05
1
2
3
4
Quick Release Bracket – Six Pack, MaXx-D, Toro,
Strada, Race, (Diablo and Joystick with clip)
The Exposure QR bracket is a triumph in design that brings to life the full benet of
Exposure’s principle feature, Cable Free Design (CFD). The light unit is easily and
quickly attached and removed. The bracket stays with the bike and the light will be in
the perfect position every time it is attached.
• Mounting to a 31.8mm bar – Remove the spacer from the bracket. Wrap the
supplied Silicone band, (marked Exposure 31.8) around the handlebar and clamp
bracket over the band to protect the bars. Tighten the clamp with a 4mm hex key.
(Maximum 5Nm)
DO NOT OVER TIGHTEN!
• Mounting to a 25.4 or 26mm bar - Clip the plastic spacer over your bar, attach the
bracket over the spacer and tighten the clamp with a 4mm hex key. (Maximum 5 Nm)
1 Attach the cleat to the light unit using
the provided bolt (Already tted to new
lights).
2 Locate the cleat into the V section of
the bracket and slide forward until the
steel pin “clicks” into place
3 To adjust the horizontal angle of the
light, loosen the cleat bolt. A hole in
the bracket enables access to the bolt
when the light is in the bracket. Use a
4mm hex key to adjust and tighten the
bolt securely (Maximum 5Nm)
4 To release the light from the bracket
pull down on the red button and gently
pull back the light with your hand. This
is a simple one-hand operation.
• Warning - Make sure that brake
and gear cables cannot catch on or
interfere with the light or the bracket or
release button.
Racers beware - check number
boards do not interfere with bracket
button. If the steel pin can not pop-up
fully the light will not be fully engaged
to the bracket and may come off.
QR bracket also available as accessory:
EXPQRBK-10 Bracket Only (no cleat or bolt)
EXPQRBKSET Bracket with clip for Joystick/Diablo/Spark
