TELEMETRY AND SETTINGS
The device is compatible with JETIBOX and you can use it for programming. The JETIBOX menu is divided into
three sections:
Actual values –displays the latest telemetry values (current, voltage, capacity, temperature) together
with minimums and maximums.
oIn the Capacity screen, you can press left+right buttons together to reset the measured capacity.
oReset Min/Max - press left+right buttons together to reset all minimums and maximums.
Setting –basic settings of the sensor
oLanguage –you can choose the language of the JETIBOX screen.
oSwitch type (Touch/Standard) –Only Voltario T30. You can specify which type of switch will be
used to the device on and off.
oTouch sensitivity –if the touch switch is used, you can increase its sensitivity by editing this
value. Please note that increasing the sensitivity will allow you to install the Voltario directly
inside thicker fuselages. On the other hand, this will also make the touch sensor more
vulnerable to erroneous inputs.
oCapacity reset –Setting up this parameter will specify at which moment the capacity is reset to
zero. Available options:
Power-On (default) –capacity is reset every time after connecting the battery.
Voltage-Change –capacity is reset after connecting the battery with different voltage (by
15% or more). This way the sensor may distinguish between charged and discharged
battery.
Manual –capacity is never reset automatically.
oShutdown voltage (T30) –you can specify the minimum voltage for safe operation of the
model. If the voltage goes below the specified level for more than 30 seconds, the Voltario will
shut down.
oShutdown current (only S30) –you can specify the maximum allowed current before the
Voltario shuts down the load. By default, after reaching the shutdown current, it takes
approximately 0.5 seconds before the fuse reacts. But the overcurrent shutdown reacts
proportionally faster if the current is higher.
Service –In this menu you can view the device version and reset it to the default factory configuration.
