
2.2. USB interface card
An external Delock USB 3.1 Gen 2 host controller card (incl. a CD that contains the necessary
driver) comes along with each pco.edge camera. This card can be used to connect the camera
to a PC via USB cable if the PC does not have the necessary USB port installed already.
Note: In multi-camera operation, each camera needs its own USB host controller card.
Hardware Installation: First shut down the computer and mount and install the USB 3.1 Gen 2
host controller card.
WARNING: Danger from electrical voltage!
HIGH VOLTAGE: Hardware installation must be performed by a technician, because high
voltages can occur on the device. Always pull the main plug before opening the computer. Wear
anti-static ESD boots to prevent irreparable damage.
Driver Installation: The driver installation differs, depending on the operating system and controller
card:
For Win 10 or higher a manual installation of ASMedia3142 can be done. For Win 7/8 the manufacturer
must be asked if an implementation is possible.
OS Controller card Driver
Win 10 Delock 90299 Manual Installation of ASMedia3142
Win 11 Delock 90299 Manual Installation of ASMedia3142
Linux Delock 90299 PCO-connection based on libusb version 1.0.21
ASMedia3142 Installation Follow these steps to install the ASMedia3142 driver under Win 10/11:
•Insert the Delock driver CD SE-CD5D-DL-PCIEU in your CD drive and open the folder
ASMedia.
•Alternatively, browse for the folder USB3.0pciboard on the USB stick that comes with the
camera.
•Open the subfolder ASM3142 and run the setup.exe
•If the User Account Control is enabled, a dialog may ask you to launch the setup. Accept
with Yes.
•Follow the instructions of the Installer.
For more information on the installation and operation of the USB interface card, please consult
the manufacturer.
pco.edge 4.2 bi XU Chapter 2
pco.edge 4.2 bi XU user manual 1.0.0 8