Fantech RIL-100 Instrucciones de instalación y funcionamiento

RIL-150

RIL-200

INSTALLATION & MAINTENANCE

INSTRUCTIONS

,Q/LQH

'XFW0RXQWHG)DQ

RIL-100

RIL-125

Specification

snoisnemiD

Model A B C D E F G Weight kg

RIL-150 112 60 100 80 295 147 200 2.7

RIL-200 124 94 108.5100 302 198 217 4.9

Electrical Data

Model Speed

r/min FLC Amps Input W

RIL-100 High 2200 0.11 24

RIL-100 Low 1850 0.10 18

RIL-125 High 2250 0.13 30

RIL-125 Low 1900 0.10 22

General

1.1. It is important that these Installation and Maintenance Instructions

are fully adhered to.

1.2.All electrical installations must be carried out by a suitably qualified

and competent personnel in accordance with all statutory

requirements.

1.3. The fan is designed for use in an ambient temperature of up to 40°C.

It is not suitable for corrosive or explosive atmospheres.

1.4. The installer should provide easy access to the fan to facilitate future

maintenance, and ensure that the fan is adequately supported.

Page 2 of 4

RIL-100 100 60 88 80 303 97 176 2

RIL-125 100 60 88 80 258 123 176 2

1.5 This product is not intended for use by persons (including children)

with reduced physical sensory or mental capabilities, or lack of

experience and knowledge, unless they have been given supervision

or instruction concerning use of the product by a person responsible

for their safety. Children should be supervised to ensure that they do

not play with the product.

1.6 Precautions must be taken to avoid back-flow of gases into the room

from the open flue of gas or other fuel burning appliances.

1.7 A minimum of one (1) metre of duct is to be fitted to the fan inlet and

discharge spigots.

1.8 To avoid a hazard, a damaged supply cord must be replaced by the

manufacturer.

Installation

Warning: The fan must be isolated from the power supply during

installation and maintenance.

2.1.Upon receipt, the fan should be inspected for any damage.

2.2.Check the details on the rating plate to ensure that the correct power

supply is available

2.3. Means for electrical disconnection must be incorporated in the wiring

installation in accordance with the relevant wiring regulations.

2.4.Remove the fan body from the spigots that are attached to the base,

by releasing the two retaining clamps RIL-100 / RIL-125.

Page 3 of 4

Specification

snoisnemiD

Model A B C D E F G Weight kg

RIL-150 112 60 100 80 295 147 200 2.7

RIL-200 124 94 108.5100 302 198 217 4.9

Electrical Data

Model Speed

r/min FLC Amps Input W

RIL-100 High 2200 0.11 24

RIL-100 Low 1850 0.10 18

RIL-125 High 2250 0.13 30

RIL-125 Low 1900 0.10 22

General

1.1. It is important that these Installation and Maintenance Instructions

are fully adhered to.

1.2.All electrical installations must be carried out by a suitably qualified

and competent personnel in accordance with all statutory

requirements.

1.3. The fan is designed for use in an ambient temperature of up to 40°C.

It is not suitable for corrosive or explosive atmospheres.

1.4. The installer should provide easy access to the fan to facilitate future

maintenance, and ensure that the fan is adequately supported.

Page 2 of 4

RIL-100 100 60 88 80 303 97 176 2

RIL-125 100 60 88 80 258 123 176 2

1.5 This product is not intended for use by persons (including children)

with reduced physical sensory or mental capabilities, or lack of

experience and knowledge, unless they have been given supervision

or instruction concerning use of the product by a person responsible

for their safety. Children should be supervised to ensure that they do

not play with the product.

1.6 Precautions must be taken to avoid back-flow of gases into the room

from the open flue of gas or other fuel burning appliances.

1.7 A minimum of one (1) metre of duct is to be fitted to the fan inlet and

discharge spigots.

1.8 To avoid a hazard, a damaged supply cord must be replaced by the

manufacturer.

Installation

Warning: The fan must be isolated from the power supply during

installation and maintenance.

2.1.Upon receipt, the fan should be inspected for any damage.

2.2.Check the details on the rating plate to ensure that the correct power

supply is available

2.3. Means for electrical disconnection must be incorporated in the wiring

installation in accordance with the relevant wiring regulations.

2.4.Remove the fan body from the spigots that are attached to the base,

by releasing the two retaining clamps RIL-100 / RIL-125.

Page 3 of 4

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Admirador de Fantech

Fantech

Fantech 2GMS 1021 Manual de usuario

Fantech

Fantech SER 1504N Manual de usuario

Fantech

Fantech SH704 Manual de usuario

Fantech

Fantech FADE Series Manual de usuario

Fantech

Fantech FIT 120E Manual de usuario

Fantech

Fantech SER Series Manual de usuario

Fantech

Fantech FR Series Manual de usuario

Fantech

Fantech RIL-150T Instrucciones de instalación y funcionamiento

Fantech

Fantech RVF 4XL Manual de usuario

Fantech

Fantech FQ80 Manual de usuario

Fantech

Fantech PB110 Manual

Fantech

Fantech Jetstream JCE202-3 Manual de usuario

Fantech

Fantech VER100 Manual de usuario

Fantech

Fantech RIL-150SW Instrucciones de instalación y funcionamiento

Fantech

Fantech Ezifit EIE150 Manual de usuario

Fantech

Fantech FR Series Manual de usuario

Fantech

Fantech Serenity Series Manual de usuario

Fantech

Fantech MINITUBE Series Instrucciones de instalación y funcionamiento

Fantech

Fantech HV-150CAP Manual de usuario

Fantech

Fantech AEV Series Manual de usuario

Fantech

Fantech DBF110 Manual de usuario

Fantech

Fantech PB110L7 Manual

Fantech

Fantech OdourVac Manual de servicio

Fantech

Fantech SHR 1504 Manual de usuario

Manuales populares de Admirador de otras marcas

ELTA FANS

ELTA FANS H03VV-F Manual de usuario

Hunter

Hunter 20714 Manual de instrucciones

Emerson

Emerson CARRERA VERANDA CF542ORB00 Manual de usuario

Hunter

Hunter Caraway Manual de instrucciones

Panasonic

Panasonic FV-15NLFS1 Manual de usuario

Kompernass

Kompernass KH 1150 Manual de usuario

VES

VES FALA100/12V/TR Manual de usuario

Vertiv

Vertiv Liebert DCD Manual de usuario

Westinghouse

Westinghouse GFP Series Manual de usuario

Venmar

Venmar KUBIX HRV PLUS Series Manual de usuario

Maico

Maico ECR 31 Manual de usuario

Sonnenkonig

Sonnenkonig Dinky Manual de usuario

S&P

S&P ECOWATT HXBR Manual de usuario

Wider

Wider IMP03369BH Manual de usuario

Panasonic

Panasonic F-60DHN Manual de usuario

Hinkley

Hinkley HIGHLAND Manual de usuario

Broan

Broan 766BN Manual de usuario

Premium

Premium PFS16022 Instrucciones de montaje