ETC CLARETTE GANGING Manual de usuario
LifeWorkEtc.com
800-634-9514
PN 3385780, Rev -
STEP 01
CLARETTE GANGING A S S E M B LY
THE GANGING STRAP CONSISTS OF A “FIGURE 8” SHAPE WITH VELCRO ON BOTH SIDES OF ONE END.
IT ATTACHES TO THE STEM OF THE GLIDES USED ON THE CLARETTE SEATS AND OTTOMANS.
NOTE: REMOVE THE SMALL METAL SPACER FROM THE GANGING STRAP.
THE WASHER, METAL SPACER, AND MOUNTING SCREW INCLUDED IN THE KIT ARE NOT NEEDED.
CAREFULLY TURN THE SEAT/OTTOMAN ON ITS SIDE.
UNSCREW THE GLIDE FROM THE SEAT/OTTOMAN. PUSH GLIDE STEM THROUGH THE HOLE OF THE GANGING STRAP
MAKING SURE THAT THE “THIS SIDE UP” LABEL IS FACING UP. SCREW GLIDE BACK ON THE SEAT/OTTOMAN.
REPEAT UNTIL THE DESIRED AMOUNT OF GANGING STRAPS ARE ATTACHED TO THE SEAT/OTTOMAN.
GLIDE STEM
GANGING STRAP
GLIDE
LifeWorkEtc.com
800-634-9514
PN 3385780, Rev -
CLARETTE GANGING A S S E M B LY
STEP 02
REPEAT STEP 1 ON ALL SEATS/OTTOMANS THAT ARE TO BE GANGED.
TO USE THE GANGING STRAPS, MOVE THE SEATS/OTTOMANS INTO POSITION NEXT TO EACH OTHER. SEATS/
OTTOMANS MUST BE POSITIONED SO THE STRAPS ON ONE SEAT/OTTOMAN CAN REACH THE ATTACHMENT POINTS
OF THE STRAPS ON ANY ADJACENT SEAT/OTTOMAN. TURN STRAPS TOWARDS EACH OTHER AND FIRMLY PRESS
VELCRO ENDS TOGETHER.
WHEN GANGING STRAPS ARE NOT IN USE, SIMPLY ROTATE THEM OUT OF VIEW UNDER THE SEAT/OTTOMAN.
Tabla de contenidos
Otros manuales de Rack y soporte de ETC
ETC
ETC OneTrack by ETC Manual técnico
ETC
ETC Sensor+ SR Series Manual de usuario
ETC
ETC Unison Paradigm P-TS7 Manual de usuario
ETC
ETC EOS Manual de usuario
ETC
ETC Emphasis 4200A2009 Manual de usuario
ETC
ETC ESR3 Series Manual de usuario
ETC
ETC P-TS18-RM Manual de usuario
ETC
ETC Sensor 3 Manual de usuario
ETC
ETC sensor+ CEM+ Manual de usuario
ETC
ETC LIZANNE SINGLE Manual de usuario
