GT-800BT User’s Manual
EverMore Technology, Inc.
2F, No.7, R&D Road 1, Science-Based Industrial Park, Hsinchu, Taiwan, 300, R.O.C. http://www.emt.com.tw
Page 3
0. Quick Installation
1. Before using the battery, please put it in GT-800BT and have it recharged fully for 4 hours.
2. To Connect GT-800BT with PC or Notebook
2.1 To plug Bluetooth USB dongle into PC or Notebook
2.2 Check the COM port number used by Bluetooth Device. (Example: COM 6).
2.3 To run GT-800BT utility and set the right COM port number.
3. Pass Word for pair is “ 0000 “.
LED Indicators
BLUETOOTH LED (BLUE)
Light On/Off (Continued on): Pair Searching
Light On/Off (1 sec/1 sec): Linking completed
1. POWER CHARGE JACK
2. USB DOWNLOAD
1. GPS LED (GREEN)
2. MEMORY STORAGE LED
Light On/Off (Continued on): Acquiring Satellites
Light On/Off (1 sec/2 sec) : Position Fixed
Memory storage full LED (RED)
Memory storage full LED + GPS unfixed (ORANGE)
Memory storage full LED + GPS fixed (ORANGE
LED flashing) ( 1 sec on/ 2 sec off)
1. POWER BUTTON
GPS & Bluetooth LED off: Three presses
on power button and hold it for 3 sec
Bluetooth LED: Two presses on
power button and hold if for 3 sec
GPS LED: One press on the power
button and hold it for 3 sec
1.1
1.2
1.3
2. BATTERY STATUS LED (RED)
Light Off: Battery full or not in charging
Light On/Off (1 sec on /2 sec off): Battery low.
Turn off after 5 minutes - Press the power button - GPS light
will on and red light flashes under 10 sec - then turn off
Light On: In charging
IMPORTANT
The digital camera clock setting must be set according to the system time displayed on the computer
before taking the photo. This data is used to match the photos to their GPS positions. If the time is wrong in
your camera, the photos will be tagged in the wrong places.
