3 4
Some Safety Measures
Important Precautions:
The Output Side of the AC supply wiring of EXIDE INTEGRA should never be
connected to utility Power or DG Set. This condition is far worse than Short
Circuit. If the unit survives this condition, it will shut down until connections are
made. During Installation should ensure that the AC supply Output of EXIDE
INTEGRA should not be connected to Mains Input.
CAUTION: Power Switch Should be in OFF Condition while making AC Input/
Output Connections.
WARNINGS:
DO NOT ATTEMPT to open or repair the battery pack
DO NOT EXPOSE to re
DO NOT SHORT - CIRCUIT the positive and negative terminals of the
battery with wire or other conductive objects
DO NOT EXPOSE to temperatures above 50°C and keep out of
direct sunlight
DO NOT IMMERSE the battery / module in water, saltwater,
or any other liquid
DO NOT REVERSE polarity or connect the battery in series
DO NOT REMOVE and Transport the battery / module with metal
objects that may short the +Ve and –Ve power terminals
(tools, necklace, rings etc.)
DO NOT PIERCE the battery / module / cells with sharp objects
like nails or screw drivers
DO NOT OPERATE without the earth / GND connected
DO NOT CONTINUE using the battery / module / pack during critical
alarm conditions
DO NOT USE liquids for cleaning, specically Alcohol or
Ammonia extracts
DO NOT DISASSEMBLE or open, crush, bend or deform, puncture,
or shred without manufacturer’s permission
DO NOT STORE batteries more than over 6 months without recharge
maintenance. Battery safety may be compromised when recharging
batteries which have rested for a longer time
DO NOT ALLOW battery maintenance or usage by children
DO NOT REMOVE Batteries for using in other Applications. It is
Hazardous.
General Precautions:
Before installing, connecting any wiring or using the EXIDE INTEGRA, read all
instructions of this instruction manual.
CAUTION:
Do not install unit unless instructed to do so. Failure to comply with
this instruction can cause damage or complete failure of the unit.
CAUTION:
To reduce risk of injury, make connection properly
Do not expose the system to rain, snow or liquids of any type.
Do not disassemble the system.
Call EXIDE authorised service centre when service or repair is required.
Incorrect reassembly may result in a risk of electric shock or re.
To reduce risk of electric shock, disconnect all the wiring & Switch OFF
the Power Switch from (or of) system before attempting any
maintenance cleaning. Turning o the system will not reduce this risk
WARNING: WORKING IN VICINITY OF A LITHIUM ION BATTERY IS
DANGEROUS.
Be extra cautious when working with metal tools on, or around
batteries. The potential exists to drop a tool and short-circuit the
batteries or other electrical parts resulting in sparks that could
cause an explosion
Do not leave batteries in discharge state for more than one or two days.
Battery will self-discharge over a period of 2 – 3 Months, so they should
periodically recharge even if they are not being used.
EXIDE INTEGRA should be stored at 0 – 45 C ambient temperature
range
GROUNDING INSTRUCTIONS: The EXIDE INTEGRA Pure Sine Wave Inverter
should be connected to a grounded with permanent wiring connection.
INCASE OF FOULING SMELL /SMOKE / FIRE
1. Immediately switch-o the Power Switch on Inverter
2. Disconnect the Input AC power to Inverter
3. Do not use water to prevent Smoke / Fire
4. Use Class D (Dry Powder type) Fire Extinguisher
5. Stay away from Inverter
6. Immediately seek nearest assistance
7. Inform Exide Customer care (Exide can review and update these points)
