OPERATION
OPERATION WITH THE CONTROL PANEL
The unit will beep. Press again to decrease the flame
intensity. There are six light intensities to choose from. The
flame optics will go lower under the sequence of 6, 5, 4,
3 ,2 and 1. Press the button again to stop the flame effect.
750W:
Press this button for low heat level. The indicator
light wil l be ON. The heater will provide low heat level.
Press once again to stop the low heat level function.
1500W:
Press this button for high heat level. The unit
will beep. The heater will provide high heat level. Press
once again to stop the high heat level function.
OPERATION WITH THE REMOTE
CONTROL
1W
750W:
1500W:
Installation
Warning: Installing this product below 300mm will cause
overheating issues.
The suite is designed as a wall mounted suite; it is not suitable to be
installed at floor level.
This model is provided with a wall mounting bracket along with x5
screws and wall plugs.
PLEASE NOTE: The screws and plugs provided are only suitable
for a solid wall fixing.
If the installation is onto a hollow/stud wall, we recommend that
heavy duty wall anchors or equivalent are used.
To install the product:
Measure 700mm from the floor level up the wall, Mark this
measurement with a pencil.
Place the bottom edge of the wall bracket on the 700mm mark,
level using a spirit level and mark and drill the x5 fixing holes.
Using the correct wall fixings screw and fix the wall bracket in
place.
Locate the x3 slots in the rear of the product, carefully align these
slots with the prongs on the wall bracket, lift and slot the product
into place.
Locate the power cable socket on the bottom right hand side,
underneath the hearth on the fire, and plug the power lead in.
The product is now ready to use.
