EROAD CoreHub Xtreme Manual de usuario
EROAD
EROAD CoreHub Xtreme
Install Guide
Thermo King, AUS, NZL
Technical support
USA 1-855-503-7623 [email protected]
AUS 1800 437 623 [email protected]
NZL 0800 437 623 [email protected]
Parts & equipment
CoreHub Xtreme (the ‘unit’)
Trailer & reefer Smart harness
External antenna
Bracket
Zip ties, screws
•
•
•
•
•
•
1.
2.
3.
Required tools
Socket/ Spanner set
Side cutters
Impact driver and hex bits
18/20ga butt splice crimping tool
Propane torch
Platform to safely reach the top of the reefer
Pre-prep
Start the reefer to ensure it’s working with no
console alarms.
Ensure the reefer has its iBOX/REB/Bluebox 1
or 2 firmware updated.
Use the Safety Lockout Procedure -
disconnect any AC power source and battery
NEGATIVE.
A ladder is fine for heights up to 2 m (7
ft) but should not be considered safe
for reaching the top of a reefer. Where
possible, use a scissor-lift, forklift
basket, or similar stable, load-bearing
platform.
•
Mount the unit
For SR4 units, mount the unit to the front of the
trailer above the battery.
Bracket
Precedent
•
•
Legacy units
For legacy units (SR3 and before), mount the
unit vertically on the upper half of the reefer
next to the condenser inflow (above the
display).
Keep the unit and cables away from hot or
moving parts, and high voltage lines (usually
colored orange).
•
•
Mount the antenna
Attach the antenna to the top of the reefer or
the side front of the trailer. It should directly
see the sky.
Run the cables into the controller
enclosure
Open the Precedent control compartment
cover. Unscrew the cable cover to push the
cables through to reach the power and data
connections. In legacy models, remove the fuse
cap to push the cables through a round hole.
1.
2.
1.
2.
Plug the unit into the
reefer 3rd party port
The unit’s harness has connectors for reefer
data and fuel sensor. It plugs into the 3rd
party communications port located inside the
reefer controller module.
Depending on the reefer type and readiness
for telematics it may be necessary to do
additional work to add this port to the reefer.
This is described in additional documentation
covering legacy, I-Box, REB and Blue-Box
connections.
Connect reefer power
Connect the BLACK ground ring to the “CH”
stud on the reefer controller board.
Connect the RED power ring at the “2” stud on
the reefer controller board.
1.
2.
Reefer on; look for a
solid red light
Reconnect the battery.
Use the displayed table to troubleshoot the
unit’s status.
Color Flash Desc
Pink Solid Bootup
Blue Solid Starting Services
Green Solid /Ignition
On
Disconnected from
Cloud
Red Flashing /
Ignition Off
Connecting to Cloud
Red Solid /Ignition
Off
Connected to Cloud
Orange Flashing /
Ignition On
Connecting to Cloud
Orange Solid /Ignition
On
Connected to Cloud
Otros manuales para CoreHub Xtreme
1
Tabla de contenidos
Otros manuales de Accesorios para automóviles de EROAD
