CS 14/2400 PRO English | 9
www.ffgroup-tools.com
and against accidental touching of the cutting disc.
f
when opened.
f
f
tools. The mains cable can be cut through or get
caught.
f
of control.
fNever remove cutting remainders, metal chips, etc.
from the cutting area while the machine is running.
f
when the machine is switched on. Otherwise, there
f
chips, etc. Small pieces of metal or other objects that
come in contact with the rotating cutting disc can
f
pieces that are too small to clamp. Otherwise, the
clearance of your hand to the rotating cutting disc
is too small.
fIf the cutting disc becomes jammed, switch the ma
complete stop. Never attempt to remove a still run
ning cutting disc from the cut, otherwise there is
for the jamming.
f
applying lateral pressure to it. The cutting disc can
f
and do not apply too much pressure when using the
power tool. Particularly avoid jamming or wedging
prior warning.
f
cutting metal.
f
grinder can be subject to overload.
f
ting discs. Damaged cutting discs cause increased
fAlways use cutting discs with correct size and shape
(diamond versus round) of arbor holes. Cutting discs
that do not match the mounting hardware of the
control.
fDo not attach a saw chain woodcarving blade or
toothed saw blade. Such blades create frequent
f
f
signed and recommended by the tool manufacturer.
power tool, it does not assure safe operation.
f
has cooled. The cutting disc becomes very hot while
f
ble repaired only through an authorised customer
damaged extension cables. This will ensure that the
safety of the power tool is maintained.
fStore the machine in a safe manner when not being
This prevents the machine from storage damage,
and from being operated by untrained persons.
f
clamping devices or in a vice is held more secure than
by hand.
fNever leave the machine before it has come to a
complete stop. Cutting tools that are still running
can cause injuries.
fNever use the machine with a damaged cable. Do not
touch the damaged cable and pull the mains plug
chine’s rating plate are compatible with the power
supply you intend to connect it to.
This appliance is Class II and is designed for connec
tion to a power supply matching that detailed on the
an extension lead is required, use an approved and
the instruction supplied with the extension lead.
f
heavy enough to carry the current your product will
draw. An undersized cord will cause a drop in line
voltage resulting in loss of power and overheating.
fAlways replace a damaged extension cord or have
fProtect your extension cords from sharp objects,
excessive heat and damp/wet areas.
f
circuit should be protected with the appropriate
same as the voltage stamped on the motor name
motor.
The machine is intended for stationary use with
cutting discs to perform lengthways and crossways
straight cuts or mitre cuts to 45° in metal materials
without the use of water.
