Left Bracket Right Bracket
Attaching right bracket to wall
Left end of spring drive wheel
Illustrations, clockwise from top left:
End brackets (right and left sides), end caps,
stop pin and installation screws.
PACKAGE CONTENTS
BEFORE YOU BEGIN, VERIFY THAT YOU HAVE ALL THE NECESSARY
PARTS AND PIECES:
• SHADES - NOTE THE SHADE SIZE. THIS IS VERY IMPORTANT.
For shade sizes less than 36⁷⁄₈” tip to tip wide, refer to the
installation instructions for Smartroll™ 24-1.
For shade sizes greater than 36⁷⁄₈” tip to tip wide, refer to
the installation instructions for Smartroll™ 32-1.
• PACKAGE - Contains 2 brackets (a left bracket and a right
bracket), 2 bracket covers, 4 mounting screws and a
stop pin.
If this Smartroll technology is new to you, or you have
never installed a Smartroll shade before, please go to the
video at: www.smartroll.com
Scroll down to the “Technological Innovation” section and
you will see the video for the “Smartroll 32-1 Installation Tour”
on the right side.
Pay particular attention to Steps 2/7 through 7/7 in this video.
Step 1/7 has already been completed at the factory.
NOTE:
The following directions are based on a standard roll
shade. For a reverse roll shade, simply turn the shade
around.
The spring drive wheel for a standard shade installation
will be on the right side and the brake wheel will be on
the left side.
If the shade is turned around, the spring drive wheel will
be on the left side and the brake wheel will be on the
right side.
Mounting the Shades
STEP 1 - BRACKET INSTALLATION.
Attach the brackets to the wall. Use a pencil to mark the
drilling points and a level to keep a proper horizontal
position.
Attach them to the wall with the 4 screws provided.
See photos below.
STEP 2 - ROLLER SHADE INSTALLATION.
Attach the roller shade to the brackets by slipping the pins
into the notches.
