Overview
This guide provides instructions on how to connect your EVOCHARGE iEVSE to local Wi-Fi signal. Note, this step is
only required when using the optional third party OCPP network service with the EVOCHARGE iEVSE and iEVSE
Plus charging station products.
Access the EVoCharge Web Portal via Wi-Fi Connection
1. First, we need to connect a laptop or mobile phone to the EVOCHARGE iEVSE. Each EVOCHARGE iEVSE has a
unique Wi-Fi signal that is identified based on the unique serial number of the charging station. To start, first
note down the serial number of the EVOCHARGE iEVSE charging station you would like to connect to via Wi-Fi.
a. The unique serial number is located on the Product ID label located on the side of the charging station
and will consist of the following structure: “1EO3-1-YYMM-XXXXX” (e.g. 1EO3-1-1836-00104)
2. Next, using laptop or mobile phone, proceed with setting up a Wi-Fi connection and locate the EVOCHARGE
iEVSE Wi-Fi signal that correlates with the unique serial number.
a. The Wi-Fi signal name will consist the following structure: “IC3-YYMMXXXXX” (e.g. IC3-183600104), as
shown below:
a. Next, click “Connect” and proceed to enter the password (network security key). The network security
key correlates to the unique serial number of each EVOCHARGE iEVSE and consists of the following
structure: “YYMMXXXXX@IC3” (e.g. 183600104@IC3).
b. Upon successful Wi-Fi connection to the EVOCHARGE iEVSE charging station, you will see the unique Wi-
Fi signal connection such as shown below:
