Page 5
EVERSAN, INC. • 34 Main Street, Whitesboro, NY 13492 • 1-800-383-6060 Fax: 315-736-4058
www.eversan.com
Operating Instructions Wireless System
The following steps must be used to ensure proper communication from the 9650 wireless control
console and each scoreboard you want to control.
1. Turn on each 9658 Scoreboard that you want to control. The scoreboard(s) should display a dash
(-) in each numeric display.
2. Connect the antenna and 9VDC adapter provided to the wireless control console. (see diagram for
proper placement)
3. Turn on the control console. Once communication has been established the scoreboards will go
through an initial checkout.
4. To use another scoreboard with a different control console repeat steps 1 through 3.
There are two modes available for setting the scoreboard:
STOP MODE:
The scoreboard goes immediately into this mode when it is first powered up.
In this mode, you can perform all functions. ONLY in this mode can TIME and
PERIODS be set. From Go mode push green button on keypad.
GO MODE: From Stop mode push the green button on the keypad.
This is the mode used during game time. You may increment the HOME or GUEST score by one or
correct the score by holding the button down. You may set BONUS and POSESSION indicators. You
can control the optional SHOT TIMER function. The CLOCK can count down (or up) in this mode and
can be stopped and started.
TO SET THE TIME:
To set the TIME for game play, press STOP, then press the TIME button and enter five (5) digits
(minutes: seconds. tenths of seconds) on the keypad, i.e. 02:00.0 will be two minutes. If an error has
been made, press the TIME button and repeat the above procedure.
TO SET THE SCORE:
In the GO mode, the score is incremented by one when the corresponding HOME or GUEST button is
pressed. Also, the score will decrement when the HOME or GUEST button is held down.
NOTE: The home and guest score is displayed on the control console’s LCD.
Alternately, any score may be put on the board by pressing either the HOME or GUEST button and
entering the desired three digit score on the keypad, i.e. 26 would be entered as 026.
TO SET THE PERIODS:
You must be in the STOP mode to set the period. Press the PERIOD button on the keypad to light
a period. Each time the button is pressed and additional period lights up indicating a period is
activated.
NOTE: The control console’s LCD display will show each period change and then display the score.
