evolution fires VEGAS 72 Manual de usuario
Electric Fireplace
AC 110V-120V 50Hz 1500 W
WARNING
Read and understand this entire owner’smanual,includingall safety
information,beforeplugging in or using this product. Failure to do so could
result in fire, electric shock, or serious personal injury.
CAUTION Keep this owner’s manual for future reference. If you sell or give this
product away, make sure this manual accompanies this product.
OWNER’S�MANUAL
VEGAS 72
1
IMPORTANT SAFETY INFORMATION!
WARNING
When using electrical appliances basic precautions should always be followed to reduce the
risk offire, electric shock and injury to persons, including thefollowing:
Read all instructions before using this heater.
This heater is hot when in use. To avoid burning,donottouchhotsurface.Ifprovided,use
handles when moving this heater. Keep combustible materials, such as furniture, pillows,
bedding, papers, clothes, and curtains at least 1 m from the front of the heater and keep them
away from the sides and rear. In order to avoid overheating, do not cover theheater.
Extreme caution is necessary when any heater is used near children or the infirm and
whenever the heater is leftoperatingandunattended.
Always unplug heater when not in use.
Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has
been dropped damaged in any manner, return heatertoauthorizedservicefacilityfor
examination, electrical or mechanical adjustment, or repair.
Indoor use only, do not use outdoors.
This heater is not intended for use in bathrooms, laundry areas and similarindoorlocations.
Never locate heater where it may fall into a bathtub or other watercontainer.
Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar
coverings. Arrange cord away from traffic area and where it will not be tippedover.
To disconnect heater, turn controls to off, then remove plug from outlet.
Do not inset or allow foreign objects to enter any ventilation or exhaust opening as this may
cause an electric shock or fire, or damage the heater.
To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft
surfaces, like a bed, where openings many become blocked.
A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, or
flammable liquids are used or stored.
Use this heater only as describes in this manual. Any other use not recommended by the
manufacturer may cause fire, electric shock, or injury to persons.
DANGER-HIGH Temperatures may be generated under certain abnormal conditions. Do not
partially or fully cover or obstruct the front of this heater.
Replacement of the lamps should be done onlywhiletheheaterisdisconnectedfromthe
supply circuit.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or capabilities, or lack of experienceandknowledge,unlesstheyhavebeengiven
supervision or instruction concerning use of the appliance by a person responsible for their
safety.Children should be supervised to ensure that they do not play with theappliance.
CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this
appliance must not be supplied through an external switching device, such as a timer, or
connected to a circuit that is regularly switched on and off by the utility.
2
Preparation
This product includes a GLASS panel! Always use extreme caution when handling
glass. Failure to do so could result in personal injury or property damage.
Remove all parts and hardware from the carton and place them on a clean, soft, dry surface. Parts and
assembly steps are grouped for wall-hanging or recessing use. Check the parts list to make sure
nothing is missing. Dispose of packaging materials properly. Please recycle wheneverpossible.
You will need the following tools (not included): Phillips screwdriver; stud finder; level; tape measure;
electric drill; 1/4” wood drill bit, hammer.
Parts and Hardware
A– Fireplace
B–WoodScrews C–Drywallanchors
Remote Control F-Metal bracket
G-Wall Bracket
Fixed on back of firebox
H-Small
Decorative
Crystals
H-Big
Decorative
Crystals
I-Log set J-Plastic Tray
Specification and Dimension
3
Installation and Assembly
Your appliance is a wall-mounted, recessed and/or mantel installed appliance. Select a suitable
location that is
not susceptible to moisture and is away from drapes, furniture and high traffic areas.
NOTE: Follow all National and local electrical codes.
MINIMUM CLEARANCE TO COMBUSTIBLES
Measurements are taken from the glass front.
Bottom 0" Top 0" to mantel
Sides 0" Top 0" to ceiling
Back 0"
MINIMUM MANTEL CLEARANCES
WARNING
WHEN USING PAINT OR LACQUER TO FINISH THE MANTEL, THE PAINT OR LACQUER MUSTBE
HEAT RESISTANT TO PREVENT DISCOLOURATION.
0” (0 mm)
4
Engine Only Recessed To Wall Installation
Hole Size
(A)
STEP A. Selection a dry wall to open a hole for fireplace box. Size of hole as below chart
Figure ( A )
STEP B. Using the screw driver to take off the screws from the front Figure (B)
STEP C. Have two adult people to pull of the glass panel and take it out Figure (C)
Framing Hole Size
Model Number WH
BEF-36WM 35.9” (91.2CM) 18.84” (47.86CM)
BEF-42WM 42.71” (108.3CM) 18.84” (47.86CM)
BEF-50WM 49.29” (125.2CM) 18.84” (47.86CM)
BEF-60WM 59.29” (150.6CM) 18.84” (47.86CM)
BEF-72WM 71.25” (181CM) 18.84” (47.86CM)
5
(B) (C)
(D) (E)
STEPD.Fix the metal brackets to the BOTTOM and the TOP of the
fireplace box. Figure(D,E)
NOTE:Metal brackets can be use as movable, please adjust to the best location as need
(F)
STEP F. Your Electric fireplace will be looks as below after installation
STEP E. Have two adult people
to lift of the fireplace box and put
it inside of the wall opening hole.
Using the screw driver to fix all
wood screws and drywall anchors
through the metal brackets to
the wall and fixing tightly.
NOTE: Making sure that all screws
and drywall anchors are well
screwed.
7
Wall Mounted Installation
Due to the many different materials used on different walls, it is highly
recommended that you consult your local builder before you install this appliance on
the wall.
A.Select a location that is not prone to moisture and is located at least 36" (914mm)
away from combustible materials such as curtain drapes, furniture, bedding, paper,
etc.
B.Have two people hold the appliance against the wall to determine the final
location.
C.Place unit face down on a soft, non abrasive surface. Remove the bracket from
the back of the unit by removing the screws, refer to Figure 1.
D.Mark out location, then mount the bracket(s) onto the wall using the supplied
screws. This bracket
MUST have the hooks facing upward and be level. NOTE:Itisstrongly
recommended that the
mounting bracket (G) be
Screwedintothe wall studs
Where possible. If the wall
Studs cannot be used, ensure
That the supplied plastic anchors are used to affix the bracket to the wall and
the bracket is adequately secured.
E. With the wall mounting bracket installed have two people lift the appliance up and
insert the two hooks
on the bracket into the two slots on the back of the appliance.
F. Check the appliance for stability ensuring that the bracket will not pull free from
the wall.
BEF-36WM/BEF-42WM/BEF-50WM Wall Bracket Illustrated
8
BEF-60WM/BEF-72WM Wall Bracket Illustrated
9
Log-set / Crystal Ember Installation
(NOTE:Please make the installationaccordingtotheemberswhich you bought or selected.)
A.
Glass front must be removed and the appliance must be mounted in its final location
before the log-set / crystal / pebble embers are installed.
B.
If you
r
fireplace come with log-set, You do not need to do anything
j
ust use as it is . Figure1.
C.
To switch to Crystals, firstly take the Log-set out of the fireplace slot, then Place the plastic tray
(J) to the fireplace designed place.Then carefullyplacecrystalembersintotheplastictray as
illustrated. Apply an even layer from side to side. Figure 2, Figure 3.
Figure 1
Figure 2
Figure 3. (Crystal medias)
HARD WIRING INSTALLATION
HARD WIRING CONNECTION
If it is necessary to hard wire this appliance, a qualified electrician must remove the cord connection, and wire
WARNING
TURN OFF THE APPLIANCE COMPLETELY AND LET COOLBEFORESERVICING.ONLYAQUALIFIEDSERVICE
PERSON SHOULD SERVICE AND REPAIR THIS ELECTRIC APPLIANCE.
Tabla de contenidos
Otros manuales de Chimenea de interior de evolution fires
evolution fires
evolution fires VEGAS PETITE Manual de usuario
evolution fires
evolution fires 3 Sided Empire 44 Manual de usuario
evolution fires
evolution fires Alpha Manual de usuario
evolution fires
evolution fires Vegas 96 Manual de usuario
evolution fires
evolution fires 3 Sided Empire 72 Manual de usuario
evolution fires
evolution fires SPECTRUM Series Manual de usuario
