2Source 4
WRD
PAR or PARNel
Safety
The Source 4WRD PAR or PARNel fixture is intended for professional use only.
Read the entire manual before using this equipment.
WARNING:
Note the following safety warnings before use:
• Do not mount the fixture on or near a flammable
surface.
• Do not use the fixture below 5°C (41°F).
• Minimum storage temperature is 5°C (41°F). When the
fixture has been stored or transported in cold
temperatures, allow it to warm to room temperature
for a minimum of 1 hour before applying power.
Applying power to a cold fixture will cause damage to
the fixture and void ETC warranty.
• Do not use this fixture with a damaged power lead. If
the power lead (cord set) is damaged, it must be
replaced.
• Do not use this fixture if glass lens is deeply scratched
or cracked. Damaged lenses must be replaced.
• To prevent wiring damage, or abrasion, do not expose
wiring to edges of sheet metal or other sharp objects.
• Use the fixture in dry locations only, where humidity
does not exceed 90 percent (non-condensing). These
fixtures are not intended for outdoor use.
• Mount and support the fixture only by the primary
suspension holes in the yoke.
• Suspend the fixture from a suitable structure using
only hardware rated for the weight of the fixture.
• In addition to primary suspension, attach a safety cable
(ETC Model 400SC or other approved safety cable or
device) to the fixture housing. An appropriate
attachment point (hole) is provided in the protruding
tab on the fixture housing.
• Disconnect the unit from power and DMX and allow
the fixture to cool before removing or installing
accessories, and for performing all cleaning and
maintenance.
