDING THE POWER CORD

Wind the power cord around

the cord storage hooks.

Secure the power

cord plug on the

power cord.

Cord Storage

Hooks

RELEASING THE POWER CORD

Rotate the upper cord

storage hook downward.

Return the hook to the

upright position before

attempting to rewind

the power cord.

Upper Cord

Storage Hook

INSERTING THE POWER CORD PLUG

Insert the power cord plug into the

wall outlet.

Plug shown in figure may

differ from actual plug

attached to unit for

your area.

Parallel position

This position is used for cleaning under

furniture.

ADJUSTING THE HANDLE

Upright position

The handle is normally locked in this

position for storage or when using the

attachments.

Push the handle forward

until it locks.

The handle of this vacuum cleaner can be set to one of

three positions -Upright, Normal, Parallel. Place your foot

on handle release lever as shown and pull back on the handle

until it releases from its upright position.

Normal position

This position is used for normal cleaning.

USING THE VACUUM CLEANER

Handle Release Lever

ON/OFF Switch

ON/OFF SWITCH

Start or stop vacuum cleaner by pushing

on the switch.

OFF ON

The suction force can be adjusted to several settings between "MIN" and "MAX".

Rug/Floor (Tools)

SELECTOR

EDGE CLEANING

This vacuum cleaner is equipped with an "edge cleaning" function for cleaning carpet edges

near baseboards and stationary furniture.

USING THE VACUUM CLEANER

Nozzle Head

HEIGHT ADJUSTMENT LEVER

The nozzle head can be

adjusted to four different

height settings.

Before using the height adj-

ustment lever,please make

sure the nozzle head is tilted

backward from the floor.

Caution:

Set the height adjustment to the

appropriate carpet length.

TURN OFF BRUSH ROLL

WHEN USING TOOLS.

High Carpet/

Tools

VARIABLE SUCTION CONTROL

MAX:Use strong suction force when vacuurning carpets,

floors or cleaning dust and dirt that is hard to

remove.

MIN:Use less suction force when cleaning delecate

surfaces such as drapes or when you wish to

vacuum quietly.

Variable Suction

Control

To strengthen the suction force, turn the

variable suction control to the "MAX" position.

To weaken the suction force, turn the variable

suction control to the "MIN" position.

RUG/FLOOR (TOOLS)SELECTOR

The RUG/FLOOR(TOOLS)selector should only be adjusted while the vacuum cleaner is

turned on and in the upright position.

When cleaning a rug or carpet, first turn the ON/OFF switch to the ON position,

and then set the RUG/FLOOR(TOOLS)selector

to the RUG position.

When cleaning a bare floor or when using one

of the attachments, set the RUG/FLOOR

(TOOLS)selector to the FLOOR position.

Caution: Do not change the setting of the RUG/FLOOR(TOOLS)selector while the vacuum

cleaner is turned off.

Low Carpet/

Bare Floor

Height Adjustment

Lever

Release

Button B

Attachment Clamp

Caution: When using one of the attachments during cleaning, set the vacuum

cleaner to the upright position.

USING THE ATTACHMENTS

Press the release button B to

disconnect the handle from the

vacuum cleaner.

Remove the attachments from the vacuum cleaner.

Caution:

When removing the attachments, pull

them in the directions shown in the

illustration. Pulling them in the wrong

direction or pulling them forcefully may

cause damage to the attachment clamp.

Attach the attachments as shown below.

Hook the hose holder onto the holder mount.

Caution:

Before using the attachments, please make sure

the hose is hooked on the holder mount.

When you have finished using the attachments,replace them

in their original positions as shown on page 4. Tabs

Groove

Upholstery tool & Dusting brush

To detach the dusting brush from the upholstery tool: Press the

tabs on the brush downward to remove it.

To reattach the dusting brush to the upholstery tool: Insert

the front of the upholstery tool under the hook on the front of the

dusting brush. Press down on the back of the upholstery tool to

snap it into place under the dusting brush tabs.

Attach the attachments on the handle or

the suction hose B.

Caution:

Before using the suction

hose B, please make

sure the handle is

reattached on the body.

Hose

Holder

Mount

The wand and crevice tool are

contained together.

Pull out the crevice tool as shown.

Wand

Crevice Tool

Suction Hose A

Wand Crevice Tool

Upholstery

Tool

Dusting

Brush

Suction Hose B

Handle

Duster

Turbo Brush

Bare Floor Brush

USING THE ATTACHMENTS

Hose Attachment

Line up notches,

push hose in till it

clicks.

Handle

Hose Cuff

Suction Inlet

Suction

Hose A

The Turbo Brush is attached

on the main body.

Open the tool cover and take out the

Turbo Brush.

Turbo Brush Attachment

Tool Cover

Turbo Brush Inside

Turbo Brush

Tabla de contenidos

Otros manuales de Aspiradora de Fantom

Fantom

Fantom VACUUM CLEANER FM744HY Manual de usuario

Fantom

Fantom XF732H Manual de usuario

Fantom

Fantom Falcon FC251 Manual de usuario

Fantom

Fantom POWER PET BAGGED CANISTER FM765MC 31 Manual de usuario

Fantom

Fantom PROMIDI 400 CM Manual de usuario

Fantom

Fantom FM732H Manual de usuario

Fantom

Fantom Magic WF 4000 Manual de usuario

Fantom

Fantom FM142EF Manual de usuario

Fantom

Fantom CV242H Manual de usuario

Fantom

Fantom FM766HG Manual de usuario

Fantom

Fantom FM744H Manual de usuario

Fantom

Fantom FM430H Manual de usuario

Fantom

Fantom BAGLESS STICK VAC FS800 Manual de usuario

Fantom

Fantom FM744HY Guía

Fantom

Fantom FANTOM FM430K Manual de usuario

Fantom

Fantom FM741C Manual de usuario

Fantom

Fantom PROMAX 800M3 Manual de usuario

Fantom

Fantom FM741HR Manual de usuario

Fantom

Fantom FM742H Manual de usuario

Fantom

Fantom FM788HB Manual de usuario

Fantom

Fantom FM310K Manual de usuario

Fantom

Fantom FANTOM FM760K Manual de usuario

Fantom

Fantom FM625H Manual de usuario

Fantom

Fantom FS801 Manual de usuario

Manuales populares de Aspiradora de otras marcas

Bissell

Bissell LittleGreen Proheat 1425 Series Manual de usuario

Panasonic

Panasonic MC-YL637S147-AE Manual de usuario

NEFF

NEFF N17XH10 0 Series Manual de usuario

LG A9 Series Manual de usuario

Oreck

Oreck Cordless Captura BK51700 Series Manual de usuario

Kogan

Kogan KAVACROBVWA Manual de usuario

Kränzle

Kränzle VENTOS 50 ID Guía del usuario

EVVO

EVVO Ai35 Manual de usuario

DeWalt

DeWalt DWH200D Manual de usuario

Pontec

Pontec Pondomatic Vacuum Cleaner Manual de usuario

Cleanmaxx

Cleanmaxx PC-P007E Manual de usuario

Exido

Exido 240-114 Manual de usuario

RIDGID

RIDGID WD1685AU0 Manual de usuario

Ezviz

Ezviz RE4P Manual de usuario

STG global

STG global TANVAC HDV3000 Manual de usuario

Shark

Shark ROTATOR PRO COMPLETE NV550 Series Manual de usuario

Factory

Factory M3340 Manual de usuario

Shop-Vac

Shop-Vac VN92 SERIES Manual de usuario