ESC EPC-600-ST Manual de usuario

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS PRODUCT TO RAIN

OR MOISTURE. DO NOT INSERT ANY METALLIC OBJECTS THROUGH THE VENTILATION GRILLS OR

OTHER OPENINGS ON THE EQUIPMENT.

EXPLANATION OF GRAPHICAL SYMBOLS

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended

To alert the user to the presence of un-insulated "dangerous voltage" within the

product's enclosure that may be of sufficient magnitude to constitute a risk of electric

shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to

The presence of important operating and maintenance (servicing) instruction in

the literature accompanying the product

WARNING

CAUTION

FCC COMPLIANCE STATEMENT

FCC INFORMATION: THIS EQUIPMENT HAS BEEN TESTED AND FOUND TO COMPLY WITH THE

LIMITS FOR A CLASS A DIGITAL DEVICE, PURSUANT TO PART 15 OF THE FCC RULES. THESE

LIMITS ARE DESIGNED TO PROVIDE REASONABLE PROTECTION AGAINST HARMFUL

INTERFERENCE WHEN THE EQUIPMENT IS OPERATED IN A COMMERCIAL ENVIRONMENT. THIS

EQUIPMENT GENERATES, USES, AND CAN RADIATE RADIO FREQUENCY ENERGY AND IF NOT

INSTALLED AND USED IN ACCORDANCE WITH THE INSTRUCTION MANUAL, MAY CAUSE HARMFUL

INTERFERENCE TO RADIO COMMUNICATIONS. OPERATION OF THIS EQUIPMENT IN A

RESIDENTIAL AREA IS LIKELY TO CAUSE HARMFUL INTERFERENCE IN WHICH CASE THE USER

WILL BE REQUIRED TO CORRECT THE INTERFERENCE AT HIS OWN EXPENSE.

CAUTION: CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE

FOR COMPLIANCE COULD VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT.

CE COMPLIANCE STATEMENT

WARNING

THIS IS A CLASS A PRODUCT. IN A DOMESTIC ENVIRONMENT THIS PRODUCT MAY CAUSE RADIO

INTERFERENCE IN WHICH CASE THE USER MAY BE REQUIRED TO TAKE ADEQUATE MEASURES.

•FEATURES -------------------------------------------------------------------------- 5

•CONSTRUCTION ------------------------------------------------------------------ 6

•DIP SWITCH SETTING ----------------------------------------------------------- 7

-Communication

-Protocol

- PTZ address

•CABLE CONNECTION ---------------------------------------------------------- 9

•MAIN SETUP MENU ------------------------------------------------------------ 11

(1) Motion Setting ----------------------------------------------------------------------- 11

Preset ------------------------------------------------------------- 11

Tour ------------------------------------------------------------ 12

Scan ------------------------------------------------------------ 13

Pattern ------------------------------------------------------------ 14

Alarm ------------------------------------------------------------ 15

Area ------------------------------------------------------------ 16

(2) Dome Setting --------------------------------------------------------------------- 17

(3) Camera Setting --------------------------------------------------------------------- 19

(4) Clear Data --------------------------------------------------------------------------- 20

(5) Vector Initialize --------------------------------------------------------------------- 20

USING KEYBOARD CONTROLLER ------------------------------------------- 21

SPECIFICATIONS ---------------------------------------------------------------- 27

DIMENSIONS ---------------------------------------------------------------------- 29

CONTENTS

FEATURES

•Builtin stabilizer to use vibration area or Military zone, etc - optional

•Fire engine, Police car and other special applications

•Built-in 27x Optical DayNight zoom camera and Endless PanTilt driver

•Aluminum body and resistance lens cover (Crystal)

•MAX. 100˚/sec Pan speed

•Builtin MPEG-4 / IP PTZ server to use plug-in & play by client PC by using LAN

or WAN Network line (TCP / IP)

•System function

Preset - Up to 63 programmable preset.

Scan - Repeatedly pan & tilt operating between two positions. (Max. 4)

Tour – Up to 8 programmable Tours consisting of presets with individual dwell time..

Pattern - Up to 2 programmable Patterns memorized the PTZ movement.

Area – Up to 4 programmable Area display set.

Alarm- Move the camera to programmed Preset position with Alarm trigger (Max. 2)

•Variable speed Pan/Tilt control

In manual mode, sophisticated operating is possible at zoom in state by speed correcting function.

•Position Auto Return (Park Action)

After passing some time at manual operating, returning to the pre-set position.

•OSD(On Screen Display)

Displays camera ID , area name, preset No.and kinds of camera functions on screen.

•Various Function Switch

1. Convertible to RS485 and RS 232C by DIP switch.

2. Protocol convert switch

By using DIP switch, P-D(2400bps), and P-P(4800bps) protocol can be converted and various

baud rate can be matched by auto detection.

3. Supports up to 255 address

CONSTRUCTION

DIP SWITCH SETTING

•System setting

NO 1,2. Communication Protocol Select

1:On/2:Off -> P-D , 1:Off/2:On -> P-P

NO 3,4,5,6. Reserved

NO 7. Video format select (NTSC/PAL), Keep this as factory default.

NO 8. Select mounting type. (Top mount/Ceiling mount)

On : Ceiling Mount / Off : Pole, Car roof, or desk mount.

•Camera Address Select

Refer to the next page(8-page) camera address setting

•Termination Resistance Switch

Whether it is a PT camera or keyboard controller, the device which is connected at the

end of the line must have the cable communication terminated by setting the

appropriate DIP switch. Without proper termination, there is potential for control signal

errors. Total length of the cable for communication should not exceed 1.2Km.

•RS-485 communication

RS-485 communication is used to control the PTZ camera. For multiple camera connection &

control, user should assign camera address through this DIP switch.

Standard : RS-485 with MAX. 256 Camera Control

Number of wire : 2 Wire (D+, D-)

Protocol : D-Protocol, P-protocol

•D Protocol ?

Baud Rate : 2400 bps

Data Format : Asynchronous, 1 start bit, 8 data bits, non parity, 1 stop bit

Topology : Daisy-chain

etc : Refer to -D Specification

Protocol and System Set

Camera Address Set

12345678

CAMERA ADDRESS SETTING

Address MSB LSB Address MSB LSB Address MSB LSB Address MSB LSB

- 0 0 64 4 0 128 8 0 192 C 0

1 0 1 65 4 1 129 8 1 193 C 1

2 0 2 66 4 2 130 8 2 194 C 2

3 0 3 67 4 3 131 8 3 195 C 3

4 0 4 68 4 4 132 8 4 196 C 4

5 0 5 69 4 5 133 8 5 197 C 5

6 0 6 70 4 6 134 8 6 198 C 6

7 0 7 71 4 7 135 8 7 199 C 7

8 0 8 72 4 8 136 8 8 200 C 8

9 0 9 73 4 9 137 8 9 201 C 9

10 0 A 74 4 A 138 8 A 202 C A

11 0 B 75 4 B 139 8 B 203 C B

12 0 C 76 4 C 140 8 C 204 C C

13 0 D 77 4 D 141 8 D 205 C D

14 0 E 78 4 E 142 8 E 206 C E

15 0 F 79 4 F 143 8 F 207 C F

16 1 0 80 5 0 144 9 0 208 D 0

17 1 1 81 5 1 145 9 1 209 D 1

18 1 2 82 5 2 146 9 2 210 D 2

19 1 3 83 5 3 147 9 3 211 D 3

20 1 4 84 5 4 148 9 4 212 D 4

21 1 5 85 5 5 149 9 5 213 D 5

22 1 6 86 5 6 150 9 6 214 D 6

23 1 7 87 5 7 151 9 7 215 D 7

24 1 8 88 5 8 152 9 8 216 D 8

25 1 9 89 5 9 153 9 9 217 D 9

26 1 A 90 5 A 154 9 A 218 D A

27 1 B 91 5 B 155 9 B 219 D B

28 1 C 92 5 C 156 9 C 220 D C

29 1 D 93 5 D 157 9 D 221 D D

30 1 E 94 5 E 158 9 E 222 D E

31 1 F 95 5 F 159 9 F 223 D F

32 2 0 96 6 0 160 A 0 224 E 0

33 2 1 97 6 1 161 A 1 225 E 1

34 2 2 98 6 2 162 A 2 226 E 2

35 2 3 99 6 3 163 A 3 227 E 3

36 2 4 100 6 4 164 A 4 228 E 4

37 2 5 101 6 5 165 A 5 229 E 5

38 2 6 102 6 6 166 A 6 230 E 6

39 2 7 103 6 7 167 A 7 231 E 7

40 2 8 104 6 8 168 A 8 232 E 8

41 2 9 105 6 9 169 A 9 233 E 9

42 2 A 106 6 A 170 A A 234 E A

43 2 B 107 6 B 171 A B 235 E B

44 2 C 108 6 C 172 A C 236 E C

45 2 D 109 6 D 173 A D 237 E D

46 2 E 110 6 E 174 A E 238 E E

47 2 F 111 6 F 175 A F 239 E F

48 3 0 112 7 0 176 B 0 240 F 0

49 3 1 113 7 1 177 B 1 241 F 1

50 3 2 114 7 2 178 B 2 242 F 2

51 3 3 115 7 3 179 B 3 243 F 3

52 3 4 116 7 4 180 B 4 244 F 4

53 3 5 117 7 5 181 B 5 245 F 5

54 3 6 118 7 6 182 B 6 246 F 6

55 3 7 119 7 7 183 B 7 247 F 7

56 3 8 120 7 8 184 B 8 248 F 8

57 3 9 121 7 9 185 B 9 249 F 9

58 3 A 122 7 A 186 B A 250 F A

59 3 B 123 7 B 187 B B 251 F B

60 3 C 124 7 C 188 B C 252 F C

61 3 D 125 7 D 189 B D 253 F D

62 3 E 126 7 E 190 B E 254 F E

63 3 F 127 7 F 191 B F 255 F F

Main Menu window will appear.

Main Menu

JOYSTICK

1 + Quick Operating Guide

Flip : 90 +

Auto Flip ON : 93 + 3sec.

Auto Flip OFF : 94 + 3sec.

Move initial position : 93 +

Menu Start : 95 +

95 + PRESET

JOYSTICK

or NEAR

** Move the joystick up and down to navigate through the menu items.

Push the NEAR key or move joystick to the right to select a menu item.

PRESET

Main Setup-menu

MAIN MENU

---------

MOTION SETTING ▶

DOME SETTING ▷

CAMERA SETTING ▷

CLEAR DATA ▷

VECTOR INIT

EXIT

SELECT→NEAR/RIGHT ▷ SUB MENU

MOTION MENU

-----------

PRESET ▶

TOUR ▷

SCAN ▷

PATTERN ▷

ALARM ▷

AREA ▷

BACK

EXIT

SELECT→NEAR/RIGHT ▷ SUB MENU

DOME MENU

-----------

TITLE SET : CPAN 20.011

AUTO FLIP ON

POWER UP ACTION ON

PARK ACTION ▷

DISPLAY ON/OFF ▷

SPEED BY ZOOM ON

FACTORY SET ▷

BACK

EXIT

SELECT→NEAR/RIGHT

CAMERA MENU

-----------

FOCUS MODE ▶

WHITE BALANCE ▷

EXPOSURE ▷

DAY & NIGHT : DAY

SHARPNESS : 10

BACKLIGHT : OFF

CAMERA DEFAULT

BACK

EXIT

SELECT→FOCUS MODE SETTING

DATA CLEAR

--------------------

PRESET

TOUR

AREA

ALARM

SCAN

PATTERN

BACK

EXIT

SELECT→NEAR/RIGHT

Tabla de contenidos

Manuales populares de Cámara de seguridad de otras marcas

Okina USA

Okina USA SIR36-870VF650LP Manual de usuario

Divio

Divio NDR155PA Manual de usuario

Canon

Canon VB-C500D Manual de usuario

Easy Access

Easy Access EasyGuard Manual de usuario

Vivotek

Vivotek FD9389-EHV-v2 Manual de usuario

TUYA

TUYA COSMO W2 Manual de usuario

Eusso

Eusso UNC7500-IR Guía de configuración

urmet domus

urmet domus 1096/204 Manual de usuario

VC VC20 series Manual de usuario

Axis

Axis Q1614 Manual de usuario

ieGeek

ieGeek DD201 Manual de usuario

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Manual de usuario

Vicon

Vicon V662-D-1 Instrucciones de funcionamiento

Grundig

Grundig GCH-K0274P Manual de usuario

Lorex

Lorex VANTAGE LBC7032 Manual de usuario

4xem

4xem WPT Manual de usuario

Samsung

Samsung SCV-3082 Manual de usuario

Vitek

Vitek VTC-C544 Manual de usuario