Evinci TD Series Manual de usuario
evinci™ ELECTRIC BICYCLE
USER MANUAL
TD-Series
(TUI / FALCON / ROBIN)
PLEASE READ CAREFULLY
Ta le of Contents
Safety Instructions........................................................................................3
Symbols.......................................................................................................3
Introduction.................................................................................................4
Mode of operation and extent of electronic power assistance..........................................4
Levels of support..........................................................................................................4
What comes with the bike ............................................................................4
TUI / FALCON – components.........................................................................5
Robin Folding Bike........................................................................................6
Basic Safety Tips...........................................................................................7
For your own road safety..............................................................................................7
How to use your charger...............................................................................7
Safety notes concerning the battery...............................................................9
Charging the battery...................................................................................10
How to remove and insert the battery..........................................................................10
Before starting to ride.................................................................................11
Adjust Seat height......................................................................................................11
How to find the correct saddle height .........................................................................11
Adjusting the saddle angle..........................................................................................11
Adjust the stem and handlebar....................................................................................12
Check tire pressure.....................................................................................................12
Operation...................................................................................................12
Display functions........................................................................................................12
Throttle......................................................................................................................13
Gears.........................................................................................................................14
Brakes.......................................................................................................................14
Maintenance...............................................................................................15
Brakes.......................................................................................................................15
Gears.........................................................................................................................16
Lubrication.................................................................................................................16
Cleaning your bike......................................................................................................16
Safety points..............................................................................................17
Repairing a puncture...................................................................................17
Removal of rear wheel................................................................................................17
Trouble shooting.........................................................................................18
Glossary.....................................................................................................19
BMS...........................................................................................................................19
Controller...................................................................................................................19
Display.......................................................................................................................19
Hall sensor.................................................................................................................19
Pedal Assist Sensor (PAS)............................................................................................19
2
Safety Instructions
Thank you for purchasing an
evinci
electric bike, designed by NZEBIKES. This
electric bicycle features the most recent innovation in technology and applies to
the AS/NZ standard. For safety reasons, it is most important that you read this
User Guide BEFORE you operate the bike. Improper handling can reduce its
riding performance and most importantly, pose danger to your safety and
health!
NZEBIKES is continuously updating and innovating this product. The printed
manual may therefore not always include the latest updates. However, we shall
make sure that our online manual will always be up to date on
www.evinci.nz/support.
We want also encourage you to register your bike with your
frame serial number. This allows us to help you finding your
bike in case of theft, as we get contacted by the police when
bikes are recovered.
To register just go to our
evinci
website and click on
“Login”.
Symbols
Please pay particular attention to information next to one of the symbols shown
below as it can be very important for your personal safety.
WARNING
This symbol indicates that improper handling poses a
risk to your health and safety
ATTENTION
This indicates that improper handling could damage
components and make
void the warranty.
NOTE
Points out to useful tips
3
Introduction
You have decided in favour of a Pedelec (Pedal Electric Cycle) - a bicycle that is
equipped with an electric motor to give you additional assistance when riding.
With this bicycle you can make better progress in headwinds, when
transporting heavy loads or on steep slopes.
You can select the level of power assistance required according to the weight of
your load and/or the prevailing road conditions, the effectiveness of the power
assistance depends on your pedal power and the level of assistance selected.
Before switching on the electric assistance system, please read the chapter
“Charging the battery”. The battery must be fully charged before you go for a
ride the first time.
Mode of operation and extent of electronic power assistance
As soon as you turn on the electric assistance system and begin pedalling or
twisting the throttle, electronic power assistance is available. Depending on the
selected assistance level the motor will add a certain amount of power to assist
you. The more you pedal on your own the less power the motor has to add,
which increases the all over range.
The pedal assistance does not measure your pedal effort, this means you can
relax when being exhausted and let the motor take over most of the work. Just
keep in mind that the battery will get sooner used up. An average rider can
easily reach on flat tracks up to 80km out of the standard 16Ah battery.
Levels of support
There are currently five support levels:
1 = 20%, 2 = 40%, 3 = 60%, 4 = 80%, 5 = 100%
With higher support the motor will reach also a higher speed.
What comes with the bike?
•240V mains charger
•LED handlebar mounted front light, battery operated
•A set of 2 keys for the battery lock
4
TUI / FALC N – components
1 LCD Control Display 5 Motor Controller
2 Throttle 6 Battery
3 Gear Changer 7 Battery Lock
4 Pedal Assist Sensor 8 Hub Motor
5
Robin Folding Bike
Remove battery for easier handling
1. Fold both pedals by pulling the inner lock while swiveling.
2. Fold down the steerer tube by pulling the lever (lift safety lock pin first).
Make sure no cables get jammed.
3. Fold frame: Lift lever, pull lever
out of notch. Lift pin to unlock
from frame.
4. Make sure left side pedal is
pointing backwards, bring
stand up, turn front part to the
back. Rest bike on bottom
bracket stand.
5. If you want to lay the bike
down for transport, lay it on
the right side.
6
Basic Safety Tips
Always pull the brakes and hold the handlebar firm and
straight before taking off in order to make sure you keep
control of the bike when power assistance is in action! NOTE
that power assistance is triggered off IMMEDIATELY as soon
as the crank moves slightly in riding direction. Also, keep in
mind that the right hand half-throttle is active. By pulling one
of the brakes the motor will be disengaged.
For your own road safety
●Always wear a suitable bike helmet
●Wear bright clothing or reflective elements to
be seen better by other road users
●Wear shoes with a non-slip sole
●Wear close-fitting clothing on your legs or
wear trouser clips
●Wear bicycle gloves
How to use your charger
To charge the battery your
evinci
bike comes with a 3Ah quick charger. Please
do not use any other charger.
If you want to charge your battery from a car or motor home
(12V systems), NZEBIKES or your retailer can supply a special
charger called PowerBuddy for this purpose.
Before you first use the charger please read the following notes regarding
safety carefully!
7
Ref (1)
•Keep the charger away from children!
•In order to prevent any possible injury this charger
should only be used for the original lithium battery
which is supplied together with the
evinci
e-bike
•Any other battery is not compatible and risks to explode
while charging, causing serious injury to people as well
as damage to other equipment
•Using this charger for batteries not supplied by
evinci
could risk catching fire, provoke electric shock and/or
cause serious injury
•Please make sure that the charger is always kept dry
and does not get wet at any time.
Should there be an incidence of contact with water or any other liquid, make
sure to unplug the charger immediately from the power socket and have it
inspected by your dealer.
Make sure the charger is always placed on a flat surface when in use. Please
make sure that the charger is always unplugged and removed from the power
socket when not in use.
Before using the charger, always make sure that the plug and the cables are
not damaged.
Never connect a damaged cable or plug to the power socket. Never try to
disassemble the charger. There are no serviceable parts in the charger.
Always unplug the charger before cleaning it. The charger should only be
cleaned with a dry cloth. Never use a wet cloth, oil or any other liquid. Only use
the original cable supplied with the charger.
8
The charger LED (1) indicates the battery status:
LED STATUS
green the battery is not connected
red the battery is charging
green the battery is charged, the charger has switched off
Before using your battery the first time, it has to be charged
once over night for at least 12 hours.
Safety notes concerning the battery
•Keep the battery out of reach for children
•Never try to open the battery. Apart from this being
dangerous, all warranty will be void
•Do not provoke a shortcut circuit with metal gadgets
•Remove the battery from the bike when transporting on
an external bike rack
•Do not dip the battery in water or any other liquid
•Do not keep the battery close to heat or open fire
•A battery needs to be re-cycled after use, never throw it
in an open fire as it could explode
•If the battery is damaged because it has been dropped
somewhere or because of a biking accident, there might
be a risk of an internal short-circuit
•Immediately stop using a damaged battery.
In order to maximise the use of this battery, please consider the following:
The battery will not charge when exposed to temperatures below +0°C or
above +60°C. It is therefore recommended to keep the battery at room
temperature before charging it.
The charger operates with a microcomputer system with automated control
functions. It automatically stops charging when the battery is full. It cannot be
damaged by overcharging.
None the less, we strongly recommend to always disconnect the power plug
from the wall socket after the battery is charged as power surges, i.e. lightning,
through the grid can damage the charger or battery electronics!
9
When storing the battery for a longer time period, (e.g. over winter) it is
important to place surface in a dry place. The battery should be re-charged
once every 3 month when it is not used. Negligence could lead to complete
discharge of the battery and this would void the warranty.
The discharging of the battery is due to chemical processes
which are taking place within the battery cells. How much a
battery discharges depends on the time it has not been used
and the temperature it has been exposed to. Thus, a re-
charge every 3 month, when not in use, is essential.
Charging the battery
You may charge the battery on the bike or remove it to a
more convenient place.
1. Open the rubber cover and connect the charger plug to the battery
2. Connect the power cord to a mains socket
3. Make sure to neatly close the charge port with the rubber cover to
prevent water from getting in
The charger will get warm while charging – do not cover while
in use as it might cause a malfunction.
How to remove and insert the battery
1. Removal: if the battery is locked, first unlock the battery
2. Swivel the seat to the front and pull the battery upwards till it unlocks
from the rail. Take it out.
3. Insert: Slide the battery into the battery rail, secure it in the frame with
the battery frame lock.
Make sure the battery is fully inserted in to the battery rail
and locked to prevent the battery from jumping out when
riding over bumpy ground
10
Este manual sirve para los siguientes modelos
3
Tabla de contenidos
Otros manuales de Bicicleta de Evinci
