www.evacuatoralarms.com
Evacuator Synergy + TS Base Station Instructions
SYSTEM SET UP
Evacuator Synergy + Alert System Specification and user operating instructions.
Thank you for choosing the Evacuator Synergy + Wireless Alert system. In order for you to realise the
full potential and reliability of this Category One Wireless system it is vitally important that you read
this user manual in full before attempting to use the system. Failure to understand the correct
installation method and functions of the system may lead to intermittent and unreliable
connectivity.
We would be delighted to assist all Evacuator Alarm clients with free Telephone Support during
office normal hours. For assistance please contact our Technical Support Team on 0845 130 7258 or
alternatively email us on technical@evacuatoralarms.com
Specification Overview (All models)
Mains Powered Evacuator Synergy + TS Base Station which enables users to receive addressable
alerts, check system status and create zones from their Evacuator Synergy + System. Base Station is
navigated using the touch screen, three buttons & Manual Call Point. Indoor Use only, Mains
Powered Device
Fitting the Antenna
The antenna should now be fitted to the Silver TNC docking point located on the top of the unit. The
Antenna should be placed over the TNC connector and twisted in clockwise motion until it locates
into place. Test that it has been located correctly by gently pulling on the Antenna in an outwards
motion.
Connecting Power Supply
Attach the provided 3 pin plug adapter to the power supply. Now plug in the 3.5mm jack into the
socket on the top edge of the product. Now Switch on the wall socket, the unit will power up by
itself.
Please use the supplied 5v 2a power supply provided, failure to do so may damage the operation of
the product.
