Extron electronics CVC 200 Manual de usuario
Extron Electronics, USA
1230 South Lewis Street
Anaheim, CA 92805
USA
714.491.1500
Fax 714.491.1517
Extron Electronics, Europe
Beeldschermweg 6C
3821 AH Amersfoort
The Netherlands
+31.33.453.4040
Fax +31.33.453.4050
Extron Electronics, Asia
135 Joo Seng Road, #04-01
PM Industrial Building
Singapore 368363
+65.6383.4400
Fax +65.6383.4664
Extron Electronics, Japan
Daisan DMJ Building 6F
3-9-1 Kudan Minami
Chiyoda-ku, Tokyo 102-0074 Japan
+81.3.3511.7655
Fax +81.3.3511.7656
www.extron.com
© 2003 Extron Electronics. All rights reserved.
User’s Guide
Specifications, cont’d
CVC 200
68-437-01 Rev. C
Printed in the USA
12 03
Component Video and HDTV to RGB Converter
Video output
Number/signal type ................... 1 RGBHV, RGBS
Connectors .................................... 6 BNC female
Nominal level ............................... 0.7V p-p for RGB
Minimum/maximum levels ...... RGB ............ 0.4V to 1.0V p-p
Impedance .................................... 75 ohms
Return loss .................................... <-30dB @ 5 MHz
DC offset ....................................... <0.1V with input at 0 offset
General
Power ............................................. 100VAC to 240VAC, 50/60 Hz, 12 watts, internal,
autoswitchable
Temperature/humidity .............. Storage -40° to +158°F (-40° to +70°C) /
10% to 90%, non-condensing
Operating +32° to +122°F (0° to +50°C) /
10% to 90%, non-condensing
Rack mount................................... Yes, with optional rack shelf,
part #60-190-01 or #60-604-01
Enclosure type .............................. Metal
Enclosure dimensions ................. 1.6" H x 8.75" W x 9.4" D
(1U high, half rack width)
4.1 cm H x 22.2 cm W x 23.9 cm D
(Depth excludes connectors.)
Product weight............................. 2.8 lbs (1.3 kg)
Shipping weight .......................... 5 lbs (2.3 kg)
Vibration ....................................... ISTA/NSTA 1A in carton
(International Safe Transit Association)
Listings .......................................... UL, CUL
Compliances ................................. CE
MTBF ............................................. 30,000 hours
Warranty ....................................... 3 years parts and labor
Specifications are subject to change without notice.
CVC 200 • Installation
Introduction
1 2CVC 200 • Cable Connection and Rate Selection
The CVC 200 Component Video Converter converts all SMPTE standard
component video formats to RGBS or RGBHV video. The CVC 200 can
also strip sync-on-green (SOG) from RGsB video. The converter outputs
converted RGBS or RGBHV video on BNC connectors. Figure 1 shows a
typical CVC 200 application.
OUTPUT
INPUT
FORMAT
Extron
CVC 200
Video Converter
HDTV
Set Top Box
Large Screen
Rear Projector
LCD Projector
Video Monitor
DVD
or
or
Figure 1 — Typical CVC 200 application
The component video input formats include DVD, Betacam® video, and
HDTV component video. The RGsB video input can be computer video
or NTSC/PAL video.
Mounting
The CVC 200 can be rack mounted using one side of a 1U Universal
Rack Shelf (part #60-190-01) or 1U Basic Rack Shelf (part #60-604-01).
Rack mount the CVC 200 as follows:
1. Remove the feet from the case, if they were previously installed.
2. Mount the CVC 200 on the rack shelf, using two 4-40 x 3/16"
screws in opposite corners (under the shelf) to secure the case to
the shelf (figure 2).
(2) 4-40 x 3/16" Screws
Use 2 mounting holes on
opposite corners.
False front panel
uses 2 front holes.
#10-32 Screw
w/ Nylon Captive
Cap Washer
CVC 200
Figure 2 — Rack mounting the CVC 200
Cable Connection and Rate Selection
See figure 3 to identify the rear panel connections and Format rotary
switch
OUTPUT
RGBSHV
P
R
/R
P
B
/B
Y/G
INPUT FORMAT
LISTED
1T23
I.T.E.
C
.35A
100-240V 50-60Hz
2 4
1
3
Figure 3 — CVC 200 rear panel features
CVC 200 • Rate Selection
Cable Connection and Rate Selection
CVC 200 • Specifications
Cable Connection and Rate Selection, cont’d
43
Input connections
1
Power connector — Plug a standard IEC power cord into this
connector to connect the CVC 200 to a 100 to 240VAC, 50 Hz or
60 Hz power source.
2
Input connectors — Connect a component video input device
(HDTV, W-VHS [Y, PR, PB], SMPTE [Y, R-Y, B-Y]), Betacam®
[Y, R-Y, B-Y]) or an RGsB input device to these female BNC
connectors. Use high-resolution cable, such as Extron's BNC-4
mini HR, RG59/HR, or RG6/SHR cable. Connect the input
device as shown in figure 4.
PR/R
PB/B
Y/G
PR/R
PB/B
Y/G
Y, PB, PR
RGsB
(SOG)
video
Y, B-Y, R-Y
video
video
PR/R
PB/B
Y/G (R-Y)
(B-Y)
Figure 4 — Input connections
Format rotary switch
3
Format rotary switch — Use an Extron Tweeker or other small
screwdriver to set the Format rotary switch to match the video
input format. The table below shows the switch settings and their
assigned input video formats.
Position
0
1
2
3
4
5
6
7
8
9
A
B-F
Input
format(s)
Not used
Y, Pb, Pr
Y, Pb, Pr
Y, Pb, Pr
Not used
RGsB
RGsB
Y, Pb, Pr
Y, Pb, Pr
Y, Pb, Pr
Y, Pb, Pr
Not used
Standard or rate
NTSC/PAL
HDTV (480p, 576p, 720p, 1035i, 1080i)
Betacam
NTSC/PAL
Computer rates
NTSC/PAL
HDTV (720p)
HDTV (1080i)
HDTV (1080p)
Format
switch
Output connections
4
Output connectors — Connect an RGBHV or RGBS display to
these female BNC connectors. Use high-resolution cable, such as
Extron's BNC-4 or BNC-5 mini HR, RG59/HR, or RG6/SHR
cable. Connect the display as shown in figure 5.
RV
GBSH
RV
GBSH
RGBHV
video
RGBS
video
Figure 5 — Output connections
Specifications
Video
Gain ............................................... Unity
Bandwidth .................................... 55 MHz (-3dB)
Video input
Number/signal type ................... 1 component video (HDTV, W-VHS [Y, PR, PB],
SMPTE [Y, R-Y, B-Y], and Betacam [Y, R-Y, B-Y])
or RGsB
Connectors .................................... 3 BNC female
Nominal level ............................... 1V p-p for Y of component video
0.3V p-p for R-Y and B-Y of component video
0.7V p-p for PB, PR
Minimum/maximum levels
Y ......................................... 0.5V to 1.5V p-p with no offset at unity gain
PBPR.............................................................. 0.4V to 1.0V p-p with no offset at unity gain
Impedance .................................... 75 ohms
Horizontal frequency .................. 15.75 kHz to 45 kHz according to selected mode
Vertical frequency ....................... 60 Hz
Return loss .................................... <-25dB @ 5 MHz
DC offset allowed ........................ ±2V (max.)
Tabla de contenidos
Otros manuales de Convertidor de medios de Extron electronics
Extron electronics
Extron electronics TLI Pro 201 Manual de usuario
Extron electronics
Extron electronics Four Input Video and RGB Scaler DVS 304 Manual de usuario
Extron electronics
Extron electronics DVS 204 Manual de usuario
Extron electronics
Extron electronics CD 400 Manual de usuario
Extron electronics
Extron electronics IN1608 xi IPCP SA with LinkLicense Manual de usuario
Extron electronics
Extron electronics Quantum Elite Series Manual de usuario
Extron electronics
Extron electronics VN-Matrix 300 Manual de usuario
Extron electronics
Extron electronics II Manual de usuario
Extron electronics
Extron electronics DSC 3G-3G A Manual de usuario
Extron electronics
Extron electronics Converter CVC 200 Manual de usuario
Extron electronics
Extron electronics YCV 100 Manual de usuario
Extron electronics
Extron electronics DSC HD-HD 4K A Manual de usuario
Extron electronics
Extron electronics DSC 301 HD Manual de usuario
Extron electronics
Extron electronics VSC 900 Manual de usuario
Extron electronics
Extron electronics VSC 150 Manual de usuario
Extron electronics
Extron electronics Emotia Xtreme Manual de usuario
Extron electronics
Extron electronics USP 507 Manual de usuario
Extron electronics
Extron electronics DVS 204 Manual de usuario
Extron electronics
Extron electronics DVS 304 Series Manual de usuario
Extron electronics
Extron electronics AXI 016 Manual de usuario
