6
3) Press “SELECT” key to choose “DC” or “AC” measurement.
4) Remove power from the circuit under test and open the normal circuit path
where the measurement is to be taken. Connect the meter in series with
the circuit.
5) Read the result from the LCD panel.
3.4 Resistance Measurement
1) Connect the black test lead to "COM" socket and red test lead to the "VΩ"
socket. The LCD will display sign of the test lead connect to socket.
2) Set the selector switch to desired “ ” position.
3) Connect tip of the test leads to the points where the value of the resistance
is needed.
4) Read the result from the LCD panel.
Note:
When take resistance value from a circuit system, make sure the power is cut
off and all capacitors need to be discharged.
3.5 Diode and Audible continuity Test
1) Connect the black test lead to "COM" socket and red test lead to the "VΩ"
socket. The LCD will display sign of the test lead connect to socket.
2) Set the selector switch to desired “ ” position.
3) Press “SELECT” key to choose Diode or Audible continuity measurement.
4) Connect the test leads across the diode under measurement, display shows
the approx. forward voltage of this diode.
5) Connect the test leads to two point of circuit, if the resistance is lower than
approx. 30Ω, the buzzer sounds.
Note:
Make sure the power is cut off and all capacitors need to be discharged
under this measurement.
3.6 Battery Test
1) Connect the black test lead to "COM" socket and red test lead to the
"BATmA" socket. The LCD will display sign of the test lead connect to
socket.
2) Set the selector switch to desired “1.5V” or “9V” position.
3) Connect the probe across the source or load under measurement.
4) Read the result from the LCD panel.
3.7 Data Hold
On any range, press the “D.H” key to lock display value, and the “DH” sign will
appear on the display, press it again to exit.
3.8 MAX Hold
Press the “M.H” key to lock MAX value, and the “MH” sign will appear on the
