Eurotherm 7000 Series Manual de usuario

Solid state

contactor

User Manual

7200

ENG

•DATAMANAGEMENT • CONTROLS • PROCESS AUTOMATION•

Two phase

Load Control

7000 Range

7200S

SMART CONTROLLER

THYRISTOR UNIT

CONTROLLING TWO PHASES

OF A THREE-PHASE LOAD

USER MANUAL

(electronic or mechanical, including photocopying and recording) without written permission from

Eurotherm is strictly prohibited.

7200S User Manual Ref.: HA176662 ENG - Issue 2 - 03/2009

7200S User Manual

Check characteristics

Wiring

Fan power supply

Apply control signal

Power on.

Check firing

Adjust DLF alarm

(if conditions met)

Normal operation

CHK/SET push button

Characteristics correspond

to product code

and specifications

Chapter 1

Supply protection,

protective earth (PE)Chapter 2

For fan cooled

solid state contactors Chapter 2

Chapter 2

Chapter 4

Alarms signaled Chapter 3

Chapter 3

DLF LEDs

DC logic signal :

'LDC' terminal block

AC logic signal :

'HAC' terminal block

4-20 mA analogue signal :

'ATP' terminal block

Chapter 2

ON, HEAT LEDs

Power:

Supply side :

terminals 1/L1, 3/L2

Load side :

terminals 2/T1, 4/T2

Chapter 2

Mounting DIN rail mounting or

Bulkhead mounting Chapter 2

Fuse protection Chapter 4

COMMISSIONING FLOWCHART

7200S user Manual iii

Contents

CONTENTS

Page

Commissioning flowchart . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .ii

European directives and applicable standards . . . . . . . . . . . . . . . . .iv

Chapter 1 Identification of solid state contactor . . . . . . . . . . .1-1

Chapter 2 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2-1

Chapter 3 Alarms . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3-1

Chapter 4 Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4-1

Eurotherm Limited ....................................5-1

PURPOSE OF MANUAL

This manual (Issue 2)describes the Basic Version and all Options for 7200S series solid state

contactors with current ratings up to 200 A.

7200S User Manual

EUROPEAN DIRECTIVES AND APPLICABLE STANDARDS

COMPLIANCE WITH PRODUCT STANDARD

7200S products comply with the terms of product standard EN 60947-4-3 ‘Contactors and

motor-starters - AC semiconductor controllers and contactors for non-motor loads’.

CE LABELLING

7200S products, installed and operated in accordance with their user manual, bear

CE labelling on the basis of compliance with the essential requirements of :

•the European Low Voltage Directive 73/23 EEC dated 19 February 1973

modified by 93/68 EEC dated 22 July 1993

•the Electromagnetic Compatibility Directive 89/336/EEC dated 3 May 1989

modified by 92/31/EEC dated 28 April 1992 and 93/68/EEC dated 22 July 1993.

SAFETY

The units have IP20 protection rating as defined by standard IEC 60529.

External wiring must comply with standards IEC 60364-4-43 and IEC 60943.

Copper cables and conductors must be used, rated to a temperature of 75°C (167°F).

ELECTROMAGNETIC COMPATIBILITY (EMC) TEST STANDARDS

7300S products installed and used in accordance with the user manual, are designed for

an industrial environment and not a commercial or light industrial premises and must

not be used in the home.

IMMUNITY

The EMC immunity test standards required by product standard EN 60947-4-3 are given

in the table following :

European directives and applicable standards

Test type Minimum level EMC test standard

Electrostatic discharge 4 kV on contact; 8 kV in air EN 61000-4-2

Radiated, radio frequency 10 V/m 80 MHz ≤f≤1 GHz ;

electromagnetic field 80% modulation 1 kHz sinusoid EN 61000-4-3

Electrical fast transient / burst 2 kV / 5 kHz EN 61000-4-4

Electrical Surge 4 kV line to earth

2 kV line to line EN 61000-4-5

Conducted disturbances 140 dBµV;150 kHz ≤f≤80 MHz EN 61000-4-6

Voltage dips and 5 s interruptions EN 61000-4-11

short interruptions

Table 1 EMC immunity standards compliance

7200S User Manual v

EMC GUIDE

To help you deal with installation-dependent electromagnetic interference effects,

Eurotherm provides an ‘Electromagnetic compatibility’ installation guide (ref. HA 025464)

which sets out best current practice regarding EMC.

DECLARATION OF CONFORMITY

ACE declaration of conformity is available on request.

European directives and applicable standards

EMISSIONS

The EMC emissions test standards required by product standard EN 60947-4-3 are given

in the table following :

Table 2 EMC emissions standards compliance

Emission type Firing mode EMC test standard

Radiated at radio All firing modes CISPR 11 Class A

frequencies

Conducted at radio All firing modes CISPR 11 Class A

frequencies Group 2

7200S User Manual

7200S User Manual 1-1

Identification

Chapter 1

1. IDENTIFICATION OF SOLID STATE

CONTACTOR UNITS

Contents Page

1.1. General presentation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-2

1.2. Technical specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-5

1.2.1. Use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-5

1.2.2. Power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-5

1.2.3. Load . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-5

1.2.4. Signalling . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-5

1.2.5. Firing Modes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-6

1.2.6. Inputs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-6

1.2.7. Control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-6

1.2.8. Alarms . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-7

1.2.8.1. DLF Otpion . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-7

1.2.8.2. Over temperatureAlarm.........................1-7

1.2.8.3. Alarm Relay . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-7

1.2.9. Protection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-7

1.2.10. Environment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-8

1.2.11. Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-8

1.2.12. Mounting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-8

1.2.13. Digital Communication . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-8

1.3. Coding . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-10

Identification

7200S User Manual

1-2

1. Chapter 1 IDENTIFICATION

1.1. GENERAL PRESENTATION

7200S series solid state contactors control the electrical power to three-phase industrial

loads such as low temperature coefficient and short wave infrared elements.

Standard ratings in the series range from 16 A to 200 A,at voltages from 200 V to 500 V.

7200S series solid state contactors comprise two channels, controlled by thyristors.

Depending on the type of control signal and the type of input specified, 2 operating modes

are available: logic (‘on/off ’) or modulation (‘Burst mode’).

Figure 1-1 General view of 7200S with digital communication control - ratings from 16 A to 63 A

GRF

DLF CHK

HEAT

SET

7200S

EUROTHERM

3/L2

4/T2

2/T1

1/L1

5/L3

6/T3

Protective earth

terminal

Power terminals

(supply)

Ratings

(nominal current

and nominal voltage)

Power terminals

(load)

Internal

power wiring

diagram

Control terminal

pinouts

Serious alarms

(if DLF option)

User labelling

Electronics supply

Zero crossing firing mode :

Firing request LED

Diagnostic alarm

(if DLF option)

63 A / 500 V

EN 60947-4-3

Communication Option :

Transmission LEDs and

configuration switches

ON/

Dxch

12345678

Control connector

DLF option :

CHK/SET

push button

ALR

1a 1b

73 74

COM

91 92

Aux1

230 N

16 17 18

Aux2

GND 24V 0VS

15 19 20

7200S User Manual 1-3

Identification

GRF

DLF CHK

HEAT

SET

7200S

EUROTHERM

3/L2

4/T2

2/T1

1/L1

5/L3

6/T3

80 A / 500 V

EN 60947-4-3

ALR

1a 1b

73 74

Aux1

230 N

16 17 18

Protective earth

terminal

Power terminals

(supply)

Power terminals

(load)

Internal

power wiring

diagram

Control terminal

pinouts

Serious alarms

(if DLF option)

Electronics supply

Zero crossing firing mode :

Firing request LED

Diagnostic alarm

(if DLF option)

Control connector

ATP

0VA R1

11 12

Figure 1-2 General view of 7200S with analogue control - ratings from 80 A to 100 A

Otros manuales para 7000 Series

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Controladores de Eurotherm

Eurotherm

Eurotherm 7000 Series Manual de usuario

Eurotherm

Eurotherm TE300 Series Manual de usuario

Eurotherm

Eurotherm 3500 series Manual de usuario

Eurotherm

Eurotherm P304c Manual de usuario

Eurotherm

Eurotherm SSD Drives 635 Manual de usuario

Eurotherm

Eurotherm TE200A Manual de usuario

Eurotherm

Eurotherm 2216e Manual de usuario

Eurotherm

Eurotherm Invensys Mini8 Manual de instalación y operación

Eurotherm

Eurotherm T940X Manual de funcionamiento

Eurotherm

Eurotherm P304c Manual de usuario

Eurotherm

Eurotherm EFit Manual de usuario

Eurotherm

Eurotherm Invensys 3216 Manual de usuario

Eurotherm

Eurotherm 7000 Series Manual de usuario

Eurotherm

Eurotherm 690+ Series Manual de usuario

Eurotherm

Eurotherm 506 Manual de usuario

Eurotherm

Eurotherm epack Manual de usuario

Eurotherm

Eurotherm 2604 Manual del propietario

Eurotherm

Eurotherm Invensys 3216 Manual de usuario

Eurotherm

Eurotherm 2100 Manual de usuario

Eurotherm

Eurotherm Invensys Mini8 Instrucciones de montaje

Eurotherm

Eurotherm 2704 Manual de usuario

Eurotherm

Eurotherm 902 Series Manual de usuario

Eurotherm

Eurotherm 808 Manual de usuario

Eurotherm

Eurotherm epack Manual de usuario

Manuales populares de Controladores de otras marcas

Digiplex

Digiplex DGP-848 Instrucciones de funcionamiento

YASKAWA

YASKAWA SGM series Manual de usuario

Sinope

Sinope Calypso RM3500ZB Manual de usuario

Isimet

Isimet DLA Series Style 2 Manual de instalación

LSIS

LSIS sv-ip5a Manual de usuario

Rockwell Automation

Rockwell Automation 1769-L31 Manual de usuario

Airflow

Airflow Uno hab Manual de usuario

ABB

ABB ACS580-01 drives Manual de usuario

Panasonic

Panasonic GM1 Series Manual de usuario

Emerson

Emerson SW93 Manual de usuario

AutoAqua

AutoAqua Smart ATO micro SATO-120P Manual de usuario

Panasonic

Panasonic FP? Positioning Unit RTEX Manual de usuario

Samson

Samson Type 5824 Manual de servicio

Alpha IP

Alpha IP MIOB 21001 Manual de usuario

Siemens

Siemens OpenAir GMA 1 Series Manual de usuario

Surecom

Surecom SR-629 Manual de usuario

Fishman

Fishman TriplePlay Manual de usuario

Regulus

Regulus SRS1 T Manual de usuario