English | 7
www.ffgroup-tools.com
CSC 3.6V EASY
cannot be controlled with the switch is dan-
gerous and must be repaired.
fDisconnect the plug from the power source
-
ing accessories, or storing power tools. Such
of starting the power tool accidentally.
fStore idle power tools out of the reach of
children and do not allow persons unfamil-
iar with the power tool or these instructions
to operate the power tool. Power tools are
dangerous in the hands of untrained users.
f -
of parts and any other condition that may
-
aged, have the power tool repaired before
use. Many accidents are caused by poorly
maintained power tools.
f
maintained cutting tools with sharp cutting
to control.
f
etc. in accordance with these instructions,
those intended could result in a hazardous
situation.
BATTERY TOOL USE AND CARE
f
the manufacturer. A charger that is suitable
f -
-
f
from one terminal to another. Shorting the
battery terminals together may cause burns
f
ejected from the battery; avoid contact. If
-
medical help. Liquid ejected from the bat-
tery may cause irritation or burns.
SERVICE
repair person using only identical replace-
ment parts. This will ensure that the safety
of the power tool is maintained.
SCREW DRIVERS
fAvoid damage that can be caused by screws,
f
same as the voltage indicated on the name-
plate of the charger.
f
when the tool insert jams. Be prepared for
-
• The power tool is subject to overload or
•
f
speed matching at least the highest no-load
speed of the tool.
fThe tool/charger is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
they have been given supervision or instruc-
tion concerning use of the tool/charger by a
person responsible for their safety.
fEnsure that children do not play with the
tool/charger.
f-
and loosening screws.
f
with clamping devices or in a vice is held
more securely than by hand).
f -
faces, when performing an operation where
the cutting accessory or fastener may con-
tact hidden wiring or its own cord (cutting
accessory and fasteners contacting a “live”
