Epson STYLUS 850Ne Manual de usuario

Setup Guide

Printed on recycled paper with at least 10% post-consumer content

any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior

written permission of SEIKO EPSON CORPORATION. The information contained herein is designed only for use

with this EPSON printer. EPSON is not responsible for any use of this information as applied to other printers.

Neither SEIKO EPSON CORPORATION nor its affiliates shall be liable to the purchaser of this product or third

parties for damages, losses, costs, or expenses incurred by purchaser or third parties as a result of: accident, misuse,

or abuse of this product or unauthorized modifications, repairs, or alterations to this product, or (excluding the

U.S.) failure to strictly comply with SEIKO EPSON CORPORATION’s operating and maintenance instructions.

SEIKO EPSON CORPORATION shall not be liable for any damages or problems arising from the use of any options

or any consumable products other than those designated as Original EPSON Products or EPSON Approved

Products by SEIKO EPSON CORPORATION.

EPSON and EPSON Stylus are registered trademarks ofSEIKO EPSON CORPORATION.

General Notice: Other product names used herein are for identification purposes only and may be trademarks of

their respective owners. EPSON disclaims any and all rights in those marks.

10/98

Setup Guide

This Setup Guide summarizes the process of setting up your

printer and configuring it to work with most networks. For

more information about your printer and printer software, see

your User’s Guide. For more information about your printer’s

Ethernet card and networking, see the Administrator’s Guide.

Using Your Software

Your printer comes with the following software:

◗Printer driver for Windows®and Macintosh®

◗EPSON Net!2 utility (for Windows®98, Windows®95,

Windows NT®4.0, and Macintosh) that allows you to

configure your printer for protocols including Novell®

NetWare,®TCP/IP, and AppleTalk.®

◗EPSON Status Monitor 2 for Windows that allows you to

monitor your printer over the network and use TCP/IP for

printing in Windows 98/Windows 95 peer-to-peer

networks.

◗EPSON Driver Disk Creation Utility that lets you create

diskettes for systems that don’t have CD-ROM drives.

Setup Guide: Setup Overview

Setup Overview

4Follow the steps in this guide to set up the printer, install

the ink cartridges, and connect your Ethernet card to the

network.

5Install the Network Software

See page 3 to determine whether you should install

EPSON Net!2 and EPSON Status Monitor 2 for your

protocol and operating system.

6Configure the Printer

See page 3 to determine where you should look in this

Setup Guide and the Administator’s Guide to configure

the printer and Ethernet card to work on your network.

7Set Up the Workstations

For most networks, you need to install the printer driver

on each Windows or Macintosh workstation that uses

the printer. If you like, you can also install EPSON

Status Monitor 2 on Windows workstations.

8Print a Test Page

You can print a test page in Windows 98, Windows 95

or Windows NT 4.0. This ensures that the network,

printer, and printer driver are configured correctly and

working.

Note:

If you need to make diskettes

and use them to install any

software programs, see

Appendix A in your

Administrator’s Guide

Setup Guide: Network Configurations

Network Configurations

See the table below to find your network configuration

(operating system and protocol), and determine what to install

and where to find instructions for configuring your network.*

For many operating systems, you can change configuration

settings using the Ethernet card’s internal home page. See the

Administrator’s Guide for more information.

Available Network Configurations

Operating

system Network

protocol What you need to install and configure

Windows NT 4.0

(Service Pack 3,

or higher)

TCP/IP 1. EPSON Net!2 (p.11)

2. EPSON Status Monitor 2 (p. 13)

3. IP address for the Ethernet card (p. 28)

4. Printer driver on each workstation** (p. 36)

NetBEUI

(TCP/IP must

also be installed)

1. EPSON Net!2 (p.11)

2. EPSON Status Monitor 2 (p.13)

3. IP address for the Ethernet card (p. 28)

4. NetBEUI settings on the Ethernet card home page***

(p. 34)

5. Printer driver on each workstation** (p. 36)

Novell NetWare 1. EPSON Net!2 (p.11 and p. 16)

2. EPSON Status Monitor 2 (p.13)

3. Setup using NwAdmin (p. 16) or

PCONSOLE (

Administrator’s Guide

, Chapter 4)

4. Printer driver on each workstation** (p. 36)

Setup Guide: Network Configurations

*If you need to create diskettes and install your software from them, see Appendix A in your

Administrator’s Guide

**If you have Windows NT 4.0 Server, you may only need to install the driver on the server. See

your Windows NT documentation.

***To use the Ethernet card home page, you must have TCP/IP setup on your network, as well as

one of the following Internet browsers: Microsoft Internet Explorer, version 4.0 or later; Netscape

NavigatorTM, version 3.0 or later.

Windows 98,

Windows 95 TCP/IP 1. EPSON Net!2 (p.11)

2. EPSON Status Monitor 2 on each workstation (p. 13)

3. IP address for the Ethernet card (p. 28)

4. Printer driver on each workstation (p. 36)

NetBEUI

(TCP/IP must

also be installed)

1. EPSON Net!2 (p.11)

2. EPSON Status Monitor 2 (p.13)

3. IP address for the Ethernet card (p. 28)

4. NetBEUI settings on the Ethernet card home page***

(p. 34)

5. Printer driver on each workstation (p. 36)

Novell NetWare 1. EPSON Net!2 (p.11 and p. 16)

2. EPSON Status Monitor 2 (p.13)

3. Setup using NwAdmin (p. 16) or

PCONSOLE (

Administrator’s Guide

, Chapter 4)

4. Printer driver on each workstation (p. 36)

Windows 3.1x Novell NetWare,

Windows NT

Server

Windows 3.1x acts as a client only; you can’t use a Windows

3.1x workstation to configure theEthernet cardor monitor the

printer. Install the printer driver on each workstation and

change the printer’s port setting. (p. 36)

Macintosh AppleTalk 1. EPSON Net!2 (p. 13 and p. 32)

2. Printer driver on each system (p. 36)

UNIX TCP/IP (lpr, ftp) 1. Install a printer driver and filter. (See your UNIX

documentation.)

2. Configure the printer for lpr or ftp.

(

Administrator’s Guide,

Chapter 5. )

IBM OS/2 Warp NetBEUI

(Administrator’s Guide

, Chapter 6.)

TCP/IP

(Administrator’s Guide

, Chapter 6)

Available Network Configurations

Operating

system Network

protocol What you need to install and configure

Setup Guide: Set Up the Printer

Set Up the Printer

Unpack the Printer

Remove any packing material from the printer. See the Notice

Sheet in the box for details.

Make sure you’ve got all these items:

◗Your printer and paper support

◗One color and one black ink cartridge package

◗The EPSON Stylus®COLOR 850Ne CD-ROM

◗The EPSON Media Pak containing sample ink jet paper

◗Your User’s Guide and Administrator’s Guide

◗A network cable (not supplied)

Note:

To connect your printer’s

Ethernet card to the

network, you need a twisted

pair (10BaseT) cable with an

RJ-45 connector.

paper support

black ink

cartridge

color ink

cartridge

CD-ROM

Administrator’s

Guide

User’s Guide

Setup Guide: Set Up the Printer

Attach the Paper Support

Insert the paper support in the top slot on the back of the

printer.

Do not put the printer:

◗In an area with high temperature or humidity

◗In direct sunlight or dusty conditions

◗Near sources of heat or electromagnetic interference, such

as loudspeakers or cordless telephone base units

Install the Ink Cartridges

1. Make sure the printer is turned off (the

Ppower button

should be up). Then plug the printer’s power cord into a

grounded outlet.

Note:

Follow all the safety

instructions in the

Introduction of your

User’s

Guide

Caution:

Always use the Ppower

button to turn the printer on

or off. Never use the external

switch on a power strip.

Don’t use an outlet controlled

by a wall switch or timer, or

one that uses the same

circuit as a large appliance.

This may disrupt the power,

which can erase memory or

even damage the power

supply.

power button

Setup Guide: Set Up the Printer

2. Remove the ink cartridges from their foil packages. Then

remove only the yellow part of the tape seal on the top of

each one. Don’t pull off the white portion or try to

remove the clear seal underneath the cartridge.

3. Press the

Ppower button to turn on the printer. The

Ppower light flashes and the

Band

Iink out lights come

on. The black ink cartridge holder moves into loading

position.

4. Open the printer cover and lift up the black ink cartridge

clamp.

5. Place the black ink cartridge in the holder as shown. Then

close the clamp, making sure it clicks into place.

Caution:

To ensure the print heads

chargecorrectly, install the

ink cartridges that came

with your printer.

You must remove the

yellow tape from the top

of the cartridge or you will

permanently damage it.

It’s okay if a small corner

of the yellow tapestays on

the cartridge.

Remove the yellow tape

seal

Don’t remove the

white portion

Warning:

If ink gets on your hands,

wash them thoroughly with

soap and water. If ink gets

in your eyes, flush them

immediately with water.

black ink

cartridge holder

Setup Guide: Set Up the Printer

6. Now press the

Xcolor cleaning button to move the color

ink cartridge holder into loading position.

7. Repeat steps 4 and5 to install the color ink cartridge.Then

press the

Eload/eject button to begin charging the ink

delivery system.

The printer moves the print heads and begins charging the ink

delivery system. The

Ppower light flashes, and the printer

makes various sounds.

Charging takes up to 4 minutes. Don’t turn off the printer or

interrupt this important process or you’ll use up more ink

than necessary.

When it’s finished, you can close the printer cover.

Load Paper

1. Open the output tray extensions and slide the left edge

guide all the way to the left.

Caution:

If the ink cartridge holder

moves back to the right

before you install the

cartridge, don’t try moving

it back by hand. Press the

Bblack cleaning button and

hold it down for 3 seconds

to move the holder back

into position.

Never turn off the printer

when the Ppower light is

flashing, unless the printer

hasn’t moved or made any

noise for more than 10

minutes.

Otros manuales para STYLUS 850Ne

Tabla de contenidos

Otros manuales de Impresora de Epson

Epson

Epson LX-350 Manual de usuario

Epson

Epson R1900 - Stylus Photo Color Inkjet Printer Manual de usuario

Epson

Epson Stylus NX510 Manual de usuario

Epson

Epson XP-430 Manual de usuario

Epson

Epson Stylus Photo R270 Series Manual de instrucciones

Epson

Epson Stylus Scan 2500 Manual de usuario

Epson

Epson ActionLaser 1600 Hoja de instrucciones

Epson

Epson SC-p400 series Manual de instrucciones

Epson

Epson ES-200 Manual de usuario

Epson

Epson XP-600 Manual de usuario

Epson

Epson C4100 - AcuLaser Color Laser Printer Manual de usuario

Epson

Epson XP-4100 Manual de usuario

Epson

Epson SC-P20000 SERIES Manual de usuario

Epson

Epson Stylus Pro 9600 Photographic Dye Ink Manual de usuario

Epson

Epson SureColor T3000 Manual de uso y mantenimiento

Epson

Epson SC-R5000 Series Manual de usuario

Epson

Epson SC-P800 Series Manual de instrucciones

Epson

Epson Stylus C87 Manual de usuario

Epson

Epson STYLUS S20 Series Manual de instrucciones

Epson

Epson PictureMate Snap PM 240 Manual de usuario

Epson

Epson SureColor P400 Manual de usuario

Epson

Epson Artisan 700 Series Manual de usuario

Epson

Epson Stylus Pro 9500 Engine Guía del usuario

Epson

Epson Stylus Color 980 Manual de usuario

Manuales populares de Impresora de otras marcas

Lexmark

Lexmark 1400 Series Manual

Canon

Canon i70 Series Manual de usuario

Evolis

Evolis Elypso Manual de usuario

Kyocera

Kyocera FS-9530DN Manual de usuario

Canon

Canon LASER SHOT LBP-1210 Manual de usuario

Samsung

Samsung BIXOLON SRP-350plusF Manual de usuario

Canon

Canon PIXMA PRO-1 Series Manual de usuario

Canon

Canon PIXMA G3560 Guía de configuración

Dell

Dell Color Laser Printer 2130cn Manual de usuario

Tektronix

Tektronix Phaser 840 Manual de usuario

Canon

Canon CLBR 460ps Manual de usuario

Eltron

Eltron P210 Guide Manual de usuario

Ricoh

Ricoh MD-P1 Manual de usuario

Canon

Canon imagePASS-A2 Manual de usuario

Canon

Canon S820D Manual de usuario

IRA3D

IRA3D POETRY4 Manual de usuario

Ricoh

Ricoh Aficio AP400 Manual de usuario

BIXOLON

BIXOLON SRP-352plusV Manual de usuario